- 您現在的位置：買賣IC網 > PDF目錄361039 > LMF100CIWM (NATIONAL SEMICONDUCTOR CORP) High Performance Dual Switched Capacitor Filter PDF資料下載
參數資料
| 型號： | LMF100CIWM |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 模擬濾波器 |
| 英文描述： | High Performance Dual Switched Capacitor Filter |
| 中文描述： | DUAL SWITCHED CAPACITOR FILTER, RESISTOR PROGRAMMABLE, UNIVERSAL, PDSO20 |
| 封裝： | SOP-20 |
| 文件頁數： | 25/28頁 |
| 文件大小： | 868K |
| 代理商： | LMF100CIWM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁
3.0 Applications Information
(Continued)
3.5 SAMPLED DATA SYSTEM CONSIDERATIONS
The LMF100 is a sampled data filter, and as such, differs in
many ways from conventional continuous-time filters. An im-
portant characteristic of sampled-data systems is their effect
on signals at frequencies greater than one-half the sampling
frequency. (The LMF100’s sampling frequency is the same
as its clock frequency.) If a signal with a frequency greater
than one-half the sampling frequency is applied to the input
of a sampled data system, it will be “reflected” to a frequency
less than one-half the sampling frequency. Thus, an input
signal whose frequency is f
/2 + 100 Hz will cause the sys-
tem to respond as though the input frequency was
f
/2 100 Hz. This phenomenon is known as “aliasing”, and
can be reduced or eliminated by limiting the input signal
spectrum to less than f
/2. This may in some cases require
the use of a bandwidth-limiting filter ahead of the LMF100 to
limit the input spectrum. However, since the clock frequency
is much higher than the center frequency, this will often not
be necessary.
Another characteristic of sampled-data circuits is that the
output signal changes amplitude once every sampling pe-
riod, resulting in “steps” in the output voltage which occur at
the clock rate (Figure 25). If necessary, these can be
“smoothed” with a simple R-C low-pass filter at the LMF100
output.
The ratio of f
to f
(normally either 50:1 or 100:1) will also
affect performance. A ratio of 100:1 will reduce any aliasing
problems and is usually recommended for wide-band input
DS005645-39
R1
R2 = 1 k
R3 = 100 k
R4 = 100 k
Rg = 10 k
Rl = 10 k
Rh = 10 k
= 100 k
FIGURE 23. Second-Order Notch Filter
DS005645-13
FIGURE 24. Method for Trimming V
OS
www.national.com
25
相關PDF資料 |
PDF描述 |
|---|---|
| LMF100ACN | IC-MONOLITHIC FILTER |
| LMF380 | LMF380 Triple One-Third Octave Switched-Capacitor Active Filter |
| LMF380C1J | LMF380 Triple One-Third Octave Switched-Capacitor Active Filter |
| LMF380CIN | SERIAL ATA SIGNAL CABLE |
| LMF380CIV | LMF380 Triple One-Third Octave Switched-Capacitor Active Filter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMF100CIWM/NOPB | 功能描述:有源濾波器 HI PERF DUAL SWITCH CAPACITOR FILTER RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube |
| LMF100CIWMX | 功能描述:有源濾波器 RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube |
| LMF100CIWMX/NOPB | 功能描述:有源濾波器 RoHS:否 制造商:Maxim Integrated 通道數量:1 截止頻率:150 KHz 電源電壓-最大:11 V 電源電壓-最小:4.74 V 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP N 封裝:Tube |
| LMF100J WAF | 制造商:Texas Instruments 功能描述: |
| LMF11C202W2851 | 制造商:Vishay Dale 功能描述:KIT LM F 11 C 202 W02851 E3 - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。