- 您現在的位置：買賣IC網 > PDF目錄30716 > LA4160 2.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDIP14 PDF資料下載
參數資料
| 型號： | LA4160 |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 2.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDIP14 |
| 封裝： | HEAT SINK, DIP-14 |
| 文件頁數： | 10/11頁 |
| 文件大小： | 224K |
| 代理商： | LA4160 |
LA4160
No.870-8/11
b) Power Amplifier
For the oscillation preventing capacitor connected across output pin (1) and ground, it is recommended to use a
polyester film capacitor which is excellent in temperature characteristic and frequency characteristic. It should be
noted, however, that if such a polyester film capacitor as to have a resonance point at a high frequency is used
oscillation may not be prevented.
3. Shock Noise
The shock noise which occurs from the power amplifier at the time of power supply ON/OFF is reduced by means of
the prevention circuit. However, when the starting time of the power amplifier is set earlier than that of the
preamplifier or the power supply is turned ON immediately after turning OFF, it may happen that the shock noise of
the preamplifier cannot be masked. In this case, a germanium diode is connected across pins (7) and (9), and pins (7)
and (12) respectively to make the starting time as early as possible. Even if no germanium diode is connected across
pins (7) and (12), the starting time can be made earlier, but the starting time can be made much earlier by using 2pcs.
of germanium diode.
OUT
IN
[How to make the starting time of the
preamplifier earlier]
Preamp.
Rf
1S188 (Germanium diode)
9
7
12
4. Power Supply for Radio’s Built-in Capacitor Microphone
Pin (13) is for the low ripple power supply. This pin cannot be used as the power supply for a block, such as radio,
which requires a large amount of current. The reason for this is that if this pin is used for this purpose, the middle
point of the power amplifier shifts, thereby causing the drop in output. However, this pin can be safely used as the
power supply for a built-in capacitor microphne.
5. Recording Muting
The recording muting at the time of recording by use of the built-in microphone is enabled by applying 1 to 5V DC
voltage to feedback pin (3) of the power amplifier. (Power amplifier : Cutoff)
6. In case of using in a radio-cassette recorder, the IC and the bar antenna must be arranged sufficiently distant from each
other to avoid the radiation of higher harmonic component at the time of output saturation of the power amplifier.
7. Pin-to-pin short causes breakdown and deterioration.
8. Load short causes breakdown and deterioration of both preamplifier and power amplifier.
2
3
5
0.1
2
3
5
1.0
10
VO -- Vi
Input Voltage, Vi -- mV
Output
V
oltage,
V
O
--
V
5
0.1
23
5
1.0
23
Preamplifier
2
3
5
10
23
5
f =
100Hz
10kHz
1kHz
clip
VCC = 6V
RL = 10kΩ
VG = 40dB/1kHz
Playback
THD -- VO
Output Voltage, VO -- V
T
o
tal
Harmonic
Distortion,
THD
-
-%
23
5
7
1.0
23
5
35
7
0.1
Preamplifier
2
3
5
0.1
2
3
5
1.0
2
3
5
10
2
3
5
100
1kHz
10kHz
f =
100Hz
VCC = 6V
RL = 10kΩ
VG = 40dB/1kHz
Playback
相關PDF資料 |
PDF描述 |
|---|---|
| LA4165M | SPECIALTY CONSUMER CIRCUIT, PDSO24 |
| LA4166M | SPECIALTY CONSUMER CIRCUIT, PDSO24 |
| LA4167M | SPECIALTY CONSUMER CIRCUIT, PDSO30 |
| LA4168M | SPECIALTY CONSUMER CIRCUIT, PDSO30 |
| LA4182 | 2.3 W, 2 CHANNEL, AUDIO AMPLIFIER, PDIP12 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA4162 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:SINGLE-CHIP AF AMPLIFIER |
| LA4165M | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Recording/Playback IC for Micro-Cassette Tape Recorder |
| LA4166M | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Recording and Playback System for Microcassette Players |
| LA4167M | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:1-Channel Record/Playback System for Microcassette and Cassette Recorders |
| LA4168 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Record/Playback System for Microcassette and Compact Cassette Recorders(148.50 k) |
發布緊急采購，3分鐘左右您將得到回復。