- 您現在的位置：買賣IC網 > PDF目錄383157 > ISL6561IR (INTERSIL CORP) Multi-Phase PWM Controller with Precision Rds(on) or DCR Differential Current Sensing for VR10.X Application PDF資料下載
參數資料
| 型號： | ISL6561IR |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Multi-Phase PWM Controller with Precision Rds(on) or DCR Differential Current Sensing for VR10.X Application |
| 中文描述： | SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PQCC40 |
| 封裝： | 6 X 6 MM, PLASTIC, MO-220VJJD-2, MLFP, QFN-40 |
| 文件頁數： | 1/26頁 |
| 文件大小： | 782K |
| 代理商： | ISL6561IR |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
1
FN9098.5
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143
Intersil (and design) is a registered trademark of Intersil Americas Inc.
Dynamic VID is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2002-2005. All Rights Reserved.
All other trademarks mentioned are the property of their respective owners.
ISL6561
Multi-Phase PWM Controller with
Precision r
DS(ON)
or DCR Differential
Current Sensing for VR10.X Application
The ISL6561 controls microprocessor core voltage regulation
by driving up to 4 synchronous-rectified buck channels in
parallel. Multi-phase buck converter architecture uses
interleaved timing to multiply channel ripple frequency and
reduce input and output ripple currents. Lower ripple results in
fewer components, lower component cost, reduced power
dissipation, and smaller implementation area.
Microprocessor loads can generate load transients with
extremely fast edge rates. The ISL6561 features a high
bandwidth control loop and ripple frequencies of >4MHz to
provide optimal response to the transients.
Today’s microprocessors require a tightly regulated output
voltage position versus load current (droop). The ISL6561
senses current by utilizing patented techniques to measure
the voltage across the on resistance, r
DS(ON)
, of the lower
MOSFETs or DCR of the output inductor during the lower
MOSFET conduction intervals. Current sensing provides the
needed signals for precision droop, channel-current
balancing, and overcurrent protection.
The accuracy of the current-sensing method is enhanced by
the ISL6561’s temperature compensation function. Droop
accuracy can be affected by increasing r
DS(ON)
or DCR with
elevated temperature. The ISL6561 uses an internal
temperature-sensing element to provide programmable
temperature compensation. Correctly applied, temperature
compensation can completely nullify the effect of r
DS(ON) or
DCR temperature sensitivity.
A unity gain, differential amplifier is provided for remote
voltage sensing. Any potential difference between remote
and local grounds can be completely eliminated using the
remote-sense amplifier. Eliminating ground differences
improves regulation and protection accuracy. The threshold-
sensitive enable input is available to accurately coordinate
the start up of the ISL6561 with any other voltage rail.
Dynamic-VID technology allows seamless on-the-fly VID
changes. The offset pin allows accurate voltage offset
settings that are independent of VID setting. The ISL6561
uses 5V bias and has a built-in shunt regulator to allow 12V
bias using only a small external limiting resistor.
Features
Precision Multi-Phase Core Voltage Regulation
- Differential Remote Voltage Sensing
-
±
0.5% System Accuracy Over Life, Load, Line and
Temperature
- Adjustable Reference-Voltage Offset
Precision r
DS(ON)
or DCR Current Sensing
- Integrated Programmable Temperature Compensation
- Accurate Load-Line Programming
- Accurate Channel-Current Balancing
- Differential Current Sense
- Low-Cost, Lossless Current Sensing
Internal Shunt Regulator for 5V or 12V Biasing
Microprocessor Voltage Identification Input
- Dynamic VID technology
- 6-Bit VID Input
- 0.8375V to 1.600V in 12.5mV Steps
Threshold-Sensitive Enable Function for synchronizing
with driver POR
Overcurrent Protection
Overvoltage Protection
- No Additional External Components Needed
- OVP Pin to drive opitional Crowbar Device
2, 3, or 4 Phase Operation
Greater Than 1MHz Operation (> 4MHz Ripple)
Pb-free Available
(RoHS Compliant)
QFN Package Option
- QFN Compliant to JEDEC PUB95 MO-220 QFN - Quad
Flat No Leads - Product Outline
- QFN Near Chip Scale Package Footprint; Improves
PCB Efficiency, Thinner in Profile
Data Sheet
May 12, 2005
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6561IRZ | Multi-Phase PWM Controller with Precision Rds(on) or DCR Differential Current Sensing for VR10.X Application |
| ISL6561IR-T | Multi-Phase PWM Controller with Precision Rds(on) or DCR Differential Current Sensing for VR10.X Application |
| ISL6561CRZA-T | Multi-Phase PWM Controller with Precision Rds(on) or DCR Differential Current Sensing for VR10.X Application |
| ISL6562 | Microprocessor CORE Voltage Regulator Two-Phase Buck PWM Controller |
| ISL6562CB | Microprocessor CORE Voltage Regulator Two-Phase Buck PWM Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6561IRZ | 功能描述:IC CTRLR PWM MULTIPHASE 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| ISL6561IRZ-T | 功能描述:IC CTRLR PWM MULTIPHASE 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| ISL6562 WAF | 制造商:Intersil Corporation 功能描述: |
| ISL6562CB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| ISL6562CB-T | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。