- 您現在的位置：買賣IC網 > PDF目錄361025 > LM309K THREE-TERMINAL POSITIVE FIXED VOLTAGE REGULATORS PDF資料下載
參數資料
| 型號： | LM309K |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | THREE-TERMINAL POSITIVE FIXED VOLTAGE REGULATORS |
| 中文描述： | 三端固定電壓調節器 |
| 文件頁數： | 3/8頁 |
| 文件大小： | 252K |
| 代理商： | LM309K |
Application Hints
1.
Bypass the input
of the LM109 to ground with
≥
0.2 μF
ceramic or solid tantalum capacitor if main filter capaci-
tor is more than 4 inches away.
2.
Avoid insertion of regulator into “live” socket
if input
voltage is greater than 10V. The output will rise to within
2V of the unregulated input if the ground pin does not
make contact, possibly damaging the load. The LM109
may also be damaged if a large output capacitor is
charged up, then discharged through the internal clamp
zener when the ground pin makes contact.
3.
The output clamp zener
is designed to absorb tran-
sients only. It will not clamp the output effectively if a fail-
ure occurs in the internal power transistor structure. Ze-
ner dynamic impedance is
≈
4
. Continuous RMS
current into the zener should not exceed 0.5A.
4.
Paralleling of LM109s
for higher output current is not
recommended. Current sharing will be almost nonexist-
ent, leading to a current limit mode operation for devices
with the highest initial output voltage. The current limit
devices may also heat up to the thermal shutdown point
(
≈
175C). Long term reliability cannot be guaranteed
under these conditions.
Crowbar Overvoltage Protection
5.
Preventing latchoff
for loads connected to negative
voltage:
If the output of the LM109 is pulled negative by a high cur-
rent supply so that the output pin is more than 0.5V negative
with respect to the ground pin, the LM109 can latch off. This
can be prevented by clamping the ground pin to the output
pin with a germanium or Schottky diode as shown. A silicon
diode (1N4001) at the output is also needed to keep the
positive output from being pulled too far negative. The 10
resistor will raise +V
OUT
by
≈
0.05V.
Typical Performance Characteristics
DS007138-7
Input Crowbar
DS007138-8
Output Crowbar
DS007138-9
*Zener is internal to LM109.
*
Q1 must be able to withstand 7A continuous current if fusing is not used
*
cQ2 is selected for surge capability. Consideration must be given to filter
Trip point is
≈
7.5V.
Maximum Average
Power Dissipation (LM109K)
DS007138-16
Maximum Average
Power Dissipation (LM309K)
DS007138-17
Output Impedance
DS007138-18
www.national.com
3
相關PDF資料 |
PDF描述 |
|---|---|
| LM309H | 5-Volt Regulator |
| LM310 | Voltage Follower |
| LM3101M | Current/Voltage-Mode SMPS Controller |
| LM3101N | Current/Voltage-Mode SMPS Controller |
| LM310H | Voltage Follower |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM309K STEEL | 功能描述:線性穩壓器 - 標準 RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| LM309K STEEL/NOPB | 功能描述:IC REG LDO 5.05V 1.5A TO-3 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| LM309K/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Positive Fixed Voltage Regulator |
| LM309KSTEEL | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LM309K-STEEL | 制造商:Texas Instruments 功能描述:IC, V REG +5.0V, TO-3-2, 309 制造商:Texas Instruments 功能描述:IC, LDO REG, 1.5A, 5.05V, TO-3-2; Primary Input Voltage:25V; Output Voltage Fixed:5.05V; Dropout Voltage Vdo:3mV; No. of Pins:2; Output Current:1.5A; Operating Temperature Min:0C; Operating Temperature Max:125C ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。