- 您現在的位置：買賣IC網 > PDF目錄30712 > L48DB12001PSA DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | L48DB12001PSA |
| 元件分類： | 電源模塊 |
| 英文描述： | DC-DC REG PWR SUPPLY MODULE |
| 封裝： | QUARTER BRICK PACKAGE-7 |
| 文件頁數： | 12/13頁 |
| 文件大小： | 407K |
| 代理商： | L48DB12001PSA |
DS_ L48DB12001 _02102009
8
DESIGN CONSIDERATIONS
Input Source Impedance
The impedance of the input source connecting to the
DC/DC power modules will interact with the modules
and affect the stability. A low ac-impedance input source
is recommended. If the source inductance is more than
a few μH, we advise adding a 10 to 100 μF electrolytic
capacitor (ESR < 0.7 at 100 kHz) mounted close to
the input of the module to improve the stability.
Layout and EMC Considerations
Delta’s DC/DC power modules are designed to operate
in a wide variety of systems and applications. For design
assistance with EMC compliance and related PWB
layout issues, please contact Delta’s technical support
team. An external input filter module is available for
easier EMC compliance design. Application notes to
assist designers in addressing these issues are pending
release.
Safety Considerations
The power module must be installed in compliance with
the spacing and separation requirements of the
end-user’s safety agency standard, i.e., UL60950-1,
CAN/CSA-C22.2, No. 60950-1 and EN60950-1+A11 and
IEC60950-1, if the system in which the power module is
to be used must meet safety agency requirements.
When the input source is 60 Vdc or below, the power
module
meets
SELV
(safety
extra-low
voltage)
requirements. If the input source is a hazardous voltage
which is greater than 60 Vdc and less than or equal to 75
Vdc, for the module’s output to meet SELV requirements,
all of the following must be met:
The input source must be insulate from any
hazardous voltage, including the ac mains, with
reinforced insulation.
One Vi pin and one Vo pin are grounder, or all the
input and output pins are kept floating.
The input terminals of the module are not operator
accessible.
If the metal baseplate / heatspreader is grounded
the output must be also grounded.
A SELV reliability test is conducted on the system
where the module is used to ensure that under a
single fault, hazardous voltage does not appear at
the module’s output.
Do not ground one of the input pins without grounding
one of the output pins. This connection may allow a
non-SELV voltage to appear between the output pin and
ground.
The power module has extra-low voltage (ELV) outputs
when all inputs are ELV.
This power module is not internally fused. To achieve
optimum safety and system protection, an input line fuse
is highly recommended. The safety agencies require a
normal-blow fuse with 7A maximum rating to be installed
in the ungrounded lead. A lower rated fuse can be used
based on the maximum inrush transient energy and
maximum input current.
Soldering and Cleaning Considerations
Post solder cleaning is usually the final board assembly
process before the board or system undergoes electrical
testing. Inadequate cleaning and/or drying may lower the
reliability of a power module and severely affect the
finished circuit board assembly test. Adequate cleaning
and/or drying is especially important for un-encapsulated
and/or open frame type power modules. For assistance
on appropriate soldering and cleaning procedures,
please contact Delta’s technical support team.
相關PDF資料 |
PDF描述 |
|---|---|
| L4981BD | 2 A POWER FACTOR CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO20 |
| L4981B | 2 A POWER FACTOR CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDIP20 |
| L4981AD013TR | 2 A POWER FACTOR CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO20 |
| L5200-45-AH6-R | SWITCHED CAPACITOR REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO6 |
| L5200-50-AG6-R | SWITCHED CAPACITOR REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L4-8R2-10 | 制造商:SUPERWORLD 制造商全稱:Superworld Electronics 功能描述:FERRITE CHIP INDUCTORS |
| L4901 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:DUAL 5V REGULATOR WITH RESET |
| L4901A | 功能描述:線性穩壓器 - 標準 Dual 5V 0.4A w/Reset RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| L4901AH | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Positive Fixed Voltage Regulator |
| L4902A | 功能描述:線性穩壓器 - 標準 Dual 5V 0.3A w/Reset RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
發布緊急采購，3分鐘左右您將得到回復。