欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ISP1122BD
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: Universal Serial Bus stand-alone hub
中文描述: UNIVERSAL SERIAL BUS CONTROLLER, PQFP32
封裝: 7 X 7 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-358-1, LQFP-32
文件頁數: 9/48頁
文件大?。?/td> 1159K
代理商: ISP1122BD
Philips Semiconductors
ISP1122
USB stand-alone hub
Product specification
Rev. 03 — 29 March 2000
9 of 48
9397 750 07002
Philips Electronics N.V. 2000. All rights reserved.
6.2 Philips Serial Interface Engine (SIE)
The Philips SIE implements the full USB protocol layer. It is completely hardwired for
speed and needs no firmware intervention. The functions of this block include:
synchronization pattern recognition, parallel/serial conversion, bit (de-)stuffing, CRC
checking/generation, Packet IDentifier (PID) verification/generation, address
recognition, handshake evaluation/generation.
6.3 Hub repeater
The hub repeater is responsible for managing connectivity on a ‘per packet’ basis. It
implements ‘packet signalling’ and ‘resume’ connectivity. Low-speed devices can be
connected to downstream ports. If a low-speed device is detected the repeater will
not propagate upstream packets to the corresponding port, unless they are preceded
by a PREAMBLE PID.
6.4 End-of-frame timers
This block contains the specified EOF1 and EOF2 timers which are used to detect
‘loss-of-activity’ and ‘babble’ error conditions in the hub repeater. The timers also
maintain the low-speed keep-alive strobe which is sent at the beginning of a frame.
6.5 General and individual port controller
The general and individual port controllers together provide status and control of
individual downstream ports. Any port status change will be reported to the host via
the hub status change (interrupt) endpoint.
6.6 GoodLink
Indication of a good USB connection is provided through GoodLink technology. An
LED can be directly connected via an external 330
resistor.
During enumeration the LED blinks on momentarily. After successful configuration of
the ISP1122, the LED is permanently on. The LED blinks off for 100 ms upon each
successful packet transfer (with ACK). The hub GoodLink indicator blinks when the
hub receives a packet addressed to it. Downstream GoodLink indicators blink upon
an acknowledgment from the associated port. In ‘suspend’ mode the LED is off.
This feature provides a user-friendly indication of the status of the hub, the connected
downstream devices and the USB traffic. It is a useful diagnostics tool to isolate faulty
USB equipment and helps to reduce field support and hotline costs.
6.7 Bit clock recovery
The bit clock recovery circuit recovers the clock from the incoming USB data stream
using a 4
×
oversampling principle. It is able to track jitter and frequency drift as
specified by the USB Specification Rev. 1.1
6.8 Voltage regulator
A 5 to 3.3 V DC-DC regulator is integrated on-chip to supply the analog transceiver
and internal logic. This can also be used to supply the terminal 1.5 k
pull-up resistor
on the D
+
line of the upstream connection.
相關PDF資料
PDF描述
ISP1122D Universal Serial Bus stand-alone hub
ISP1122NB Universal Serial Bus stand-alone hub
ISP1123BD CAP .068UF 100V PPS FILM ECH-S
ISP1123 Universal Serial Bus compound hub
ISP1123D Universal Serial Bus compound hub
相關代理商/技術參數
參數描述
ISP1122D 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus stand-alone hub
ISP1122NB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus stand-alone hub
ISP1123 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1123BD 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1123D 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
主站蜘蛛池模板: 稻城县| 皮山县| 威海市| 万载县| 沁阳市| 芷江| 岢岚县| 临颍县| 扶风县| 民乐县| 宽甸| 新野县| 石楼县| 尉犁县| 上饶市| 哈巴河县| 南京市| 安龙县| 江源县| 鹤山市| 吉林省| 铜梁县| 昔阳县| 新昌县| 神农架林区| 集贤县| 镇江市| 遵义市| 漳浦县| 永新县| 冷水江市| 广西| 合山市| 潮安县| 怀化市| 招远市| 库伦旗| 牙克石市| 繁峙县| 阳春市| 商河县|