欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: LC72720
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PDIP24
封裝: SDIP-24
文件頁數: 5/14頁
文件大小: 234K
代理商: LC72720
Parameter
Symbol
Conditions
Ratings
Unit
min
typ
max
Data setup time
tSU
DI, CL
0.75
s
Data hold time
tHD
DI, CL
0.75
s
Clock low-level time
tCL
CL
0.75
s
Clock high-level time
tCH
CL
0.75
s
CE wait time
tEL
CE, CL
0.75
s
CE setup time
tES
CE, CL
0.75
s
CE hold time
tEH
CE, CL
0.75
s
CE high-level time
tCE
CE
20
ms
Data latch transition time
tLC
1.15
s
Data output time
tDC
DO, CL
0.46
s
tDH
DO, CE
0.46
s
No. 5602-13/14
LC72720, 72720M
Differs with the value of
the pull-up resistor used.
DO pin operation
This LSI incorporates a RAM data buffer that can hold up to 24 blocks of data. At the point where one block of data is
written to this RAM, the LSI issues a read request by switching the DO pin from high to low.
The DO pin always goes high for a fixed period (Tdo = 265 s) after a readout and CE goes low. When all the data in the
data buffer has been read out, the DO pin is held in the high state until a new block of data has been written to the RAM. If
there is data that has not yet been read remaining in the data buffer, the DO pin goes low after the Tdo time has elapsed.
After a synchronization reset, the DO pin is held high until synchronization is established. It goes low at the point where
the LSI synchronizes.
1. When the DO pin is high following the 265 s period (Tdo) after data is read out
Here, the buffer is in the empty state, i.e. the state where new data has not been written. After this, when the DO pin
goes low, applications are guaranteed to be able to read out that data without it being overwritten by new data if they
start a readout operation within 480 ms of DO going low.
2. When DO goes low 265 s after data is read out
Here, there is data that has not been read out remaining in the data buffer. In this case, applications are guaranteed to
be able to read out that data without it being overwritten by new data if they start a readout operation within 20 ms of
DO going low. (Note that this is the worst case condition.)
Notes: 1. Although an application can determine whether or not there is data remaining in the buffer by checking the DO
level with the above timing, checking the RE and RF flags in the serial data is a preferable method.
2. Applications are not limited to reading out one block of data at a time, but rather can read out multiple blocks
of data continuously as described above. When using this method, if an application references the RE and RF
flags in the data while reading out data, it can determine the amount of data remaining. However, the length of
the period for data readout (the period the CE pin remains high) must be kept under 20 ms.
3. If the DO pin is shared with other LSIs that use the CCB interface, the application must identify which LSI
issued the readout request. One method is to read out data from the LC72720 and either check whether
meaningful data has been read (if the LC72720 is not requesting a read, data consisting of all zeros will be read
out) or check whether the DO level goes low within the 256 s following the completion of the read (if the DO
pin goes low, then the request was from another LSI).
CE pin
DO pin
CE pin
DO pin
(Last data) - 1
Last data
New data
(Last data) - 2
(Last data) - 1
Last data
DO check (Tdo < T)
相關PDF資料
PDF描述
LC72720M SPECIALTY CONSUMER CIRCUIT, PDSO24
LC72722M SPECIALTY CONSUMER CIRCUIT, PDSO24
LC72722 SPECIALTY CONSUMER CIRCUIT, PDIP24
LC72722M SPECIALTY CONSUMER CIRCUIT, PDSO24
LC72722PM SPECIALTY CONSUMER CIRCUIT, PDSO24
相關代理商/技術參數
參數描述
LC72720M 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip RDS Signal-Processing System LSI
LC72720N 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip RDS Signal-Processing System LSI
LC72720NM 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip RDS Signal-Processing System LSI
LC72720Y 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
LC72720YV 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
主站蜘蛛池模板: 安国市| 通许县| 嵊泗县| 杨浦区| 古交市| 乌拉特后旗| 讷河市| 安化县| 田阳县| 阿巴嘎旗| 婺源县| 蓝田县| 博爱县| 达拉特旗| 安岳县| 吕梁市| 南城县| 保山市| 张家川| 泗阳县| 秭归县| 建水县| 榆中县| 廊坊市| 乌拉特中旗| 攀枝花市| 宣化县| 苗栗县| 宣武区| 平谷区| 洛川县| 蒙自县| 岑巩县| 建始县| 五常市| 伊宁市| 安陆市| 黔南| 灵川县| 东丽区| 雅安市|