- 您現在的位置：買賣IC網 > PDF目錄361037 > LMC6681 (National Semiconductor Corporation) Low Voltage, Rail-To-Rail Input and Output CMOS PDF資料下載
參數資料
| 型號： | LMC6681 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Low Voltage, Rail-To-Rail Input and Output CMOS |
| 中文描述： | 低電壓軌至軌輸入和輸出的CMOS |
| 文件頁數： | 19/24頁 |
| 文件大小： | 750K |
| 代理商： | LMC6681 |
Low Voltage Peak Detector
The accuracy of the peak detector is dependent on the leak-
age currents of the diodes and the capacitors, and the
non-idealities of the amplifier. The parameters of the ampli-
fier which can limit the performance of this circuit are (a) Fi-
nite slew rate, (b) Input current, and (c) Maximum output cur-
rent of the amplifier.
The input current of the amplifier causes a slow discharge of
the capacitor. This phenomenon is called “drooping”. The
LMC6682 has a typical input current of 80 fA. This would
cause the capacitor to droop at a rate of dV/dt = I
/C =
80 fA/100 pF = 0.8 mV/s. Accuracy in the amplitude mea-
surement is also maintained by an offset voltage of 0.5 mV,
and an open-loop gain of 120 dB.
Oscillators
For single supply 5V operation, the output of the circuit will
swing from 0V to 5V. The voltage divider set up R
, R
and
R
will cause the non-inverting input of the LMC6681/2/4 to
move from 1.67V (
1
3
of 5V) to 3.33V (
2
3
of 5V). This voltage
behaves as the threshold voltage.
R
and C
determine the time constant for the circuit. The
frequency of oscillation, f
OSC
is
where
t is the time the amplifier input takes to move from
1.67V to 3.33V. The calculations are shown below.
where
τ
= RC = 0.68 seconds
→
t
1
= 0.27 seconds.
and
→
t
2
= 0.74 seconds
Then,
LMC6681/2/4 as a Comparator
Figure 23 shows the application of the LMC6681/2/4 as a
comparator. The hysteresis is determined by the ratio of the
two resistors. Since the supply current of the LMC6681/2/4 is
less than 1 mA, it can be used as a low power comparator, in
applications where the quiescent current is an important pa-
rameter. At V
S
= 3V, typical propagation delays would be on
the order of t
PHL
= 6 μs, and t
PLH
= 5 μs.
Filters
The filter shown in Figure 24is used to process “voice-band”
signals. The bandpass filter has a gain of 40 dB. The two
corner frequencies, f
1
and f
2
are calculated as
DS012042-23
FIGURE 21. Low Voltage Peak Detector
DS012042-30
FIGURE 22. 1 Hz Square— Wave Oscillator
DS012042-31
FIGURE 23. Comparator with Hysteresis
DS012042-32
FIGURE 24. Wide-Band Band-Pass Filter
www.national.com
19
相關PDF資料 |
PDF描述 |
|---|---|
| LMC6681AIM | Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681AIMX | Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681AIN | Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681BIM | Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681BIN | Low Voltage, Rail-To-Rail Input and Output CMOS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMC6681AIM | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
| LMC6681AIMX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681AIN | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681B1MX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage, Rail-To-Rail Input and Output CMOS |
| LMC6681BIM | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。