- 您現在的位置：買賣IC網 > PDF目錄30744 > LM1894M/NOPB (NATIONAL SEMICONDUCTOR CORP) SPECIALTY CONSUMER CIRCUIT, PDSO14 PDF資料下載
參數資料
| 型號： | LM1894M/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO14 |
| 封裝： | LEAD FREE, SOP-14 |
| 文件頁數： | 11/12頁 |
| 文件大小： | 340K |
| 代理商： | LM1894M/NOPB |
Application Hints
The DNR system should always be placed before tone and
volume controls as shown in Figure 1. This is because any
adjustment of these controls would alter the noise floor seen
by the DNR control path. The sensitivity resistors R1 and R2
may need to be switched with the input selector, depending
on the noise floors of different sources, i.e., tape, FM, phono.
To determine the value of R1 and R2 in a tape system for
instance; apply tape noise (no program material) and adjust
the ratio of R1 and R2 to open slightly the bandwidth of the
main signal path. This can easily be done by viewing the
capacitor voltage of pin 10 with an oscilloscope, or by using
the circuit of Figure 5. This circuit gives an LED display of the
voltage on the peak detector capacitor. Adjust the values of
R1 and R2 (their sum is always 1 k
) to light the LEDs of pin
1 and pin 18. The LED bar graph does not indicate signal
level, but rather instantaneous bandwidth of the two filters; it
should not be used as a signal-level indicator. For greater
flexibility in setting the bandwidth sensitivity, R1 and R2
could be replaced bya1k
potentiometer.
To change the minimum and maximum value of bandwidth,
the integrating capacitors, C3 and C12, can be scaled up or
down. Since the bandwidth is inversely proportional to the
capacitance, changing this 0.0039 F capacitor to 0.0033 F
will change the typical bandwidth from 965 Hz–34 kHz to 1.1
kHz–40 kHz. With C3 and C12 set at 0.0033 F, the maxi-
mum bandwidth is typically 34 kHz. A double pole double
throw switch can be used to completely bypass DNR.
The capacitor on pin 10 in conjunction with internal resistors
sets the attack and decay times. The attack time can be
altered by changing the size of C10. Decay times can be
decreased by paralleling a resistor with C10, and increased
by increasing the value of C10.
When measuring the amount of noise reduction of the DNR
system, the frequency response of the cassette should be
flat to 10 kHz. The CCIR weighting network has substantial
gain to 8 kHz and any additional roll-off in the cassette player
will reduce the benefits of DNR noise reduction. A typical
signal-to-noise measurement circuit is shown in Figure 6.
The DNR system should be switched from maximum band-
width to nominal bandwidth with tape noise as a signal
source. The reduction in measured noise is the signal-to-
noise ratio improvement.
00791808
FIGURE 3. Output vs Frequency
00791809
FIGURE 4. 3 dB Bandwidth vs
Frequency and Control Signal
LM1894
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LM1894MDC | SPECIALTY CONSUMER CIRCUIT, UUC |
| LM1894MWC | SPECIALTY CONSUMER CIRCUIT, UUC |
| LM1894MT/NOPB | SPECIALTY CONSUMER CIRCUIT, PDSO14 |
| LM1894MTX/NOPB | SPECIALTY CONSUMER CIRCUIT, PDSO14 |
| LM1897N | 2 CHANNEL, AUDIO AMPLIFIER, PDIP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1894MT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| LM1894MTBD | 功能描述:BOARD EVALUATION LM1894 RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
| LM1894MX | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LM1894MX/NOPB | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LM1894N | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:OC White Company 功能描述:Dynamic Noise Reduction System 14-Pin PDIP Rail |
發布緊急采購，3分鐘左右您將得到回復。