- 您現在的位置：買賣IC網 > PDF目錄361038 > LMC7111 (National Semiconductor Corporation) Rheostat; Series:MP; Power Rating:12.5W; Resistance Max:2.5kohm; Terminal Type:Lugs; Resistance:2.5kohm; Type:Rheostat PDF資料下載
參數資料
| 型號： | LMC7111 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Rheostat; Series:MP; Power Rating:12.5W; Resistance Max:2.5kohm; Terminal Type:Lugs; Resistance:2.5kohm; Type:Rheostat |
| 中文描述： | 微型CMOS運算放大器的軌到軌輸入 |
| 文件頁數： | 12/18頁 |
| 文件大小： | 735K |
| 代理商： | LMC7111 |
Application Information
(Continued)
Low Supply Current.
The typical 25 μA supply current of
the LMC7111 extends battery life in portable applications,
and may allow the reduction of the size of batteries in some
applications.
Wide Voltage Range.
The LMC7111 is characterized at
2.7V, 3V, 3.3V, 5V and 10V. Performance data is provided at
these popular voltages. This wide voltage range makes the
LMC7111 a good choice for devices where the voltage may
vary over the life of the batteries.
2.0 Input Common Mode
Voltage Range
The LMC7111 does not exhibit phase inversion when an in-
put voltage exceeds the negative supply voltage.
The absolute maximum input voltage is 300 mV beyond ei-
ther rail at room temperature. Voltages greatly exceeding
this maximum rating can cause excessive current to flow in
or out of the input pins, adversely affecting reliability.
Applications that exceed this rating must externally limit the
maximum input current to
±
5 mA with an input resistor as
shown in Figure 1
3.0 Capacitive Load Tolerance
The LMC7111 can typically directly drive a 300 pF load with
V
= 10V at unity gain without oscillating. The unity gain fol-
lower is the most sensitive configuration. Direct capacitive
loading reduces the phase margin of op-amps. The combi-
nation of the op-amp’s output impedance and the capacitive
load induces phase lag. This results in either an under-
damped pulse response or oscillation.
Capacitive load compensation can be accomplished using
resistive isolation as shown in Figure 2 This simple tech-
nique is useful for isolating the capacitive input of multiplex-
ers and A/D converters.
4.0 Compensating for Input
Capacitance when Using Large
Value Feedback Resistors
When using very large value feedback resistors, (usually
>
500 k
) the large feed back resistance can react with the
input capacitance due to transducers, photodiodes, and cir-
cuit board parasitics to reduce phase margins.
The effect of input capacitance can be compensated for by
adding a feedback capacitor. The feedback capacitor (as in
Figure 3), C
f
is first estimated by:
or
R
1
C
IN
≤
R
2
C
f
which typically provides significant overcompensation.
Printed circuit board stray capacitance may be larger or
smaller than that of a breadboard, so the actual optimum
value for C
may be different. The values of C
should be
checked on the actual circuit. (Refer to the LMC660 quad
CMOS amplifier data sheet for a more detailed discussion.)
5.0 Output Swing
The output of the LMC7111 will go to within 100 mV of either
power supply rail for a 10 k
load and to 20 mV of the rail for
a 100 k
load. This makes the LMC7111 useful for driving
transistors which are connected to the same power supply.
By going very close to the supply, the LMC7111 can turn the
transistors all the way on or all the way off.
6.0 Biasing GaAs RF Amplifiers
The capacitive load capability, low current draw, and small
size of the SOT23-5 LMC7111 make it a good choice for pro-
viding a stable negative bias to other integrated circuits.
The very small size of the LMC7111 and the LM4040 refer-
ence take up very little board space.
DS012352-14
FIGURE 1. R
Input Current Protection for
Voltages Exceeding the Supply Voltage
DS012352-12
FIGURE 2. Resistive Isolation
of a 330 pF Capacitive Load
DS012352-13
FIGURE 3. Cancelling the Effect of Input Capacitance
www.national.com
12
相關PDF資料 |
PDF描述 |
|---|---|
| LMC7111AIN | Tiny CMOS Operational Amplifier with Rail-to-Rail Input |
| LMC7111BIM5 | Tiny CMOS Operational Amplifier with Rail-to-Rail Input |
| LMC7111BIM5X | RHEOSTAT |
| LMC7111BIN | Tiny CMOS Operational Amplifier with Rail-to-Rail Input |
| LMC7215 | Micro-Power, Rail-to-Rail CMOS Comparators with Open-Drain/Push-Pull Outputs and TinyPak⑩ Package |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMC7111AIM5 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier |
| LMC7111AIM5X | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| LMC7111AIN | 功能描述:IC OP AMP R-R IN/OUT CMOS 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| LMC7111BIM5 | 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMC7111BIM5/NOPB | 功能描述:運算放大器 - 運放 TINY 2.7V RRIO UPWR CMOS AMP RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。