- 您現在的位置：買賣IC網 > PDF目錄30743 > LM1875DWF (NATIONAL SEMICONDUCTOR CORP) 25 W, 1 CHANNEL, AUDIO AMPLIFIER, UUC PDF資料下載
參數資料
| 型號： | LM1875DWF |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 25 W, 1 CHANNEL, AUDIO AMPLIFIER, UUC |
| 封裝： | WAFER |
| 文件頁數： | 14/16頁 |
| 文件大小： | 537K |
| 代理商： | LM1875DWF |
Application Hints (Continued)
put stage and constant power dissipation in all other parts of
the circuit. The curves of “Power Dissipation vs Power Out-
put” give a better representation of the behavior of the
LM1875 with various power supply voltages and resistive
loads. As an example, if the LM1875 is operated on a 50V
power supply with a resistive load of 8
, it can develop up to
19W of internal power dissipation. If the die temperature is to
remain below 150C for ambient temperatures up to 70C,
the total junction-to-ambient thermal resistance must be less
than
Using
θ
JC=2C/W, the sum of the case-to-heat-sink interface
thermal resistance and the heat-sink-to-ambient thermal re-
sistance must be less than 2.2C/W. The case-to-heat-sink
thermal resistance of the TO-220 package varies with the
mounting method used. A metal-to-metal interface will be
about 1C/W if lubricated, and about 1.2C/W if dry.
If a mica insulator is used, the thermal resistance will be
about 1.6C/W lubricated and 3.4C/W dry. For this example,
we assume a lubricated mica insulator between the LM1875
and the heat sink. The heat sink thermal resistance must
then be less than
4.2C/W2C/W1.6C/W=0.6C/W.
This is a rather large heat sink and may not be practical in
some applications. If a smaller heat sink is required for rea-
sons of size or cost, there are two alternatives. The maxi-
mum ambient operating temperature can be reduced to 50C
(122F), resulting in a 1.6C/W heat sink, or the heat sink can
be isolated from the chassis so the mica washer is not
needed. This will change the required heat sink to a 1.2C/W
unit if the case-to-heat-sink interface is lubricated.
Note: When using a single supply, maximum transfer of heat away from the
LM1875 can be achieved by mounting the device directly to the heat
sink (tab is at ground potential); this avoids the use of a mica or other
type insulator.
The thermal requirements can become more difficult when
an amplifier is driving a reactive load. For a given magnitude
of load impedance, a higher degree of reactance will cause
a higher level of power dissipation within the amplifier. As a
general rule, the power dissipation of an amplifier driving a
60 reactive load (usually considered to be a worst-case
loudspeaker load) will be roughly that of the same amplifier
driving the resistive part of that load. For example, a loud-
speaker may at some frequency have an impedance with a
magnitude of 8
and a phase angle of 60. The real part of
this load will then be 4
, and the amplifier power dissipation
will roughly follow the curve of power dissipation with a 4
load.
www.national.com
7
相關PDF資料 |
PDF描述 |
|---|---|
| LM1875LB02 | 25 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| LM1875TLB03/NOPB | 25 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| LM1875MDC | 25 W, 1 CHANNEL, AUDIO AMPLIFIER, UUC |
| LM1877M-9X | 1.3 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO14 |
| LM1877M-9X/NOPB | 1.3 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1875L-TA5-T | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:20W AUDIO POWER AMPLIFIER |
| LM1875L-TB5-T | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:20W AUDIO POWER AMPLIFIER |
| LM1875T | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| LM1875T | 制造商:National Semiconductor Corporation 功能描述:LM1875T 20W Audio Amplifier IC |
| LM1875T/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single Audio Amplifier |
發布緊急采購，3分鐘左右您將得到回復。