- 您現在的位置：買賣IC網 > PDF目錄385403 > HT82A832R (Holtek Semiconductor Inc.) Basic USB Phone OTP MCU PDF資料下載
參數資料
| 型號： | HT82A832R |
| 廠商： | Holtek Semiconductor Inc. |
| 英文描述： | Basic USB Phone OTP MCU |
| 中文描述： | 檢察官辦公室的基本USB電話單片機 |
| 文件頁數： | 18/51頁 |
| 文件大小： | 345K |
| 代理商： | HT82A832R |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
HT82A832R
Rev. 1.00
18
July 18, 2006
options). Each bit of these input/output latches can be
set or cleared by SET [m].i and CLR [m].i (m=12H,
14H, 16H ) instructions.
Some instructions first input data and then follow the
output operations. For example,
SET [m].i ,
CLR
[m].i
into the CPU, execute the defined operations
(bit-operation), and then write the results back to the
latches or the accumulator.
CPL [m] , CPLA [m] read the entire port states
Each line of port A has the capability of waking-up the
device.
LowVoltageReset
LVR(byConfigurationOption)
The LVR option is 3.0V.
The microcontroller provides a low voltage reset circuit
inordertomonitorthesupplyvoltageofthedevice.Ifthe
supply voltage of the device is within the range
0.9V~V
LVR
, the LVR will automatically reset the device
internally.
The LVR includes the following specifications:
The low voltage (0.9V~V
LVR
) condition has to remain
in its condition for a time exceeding 1ms. If the low
voltage state does not exceed 1ms, the LVR will ig-
nore it and will not perform a reset function.
The LVR uses the OR function with the external
RESET signal to perform a chip reset.
Suspend Wake-Up and Remote Wake-Up
If there is no signal on the USB bus for over 3ms, the
HT82A832R will go into a suspend mode. The Suspend
line (bit 0 of the USC) will be set to 1 and a USB
interrupt is triggered to indicate that the HT82A832R
should jump to the suspend state to meet the
requirements of the USBsuspend current spec.
In order to meet the requirements of the suspend
current, the firmware should disable the USB clock by
clearing USBCKEN (bit3 of UCC) to 0 .
Also the user can further decrease the suspend current
by setting SUSP2 (bit4 of the UCC).
When the resume signal is sent out by the host, the
HT82A832R will be woken up by the USB interrupt and
the Resume line (bit 3 of USC) will be set. In order to
make the HT82A832R work properly, the firmware must
set USBCKEN (bit 3 of UCC) to 1 and clear SUSP2
(bit4 of the UCC). Since the Resume signal will be
cleared before the Idle signal is sent out by the host and
the Suspend line (bit 0 of USC) will go to 0 . So when
the MCU is detecting the Suspend line (bit0 of USC), the
condition of the Resume line should be noted and taken
into consideration.
The following is the timing diagram:
The device with remote wake up function can wake-up
the USB Host by sending a wake-up pulse through
RMWK (bit 1 of USC). Once the USBHost receives the
wake-up signal from the HT82A832R, it will send a
Resume signal to the device. The timing is as follows:
USB Interface
The HT82A832R device has 5 Endpoints (EP0~EP4).
EP0 supports Control transfer. EP1 and EP4 support
Interrupt transfer. EP2 supports Isochronous out
transfer. EP3 supports Isochronous in transfer.
These registers, including USC (20H), USR (21H), UCC
(22H), AWR (23H), STALL (24H), SIES (25H), MISC
(26H), FIFO0 (28H), FIFO1 (29H), FIFO2 (2AH), FIFO3
(2BH), FIFO4 (2CH) are used for the USB function.
The FIFO size of each FIFO is 8 bytes (FIFO0), 8 bytes
(FIFO1), 384 bytes (FIFO2), 32 bytes (FIFO3), 32 bytes
(FIFO4). The total is 464 bytes.
URD (bit7 of USC) is the USB reset signal control
function definition bit.
'
, %
%
&
, <
'
, %
%
&
, <
- % 1 -
- %
, %
!
相關PDF資料 |
PDF描述 |
|---|---|
| HT82A850R | Audio MCU |
| HT82A851R | USB Audio MCU |
| HT82J30A | 16 Channel A/D MCU with SPI Interface |
| HT82J30R | 16 Channel A/D MCU with SPI Interface |
| HT82J927A | USB Gamepad |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT82A832R_07 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Audio MCU |
| HT82A834R | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Audio MCU |
| HT82A836R | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Audio MCU |
| HT82A850R | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Audio MCU |
| HT82A851R | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Audio MCU |
發布緊急采購，3分鐘左右您將得到回復。