欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ISP1122NB
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: Universal Serial Bus stand-alone hub
中文描述: UNIVERSAL SERIAL BUS CONTROLLER, PDIP32
封裝: 0.400 INCH, SHRINK, PLASTIC, SOT-232-1, DIP-32
文件頁數: 8/48頁
文件大小: 1159K
代理商: ISP1122NB
Philips Semiconductors
ISP1122
USB stand-alone hub
Product specification
Rev. 03 — 29 March 2000
8 of 48
9397 750 07002
Philips Electronics N.V. 2000. All rights reserved.
[1]
[2]
Symbol names with an overscore (e.g. NAME) indicate active LOW signals.
The voltage at pin V
reg(3.3)
is gated by the RESET pin. This allows fully self-powered operation by
connecting RESET to V
BUS
(+5 V USB supply). If V
BUS
is lost upstream port D+ will not be driven.
See
Table 4 “Mode selection”
.
To disable a downstream port connect both D
+
and D
to V
CC
via a 1 M
resistor; unused ports must
be disabled in reverse order starting from port 5.
Analog detection circuit can be switched off using an external EEPROM, see
Table 23
; in this case,
the pin functions as a logic input (TTL level).
Downstream ports 1 and 2 cannot be disabled.
[3]
[4]
[5]
[6]
6.
Functional description
The ISP1122 is a stand-alone USB hub with up to 5 downstream ports. The number
of ports can be configured between 2 and 5. The downstream ports can be used to
connect low-speed or full-speed USB peripherals. All standard USB requests from
the host are handled by the hardware without the need for firmware intervention. The
block diagram is shown in
Figure 1
.
The ISP1122 requires only a single supply voltage. An internal 3.3 V regulator
provides the supply voltage for the analog USB data transceivers.
The ISP1122 supports both bus-powered and self-powered hub operation. When
using bus-powered operation a downstream port cannot supply more than 100 mA to
a peripheral. In case of self-powered operation an external supply is used to power
the downstream ports, allowing a current consumption of max. 500 mA per port.
A basic I
2
C-bus interface is provided for reading vendor ID, product ID and
configuration bits from an external EEPROM upon a reset.
6.1 Analog transceivers
The integrated transceiver interfaces directly to the USB cables through external
termination resistors. They are capable of transmitting and receiving serial data at
both ‘full-speed’ (12 Mbit/s) and ‘low-speed’ (1.5 Mbit/s) data rates. The slew rates
are adjusted according to the speed of the device connected and lie within the range
mentioned in the USB Specification Rev. 1.1
DM2
DP2
PSW1/GL1
[3]
26
27
28
AI/O
AI/O
O
downstream port 2 D
connection (analog)
[6]
downstream port 2 D
+
connection (analog)
[6]
modes 4 to 6
: power switch control output for downstream
port 1 (open-drain, 6 mA)
modes 0 to 3, 7
: GoodLink LED indicator output for
downstream port 1 (open-drain, 6 mA); to connect an LED
use a 330
series resistor
Table 3:
Symbol
[1]
Pin description for LQFP32
…continued
Pin
Type
Description
相關PDF資料
PDF描述
ISP1123BD CAP .068UF 100V PPS FILM ECH-S
ISP1123 Universal Serial Bus compound hub
ISP1123D Universal Serial Bus compound hub
ISP1123NB Universal Serial Bus compound hub
ISP1130 Universal Serial Bus compound hub with integrated keyboard controller
相關代理商/技術參數
參數描述
ISP1123 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1123BD 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1123D 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1123NB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub
ISP1130 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus compound hub with integrated keyboard controller
主站蜘蛛池模板: 神池县| 浠水县| 通道| 大名县| 乌苏市| 达孜县| 宜都市| 景谷| 卫辉市| 正蓝旗| 安阳市| 津市市| 米林县| 石楼县| 扬中市| 内丘县| 瓦房店市| 山西省| 寿阳县| 恭城| 泾阳县| 海南省| 霍邱县| 通化市| 巴南区| 黄大仙区| 宜阳县| 凤阳县| 子洲县| 德江县| 界首市| 台前县| 满洲里市| 独山县| 鄄城县| 凌云县| 阿坝| 安图县| 新昌县| 龙口市| 随州市|