- 您現在的位置：買賣IC網 > PDF目錄361040 > LMH6702MAX (NATIONAL SEMICONDUCTOR CORP) Ultra Low Distortion, Wideband Op Amp PDF資料下載
參數資料
| 型號： | LMH6702MAX |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | Ultra Low Distortion, Wideband Op Amp |
| 中文描述： | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| 封裝： | SOIC-8 |
| 文件頁數： | 10/13頁 |
| 文件大小： | 439K |
| 代理商： | LMH6702MAX |
Application Section
(Continued)
The LMH6702 data sheet shows both SOT23 and SOIC data
in the Electrical Characteristic section to aid in selecting the
right package. The Typical Performance Characteristics sec-
tion shows SOIC package plots only.
2-TONE 3
rd
ORDER INTERMODULATION
The 2-tone, 3rd order spurious plot shows a relatively con-
stant difference between the test power level and the spuri-
ous level with the difference depending on frequency. The
LMH6702 does not show an intercept type performance,
(where the relative spurious levels change at a 2X rate vs.
the test tone powers), due to an internal full power bandwidth
enhancement circuit that boosts the performance as the
output swing increases while dissipating negligible quiescent
power under low output power conditions. This feature en-
hances the distortion performance and full power bandwidth
to match that of much higher quiescent supply current parts.
CAPACITIVE LOAD DRIVE
Figure 5
shows a typical application using the LMH6702 to
drive an ADC.
The series resistor, R
S
, between the amplifier output and the
ADC input is critical to achieving best system performance.
This load capacitance, if applied directly to the output pin,
can quickly lead to unacceptable levels of ringing in the
pulse response. The plot of "R
and Settling Time vs. C
" in
the Typical Performance Characteristics section is an excel-
lent starting point for selecting R
. The value derived in that
plot minimizes the step settling time into a fixed discrete
capacitive load with the output driving a very light resistive
load (1k
). Sensitivity to capacitive loading is greatly re-
duced once the output is loaded more heavily. Therefore, for
cases where the output is heavily loaded, R
value may be
reduced. The exact value may best be determined experi-
mentally for these cases.
In applications where the LMH6702 is replacing the CLC409,
care must be taken when the device is lightly loaded and
some capacitance is present at the output. Due to the much
higher frequency response of the LMH6702 compared to the
CLC409, there could be increased susceptibility to low value
output capacitance (parasitic or inherent to the board layout
or otherwise being part of the output load). As already men-
tioned, this susceptibility is most noticeable when the
LMH6702’s resistive load is light. Parasitic capacitance can
be minimized by careful lay out. Addition of an output snub-
ber R-C network will also help by increasing the high fre-
quency resistive loading.
Referring back to
Figure 5
, it must be noted that several
additional constraints should be considered in driving the
capacitive input of an ADC. There is an option to increase
R
S
, band-limiting at the ADC input for either noise or Nyquist
band-limiting purposes. Increasing R
too much, however,
can induce an unacceptably large input glitch due to switch-
ing transients coupling through from the "convert" signal.
Also, C
is oftentimes a voltage dependent capacitance.
This input impedance non-linearity will induce distortion
terms that will increase as R
is increased. Only slight
adjustments up or down from the recommended R
value
should therefore be attempted in optimizing system perfor-
mance.
20039023
FIGURE 4. SOIC and SOT23-5 Packages Distortion
Terms Compared
20039029
FIGURE 5. Input Amplifier to ADC
L
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| LMH6702MF | Ultra Low Distortion, Wideband Op Amp |
| LMH6702MFX | Ultra Low Distortion, Wideband Op Amp |
| LMH6715 | Dual Wideband Video Op Amp |
| LMH6715MA | Dual Wideband Video Op Amp |
| LMH6715MAX | Dual Wideband Video Op Amp |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMH6702MAX/NOPB | 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMH6702MF | 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMH6702MF/NOPB | 功能描述:運算放大器 - 運放 Sgl Low Distort 600 Mhz Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMH6702MF/NOPB | 制造商:Texas Instruments 功能描述:Operational Amplifier (Op-Amp) IC |
| LMH6702MFX | 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。