- 您現在的位置：買賣IC網 > Datasheet目錄61 > GP1S560J000F (Sharp Microelectronics)SENSOR OPTO SLOT 2MM TRANS THRU Datasheet資料下載
參數資料
| 型號： | GP1S560J000F |
| 廠商： | Sharp Microelectronics |
| 文件頁數： | 5/5頁 |
| 文件大小： | 66K |
| 描述： | SENSOR OPTO SLOT 2MM TRANS THRU |
| 產品變化通告： | Internal Chip Change 04/May/2007 Product Discontinuation 04/Jan/2012 |
| 標準包裝： | 200 |
| 檢測距離： | 0.079"（2mm） |
| 檢測方法： | 可傳導的 |
| 輸出配置： | 光電晶體管 |
| 電流 - DC 正向(If)： | 50mA |
| 電流 - 集電極 (Ic)（最大）： | 20mA |
| 電壓 - 集電極發射極擊穿（最大）： | 35V |
| 響應時間： | 38µs，48µs |
| 安裝類型： | 通孔 |
| 封裝/外殼： | PCB 安裝 |
| 包裝： | 管件 |
| 類型： | 無放大 |
| 工作溫度： | -25°C ~ 85°C |
| 產品目錄頁面： | 2776 (CN2011-ZH PDF) |
| 其它名稱： | 425-1973-5 |
115
Application Circuits
NOTICE
qThe circuit application examples in this publication are provided to explain representative applications of
SHARP devices and are not intended to guarantee any circuit design or license any intellectual property
rights. SHARP takes no responsibility for any problems related to any intellectual property right of a
third party resulting from the use of SHARP's devices.
qContact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
SHARP reserves the right to make changes in the specifications, characteristics, data, materials,
structure, and other contents described herein at any time without notice in order to improve design or
reliability. Manufacturing locations are also subject to change without notice.
qObserve the following points when using any devices in this publication. SHARP takes no responsibility
for damage caused by improper use of the devices which does not meet the conditions and absolute
maximum ratings to be used specified in the relevant specification sheet nor meet the following
conditions:
(i) The devices in this publication are designed for use in general electronic equipment designs such as:
--- Personal computers
--- Office automation equipment
--- Telecommunication equipment [terminal]
--- Test and measurement equipment
--- Industrial control
--- Audio visual equipment
--- Consumer electronics
(ii)Measures such as fail-safe function and redundant design should be taken to ensure reliability and
safety when SHARP devices are used for or in connection with equipment that requires higher
reliability such as:
--- Transportation control and safety equipment (i.e., aircraft, trains, automobiles, etc.)
--- Traffic signals
--- Gas leakage sensor breakers
--- Alarm equipment
--- Various safety devices, etc.
(iii)SHARP devices shall not be used for or in connection with equipment that requires an extremely
high level of reliability and safety such as:
--- Space applications
--- Telecommunication equipment [trunk lines]
--- Nuclear power control equipment
--- Medical and other life support equipment (e.g., scuba).
qContact a SHARP representative in advance when intending to use SHARP devices for any "specific"
applications other than those recommended by SHARP or when it is unclear which category mentioned
above controls the intended use.
qIf the SHARP devices listed in this publication fall within the scope of strategic products described in the
Foreign Exchange and Foreign Trade Control Law of Japan, it is necessary to obtain approval to export
such SHARP devices.
qThis publication is the proprietary product of SHARP and is copyrighted, with all rights reserved. Under
the copyright laws, no part of this publication may be reproduced or transmitted in any form or by any
means, electronic or mechanical, for any purpose, in whole or in part, without the express written
permission of SHARP. Express written permission is also required before any use of this publication
may be made by a third party.
qContact and consult with a SHARP representative if there are any questions about the contents of this
publication.
相關PDF資料 |
PDF描述 |
|---|---|
| GP1S56TJ000F | SENSOR OPTO SLOT 2MM TRANS THRU |
| GP1S58VJ000F | SENSOR OPTO SLOT 5MM TRANS THRU |
| GP1S59J0000F | SENSR OPTO SLOT 4.2MM TRANS THRU |
| GP1S74PJ000F | SENSOR OPTO SLOT 5MM TRANS CONN |
| HMC1001-RC | SENSOR LINEAR MAGN 1 AXIS 8-SIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GP1S561 | 功能描述:PHOTOINTERRUPTER SLOT 3.0MM PCB RoHS:否 類別:傳感器，轉換器 >> 光學 - 光斷續器 - 槽型 - 晶體管輸出 系列:- 產品變化通告:Internal Chip Change 04/May/2007 標準包裝:100 系列:- 檢測距離:0.063"（1.6mm） 檢測方法:可傳導的 輸出配置:光電晶體管 電流 - DC 正向(If):50mA 電流 - 集電極 (Ic)（最大）:20mA 電壓 - 集電極發射極擊穿（最大）:35V 響應時間:35µs，35µs 安裝類型:通孔 封裝/外殼:PCB 安裝 包裝:管件 類型:無放大 工作溫度:-25°C ~ 85°C 其它名稱:425-1978-5 |
| GP1S562 | 功能描述:PHOTOINTERRUPTER SLOT 3.0MM PCB RoHS:否 類別:傳感器，轉換器 >> 光學 - 光斷續器 - 槽型 - 晶體管輸出 系列:- 產品變化通告:Internal Chip Change 04/May/2007 標準包裝:100 系列:- 檢測距離:0.063"（1.6mm） 檢測方法:可傳導的 輸出配置:光電晶體管 電流 - DC 正向(If):50mA 電流 - 集電極 (Ic)（最大）:20mA 電壓 - 集電極發射極擊穿（最大）:35V 響應時間:35µs，35µs 安裝類型:通孔 封裝/外殼:PCB 安裝 包裝:管件 類型:無放大 工作溫度:-25°C ~ 85°C 其它名稱:425-1978-5 |
| GP1S563 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Photointerrupter |
| GP1S563VJ00F | 制造商:Sharp Microelectronics Corporation 功能描述: |
| GP1S566 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Photointerrupter |
發布緊急采購，3分鐘左右您將得到回復。