欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: HT82K94E_07
廠商: Holtek Semiconductor Inc.
英文描述: USB Multimedia Keyboard Encoder 8-Bit MCU
中文描述: 的USB多媒體鍵盤編碼器8位微控制器
文件頁數: 10/43頁
文件大小: 293K
代理商: HT82K94E_07
HT82K94E/HT82K94A
Rev. 1.50
10
October 11, 2007
the interrupt request flag is recorded. If a certain inter-
rupt requires servicing within the service routine, the
EMI bit and the corresponding bit of the INTC may be set
to allow interrupt nesting. If the stack is full, the interrupt
request will not be acknowledged, even if the related in-
terruptisenabled,untiltheSPisdecremented.Ifimmedi-
ate service is desired, the stack must be prevented from
becoming full.
All these kinds of interrupts have a wake-up capability.
As an interrupt is serviced, a control transfer occurs by
pushing the program counter onto the stack, followed by
a branch to a subroutine at specified location in the pro-
gram memory. Only the program counter is pushed onto
the stack. If the contents of the register or status register
(STATUS) are altered by the interrupt service program
which corrupts the desired control sequence, the con-
tents should be saved in advance.
USB interrupts are triggered by the following USB
events and the related interrupt request flag (USBF; bit
4 of the INTC) will be set.
The corresponding USB FIFO is accessed from the
PC
The USB suspends signal from the PC
The USB resumes signal from the PC
The USB sends Reset signal
When the interrupt is enabled, the stack is not full and
the USB interrupt is active, a subroutine call to location
04H will occur. The interrupt request flag (USBF) and
EMI bits will be cleared to disable other interrupts.
When the PC Host access the FIFO of the HT82K94E/
HT82K94A, the corresponding request bit of the USR is
set, and a USB interrupt is triggered. So user can easily
decide which FIFO is accessed. When the interrupt has
been served, the corresponding bit should be cleared by
firmware. When the HT82K94E/HT82K94A receives a
USB Suspend signal from the Host PC, the suspend line
(bit0 of the USC) of the HT82K94E/HT82K94A is set
and a USB interrupt is also triggered.
Also when the HT82K94E/HT82K94A receives a Re-
sume signal from the Host PC, the resume line (bit3 of
the USC) of HT82K94E/HT82K94A is set and a USB in-
terrupt is triggered.
Whenever a USB reset signal is detected, the USB in-
terrupt is triggered.
The internal Timer/Event Counter 0 interrupt is initial-
ized by setting the Timer/Event Counter 0 interrupt re-
quest flag (; bit 5 of INTC), caused by a timer 0 overflow.
When the interrupt is enabled, the stack is not full and
the T0F bit is set, a subroutine call to location 08H will
occur. The related interrupt request flag (T0F) will be re-
setandtheEMIbitclearedtodisablefurtherinterrupts.
The internal Timer/Even Counter 1 interrupt is initialized
by setting the Timer/Event Counter 1 interrupt request
flag (;bit 6 of INTC), caused by a timer 1 overflow. When
the interrupt is enabled, the stack is not full and the T1F
is set, a subroutine call to location 0CH will occur. The
related interrupt request flag (T1F) will be reset and the
EMI bit cleared to disable further interrupts.
During the execution of an interrupt subroutine, other in-
terrupt acknowledge signals are held until the RETI in-
struction is executed or the EMI bit and the related
interrupt control bit are set to 1 (if the stack is not full).
To return from the interrupt subroutine, RET or RETI
may be invoked. RETI will set the EMI bit to enable an in-
terrupt service, but RET will not.
Bit No.
Label
Function
0
EMI
Controls the master (global) interrupt (1= enabled; 0= disabled)
1
EUI
Controls the USB interrupt (1= enabled; 0= disabled)
2
ET0I
Controls the Timer/Event Counter 0 interrupt (1= enabled; 0= disabled)
3
ET1I
Controls the Timer/Event Counter 1 interrupt (1= enabled; 0= disabled)
4
USBF
USB interrupt request flag (1= active; 0= inactive)
5
T0F
Internal Timer/Event Counter 0 request flag (1= active; 0= inactive)
6
T1F
Internal Timer/Event Counter 1 request flag (1= active; 0= inactive)
7
Unused bit, read as 0
INTC (0BH) Register
相關PDF資料
PDF描述
HT82K95AE USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95EE USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95A USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95E USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K96A USB Multimedia Keyboard Encoder 8-Bit Mask MCU
相關代理商/技術參數
參數描述
HT82K95A 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95AE 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95E 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K95EE 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Multimedia Keyboard Encoder 8-Bit MCU
HT82K96A 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:USB Multimedia Keyboard Encoder 8-Bit Mask MCU
主站蜘蛛池模板: 通州市| 交城县| 浦县| 平阳县| 齐齐哈尔市| 泾阳县| 西城区| 锦州市| 彰化县| 赫章县| 潜山县| 股票| 和平县| 柳林县| 新邵县| 疏勒县| 黄冈市| 中宁县| 即墨市| 额敏县| 新巴尔虎右旗| 义乌市| 鄂州市| 延长县| 洛浦县| 区。| 司法| 体育| 吴忠市| 延长县| 丰都县| 衡阳县| 高州市| 秭归县| 井研县| 无为县| 灵寿县| 临澧县| 凉山| 蒙山县| 临西县|