- 您現在的位置：買賣IC網 > PDF目錄30715 > LA1862M FM, AUDIO DEMODULATOR, PDSO36 PDF資料下載
參數資料
| 型號： | LA1862M |
| 元件分類： | 接收器 |
| 英文描述： | FM, AUDIO DEMODULATOR, PDSO36 |
| 封裝： | MFP-36 |
| 文件頁數： | 8/27頁 |
| 文件大?。?/td> | 810K |
| 代理商： | LA1862M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
MPX Block
1.
The variable resistor between pins 26 and 28 is for
adjusting separation.
2.
The ceramic oscillator must be a Murata F23. The use of
other oscillators leads to frequency discrepancies and
spurious oscillations.
3.
Pin 14 is the SNC control input. It uses the S-meter output
from pin 1 to automatically vary the stereo separation with
the input signal strength. It is also possible to reduce noise
resulting from weak stereo signals.
4.
Pin 13 is the HCC control input. It uses the S-meter
output from pin 1 to automatically vary the multiplexer
output high-frequency characteristic with the input signal
strength. The capacitor at pin 12 determines the maximum
attenuation for this band. Too big a capacitance, however,
will degrade music quality and make the audibility
unstable during reception.
5.
Pin 24 is the 19 kHz pilot signal input. Capacitively
couple the 19 kHz component from pin 11 to pin 24.
6.
Pin 25 is the stereo lamp signal. Current flows only for
stereo signals. Leaving the pin open forces monaural
operation.
7.
The VCO always operates during both stereo and monaural
operation.
8.
Pins 15 and 16 are the left- and right-channel outputs. The capacitors at these pins determine the amount of deemphasis —
50 μs using 0.015 μF, and 75 μs using 0.022 μF.
9.
Pin 18 is the pilot cancel signal output. Adjust the variable resistor between pins 17 and 18 to minimize the 19 kHz pilot
signal components in the left- and right-channel outputs for correct channel balance.
10. When adjusting the pilot cancel signal output, connect a 20 kHz lowpass filter (for example, a DIN audio filter) to the
multiplexer output to remove the 38 kHz component and prevent its affect on the process of minimizing the 19 kHz
component.
11. The capacitor connected to pin 34 is used to detect the pilot cancel signal. It should be connected to VCC or GND. In the
case of VCC, use a capacitor with no DC leakage.
Coil Specifications
Note: The dotted lines in the characteristics diagrams on the following pages represent device operation outside the device
specifications.
frequency
divider
(Toko)
For European markets
C = 100 pF internal
(Toko)
For North American and
Japanese markets
C = 51 pF Internal
For North American and
Japanese markets
C = 51 pF External
(Mitsumi)
For European markets
C = 100 pF External
LA1862M
No. 4092- 16/27
相關PDF資料 |
PDF描述 |
|---|---|
| LA1863M | 1-BAND, AUDIO TUNER, PQFP44 |
| LA1867NM | AM/FM, AUDIO DEMODULATOR, PQFP44 |
| LA1875M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO36 |
| LA1875M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO36 |
| LA1883M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA1867NM | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Car Radio Single-Chip Tuner System |
| LA1867NM-MPB-E | 制造商:ON Semiconductor 功能描述: |
| LA186B-9SEF9UG-3-PF | 制造商:LIGITEK 制造商全稱:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
| LA186B-9SEF-PF | 制造商:LIGITEK 制造商全稱:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
| LA186B-DBK-2-PF | 制造商:LIGITEK 制造商全稱:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
發布緊急采購，3分鐘左右您將得到回復。