- 您現在的位置：買賣IC網 > PDF目錄30736 > LC75700T (SANYO SEMICONDUCTOR CO LTD) SPECIALTY CONSUMER CIRCUIT, PDSO20 PDF資料下載
參數資料
| 型號： | LC75700T |
| 廠商： | SANYO SEMICONDUCTOR CO LTD |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
| 封裝： | 0.225 INCH, TSSOP-20 |
| 文件頁數： | 2/16頁 |
| 文件大小： | 127K |
| 代理商： | LC75700T |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
Key Scan Operation Functions
1.Key scan timing
The key scan period is 288T (s). To reliably determine the on/off state of the keys, this LSI scans the keys twice and
determines that a key has been pressed when the key data agrees. It outputs a key data read request (a low level on DO)
615T (s) after starting a key scan. If the key data does not agree and a key was pressed at that point, it scans the keys
again. Thus this LSI cannot detect a key press shorter than 615T (s).
2.Key scan operation
The pins KS1 to KS6 are set to the high or low state by the control data.
If a key on one of the lines corresponding to a KS1 to KS6 pin which is set high is pressed, the oscillator on the OSC
pin is started and a key scan is performed. Keys are scanned until all keys are released. Multiple key presses are
recognized by determining whether multiple key data bits are set.
If a key is pressed for longer than 615T (s) (where T = 1/fosc) this LSI outputs a key data read request (a low level on
DO) to the controller. The controller acknowledges this request and reads the key data. However, if CE is high during a
serial data transfer, Do will be set high.
After the controller reads the key data, the key data read request is cleared (DO is set high) and this LSI performs
another key scan. Also note that DO being an open-drain output, requires a pull-up resistor (between 1 k
and 10 k) .
No. 7632-10/16
LC75700T
Key on
*2. Not that the high/low states of these pins are determined by the control data, and that key scan output signals are not output
from pins that are set to low .
576T[s]
*2
1
2
3
4
5
6
KS4
KS5
KS6
KS3
KS2
*2
KS1
T=
1
fosc
*2
Serial data transfer
Key data read request
Key data read
DO
DI
Key address (63H)
Key address
CE
Key scan
Key input 2
Key input 1
615T[s]
Key data read request
615T[s]
Serial data transfer
Key address
T=
1
fosc
相關PDF資料 |
PDF描述 |
|---|---|
| LC75700T | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
| LC78010E | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| LC78011E | COLOR SIGNAL ENCODER, PQFP48 |
| LC78602NE | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| LC78605E | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC75700T-MPB-E | 功能描述:接口 - 專用 KEY SCAN IC RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| LC75700TS-MPB-E | 功能描述:LCD 驅動器 RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| LC75700TS-TLM-E | 功能描述:LCD 驅動器 RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| LC75700T-TLM-E | 功能描述:接口 - 專用 KEY SCAN IC RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| LC7570E | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Static Drivers for Vacuum Fluorescent Display for Frequency Display Applications |
發布緊急采購，3分鐘左右您將得到回復。