欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: LM2619MTC
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 穩壓器
英文描述: 500mA Step-Down DC-DC Converter
中文描述: 1.1 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO14
封裝: MO-153AB, TSSOP-14
文件頁數: 10/16頁
文件大小: 799K
代理商: LM2619MTC
Device Information
(Continued)
tor and load. The inductor limits the current to a ramp with a
slope of (V
–V
)/L, by storing energy in a magnetic field.
During the second part of each cycle, the controller turns the
PFET switch off, blocking current flow from the input, and
then turns the NFET synchronous rectifier on. In response,
the inductor’s magnetic field collapses, generating a voltage
that forces current from ground through the synchronous
rectifier to the output filter capacitor and load. As the stored
energy is transferred back into the circuit and depleted, the
inductor current ramps down with a slope of V
/L. If the
inductor current reaches zero before the next cycle, the
synchronous rectifier is turned off to prevent current reversal.
The output filter capacitor stores charge when the inductor
current is high, and releases it when low, smoothing the
voltage across the load.
The output voltage is regulated by modulating the PFET
switch on time to control the average current sent to the load.
The effect is identical to sending a duty-cycle modulated
rectangular wave formed by the switch and synchronous
rectifier at SW to a low-pass filter formed by the inductor and
output filter capacitor. The output voltage is equal to the
average voltage at the SW pin.
PWM OPERATION
While in PWM (Pulse Width Modulation) mode, the output
voltage is regulated by switching at a constant frequency
and then modulating the energy per cycle to control power to
the load. Energy per cycle is set by modulating the PFET
switch on-time pulse-width to control the peak inductor cur-
rent. This is done by comparing the signal from the current-
sense amplifier with a slope compensated error signal from
the voltage-feedback error amplifier. At the beginning of
each cycle, the clock turns on the PFET switch, causing the
inductor current to ramp up. When the current sense signal
ramps past the error amplifier signal, the PWM comparator
turns off the PFET switch and turns on the NFET synchro-
nous rectifier, ending the first part of the cycle. If an increase
in load pulls the output voltage down, the error amplifier
output increases, which allows the inductor current to ramp
higher before the comparator turns off the PFET. This in-
creases the average current sent to the output and adjusts
for the increase in the load.
Before going to the PWM comparator, the error signal is
summed with a slope compensation ramp from the oscillator
for stability of the current feedback loop. During the second
part of the cycle, a zero crossing detector turns off the NFET
synchronous rectifier if the inductor current ramps to zero.
The minimum on time of the PFET in PWM mode is about
200ns.
20065107
FIGURE 5. Simplified Functional Diagram
L
www.national.com
10
PrintDate=2003/08/20 PrintTime=18:54:05 801627bc ds200651_p Rev. No. 1.25
cmserv
Proof
Seq=10
相關PDF資料
PDF描述
LM2619MTCX 500mA Step-Down DC-DC Converter
LM2621MM Low Input Voltage, Step-Up DC-DC Converter
LM2621
LM2622
LM2623
相關代理商/技術參數
參數描述
LM2619MTC/NOPB 功能描述:IC REG BUCK SYNC ADJ 14-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR
LM2619MTCX 制造商:NSC 制造商全稱:National Semiconductor 功能描述:500mA Step-Down DC-DC Converter
LM261J 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Comparator
LM2621 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Input Voltage, Step-Up DC-DC Converter
LM2621_05 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Input Voltage, Step-Up DC-DC Converter
主站蜘蛛池模板: 武隆县| 香河县| 玛沁县| 贵德县| 镇平县| 沂水县| 永善县| 吉木萨尔县| 永丰县| 西城区| 西安市| 崇仁县| 黔东| 梁山县| 隆尧县| 冷水江市| 罗源县| 波密县| 白城市| 错那县| 密云县| 梨树县| 井冈山市| 修武县| 成都市| 拉萨市| 怀仁县| 滦平县| 柳林县| 疏附县| 房山区| 永平县| 旺苍县| 南部县| 枞阳县| 张北县| 永善县| 芜湖市| 海原县| 乐昌市| 柏乡县|