- 您現在的位置：買賣IC網 > PDF目錄17645 > ISL23345TFVZ (Intersil)IC DGTL POT 256POS 100K 20TSSOP PDF資料下載
參數資料
| 型號： | ISL23345TFVZ |
| 廠商： | Intersil |
| 文件頁數： | 1/19頁 |
| 文件大小： | 0K |
| 描述： | IC DGTL POT 256POS 100K 20TSSOP |
| 標準包裝： | 740 |
| 系列： | XDCP™ |
| 接片： | 256 |
| 電阻（歐姆）： | 100k |
| 電路數： | 4 |
| 溫度系數： | 標準值 45 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 1.2 V ~ 5.5 V，1.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | * |
| 封裝/外殼： | * |
| 供應商設備封裝： | * |
| 包裝： | * |
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
|Copyright Intersil Americas Inc. 2011. All Rights Reserved
Intersil (and design) and XDCP are trademarks owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners
Quad, 256 Tap, Low Voltage Digitally Controlled
Potentiometer (XDCP)
ISL23345
The ISL23345 is a volatile, low voltage, low noise, low power,
256 tap, quad digitally controlled potentiometer (DCP) with an
I2C Bus interface. It integrates four DCP cores, wiper switches
and control logic on a monolithic CMOS integrated circuit.
Each digitally controlled potentiometer is implemented with a
combination of resistor elements and CMOS switches. The
position of the wipers are controlled by the user through the
I2C bus interface. Each potentiometer has an associated
volatile Wiper Register (WRi, i = 0, 1, 2, 3) that can be directly
written to and read by the user. The contents of the WRi
controls the position of the wiper. When powered on, the wiper
of each DCP will always commence at mid-scale (128 tap
position).
The low voltage, low power consumption, and small package
of the ISL23345 make it an ideal choice for use in battery
operated equipment. In addition, the ISL23345 has a VLOGIC
pin allowing down to 1.2V bus operation, independent from the
VCC value. This allows for low logic levels to be connected
directly to the ISL23345 without passing through a voltage
level shifter.
The DCP can be used as a three-terminal potentiometer or as a
two-terminal variable resistor in a wide variety of applications
including control, parameter adjustments, and signal processing.
Power supply margining
Trimming sensor circuits
Gain adjustment in battery powered instruments
RF power amplifier bias compensation
Features
Four potentiometers per package
256 resistor taps
10k
Ω, 50kΩ or 100kΩ total resistance
I2C serial interface
- No additional level translator for low bus supply
- Three address pins allow up to eight devices per bus
Maximum supply current without serial bus activity
(standby)
- 5A @ VCC and VLOGIC = 5V
- 2A @ VCC and VLOGIC = 1.7V
Shutdown Mode
- Forces the DCP into an end-to-end open circuit and RWi is
connected to RLi internally
- Reduces power consumption by disconnecting the DCP
resistor from the circuit
Power supply
-VCC = 1.7V to 5.5V analog power supply
-VLOGIC = 1.2V to 5.5V I2C bus/logic power supply
Wiper resistance: 70
Ω typical @ VCC = 3.3V
Power-on preset to mid-scale (128 tap position)
Extended industrial temperature range: -40°C to +125°C
20 Ld TSSOP or 20 QFN packages
Pb-free (RoHS compliant)
FIGURE 1. FORWARD AND BACKWARD RESISTANCE vs TAP
POSITION, 10k DCP
FIGURE 2. VREF ADJUSTMENT
0
2000
4000
6000
8000
10000
0
64
128
192
256
TAP POSITION (DECIMAL)
RESISTANCE
(
)
VREF_M
ISL28114
1 DCP
of
ISL23345
+
-
VREF
RL1
RW1
RH1
June 21, 2011
FN7872.0
相關PDF資料 |
PDF描述 |
|---|---|
| B32671L0103J000 | CAP FILM 10000PF 1KVDC RADIAL |
| B32652A1332J | CAP FILM 3300PF 1.6KVDC RADIAL |
| SDMP0340LAT-7 | DIODE SCHTKY CA 40V 150MW SOT523 |
| B32021A3102M | CAP FILM 1000PF 1.5KVDC RADIAL |
| ISL28118FUZ | IC OPAMP PREC R-R 4MHZ LP 8MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL23345TFVZ-T7A | 功能描述:數字電位計 IC 256 TAPVOLATILE I2C QUAD FL RNG IND 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23345TFVZ-TK | 功能描述:數字電位計 IC 256 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23345UFRZ | 功能描述:數字電位計 IC 256 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23345UFRZ-T7A | 功能描述:數字電位計 IC 256 TAPVOLATILE I2C QUAD FL RNG IND 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL23345UFRZ-TK | 功能描述:數字電位計 IC 256 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。