欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: LMX2433TM
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: XO, clock
英文描述: PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
中文描述: PLL FREQUENCY SYNTHESIZER, 3600 MHz, PDSO20
封裝: PLASTIC, TSSOP-20
文件頁數: 35/49頁
文件大小: 943K
代理商: LMX2433TM
1.0 Functional Description
(Continued)
1.5.1 Phase Comparator and Internal Charge Pump Characteristics
20053511
Notes:
1.
2.
3.
4.
5.
The minimum width of the pump-up and pump-down current pulses occur at the CPoutRF or CPoutIF pins when the loop is phase locked.
The diagram assumes positive VCO characteristics, i.e. RF_CPP or IF_CPP = 1.
f
r
is the PFD input from the reference divider (R counter).
f
p
is the PFD input from the programmable feedback divder (N counter).
CPout refers to either the RF or IF charge pump output.
1.6 CHARGE PUMPS
The charge pump directs charge into or out of an external
loop filter. The loop filter converts the charge into a stable
control voltage which is applied to the tuning input of the
VCO. The charge pump steers the VCO control voltage
towards Vcc during pump-up events and towards GND dur-
ing pump-down events. When locked, CPoutRF or CPoutIF
are primarily in a TRI-STATE mode with small corrections
occuring at the phase comparator rate. The charge pump
output current magnitude can be selected by toggling the
RF_CPG
or
IF_CPG
control bits.
1.7 MICROWIRE SERIAL INTERFACE
The programmable register set is accessed via the MI-
CROWIRE serial interface. A low voltage logic interface
allows direct connection to 1.8V devices. The interface is
comprised of three signal pins: CLK, DATA and LE. Serial
data is clocked into the 24-bit shift register on the rising edge
of CLK. The last two bits decode the internal control register
address. When LE transitions HIGH, DATA stored in the shift
register is loaded into one of four control registers depending
on the state of the address bits. The MSB of DATA is loaded
in first. The synthesizers can be programmed even in power
down mode. A complete programming description is pro-
vided in
Section 2.0 Programming Description
.
1.8 MULTI-FUNCTION OUTPUTS
The LMX243x device’s Ftest/LD output pin is a multi-function
output that can be configured as a general purpose CMOS
TRI-STATE output, push-pull analog lock detect output,
open-drain analog lock detect output, digital filtered lock
detect output, or used to monitor the output of the various
reference divider (R counter) or feedback divider (N counter)
circuits. The Ftest/LD control word is used to select the
desired output function. When the PLL is in powerdown
mode, the Ftest/LD output is disabled and is in a high
impedance state.Acomplete programming description of the
multi-function output is provided in
Section 2.10
.
1.8.1 Push-Pull Analog Lock Detect Output
An analog lock detect status generated from the phase
detector is available on the Ftest/LD output pin if selected. A
push-pull configuration can be selected for the lock detect
output signal. With this configuration, the lock detect output
goes HIGH when the charge pump is inactive. It goes LOW
when the charge pump is active during a comparison cycle.
Narrow low going pulses are observed when the charge
pump turns on.
There are three separate push-pull analog lock detect sig-
nals that are routed to the multiplexer. Two of these monitor
the lock status of the individual synthesizers. The third de-
tects the condition when both the RF and IF synthesizers are
in a locked state. External circuitry is required to provide a
steady DC signal to indicate when the PLL is in a locked
state. Refer to
Section 2.10
for details on how to program
the different push-pull analog lock detect options.
1.8.2 Open-Drain Analog Lock Detect Output
The lock detect output can be an open-drain configuration. In
this configuration, the lock detect output goes to a high
impedance state when the charge pump is inactive. It goes
LOW when the charge pump is active during a comparison
cycle. When a pull-up resistor is used, narrow low going
pulses are observed when the charge pump turns on.
Similarly, three separate open-drain analog lock detect sig-
nals are routed to the multiplexer. Two of these monitor the
lock status of the individual synthesizers. The third detects
the condition when both the RF and IF synthesizers are in a
locked state. External circuitry is required to provide a steady
DC signal to indicate when the PLL is in a locked state. Refer
to
Section 2.10
for details on how to program the different
open-drain analog lock detect options.
L
www.national.com
35
相關PDF資料
PDF描述
LMX2433TMX PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
LMX2434 PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
LMX2434TM PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
LMX2434TMX PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
LMX2430SLEX PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
相關代理商/技術參數
參數描述
LMX2433TM/NOPB 功能描述:鎖相環 - PLL 3.6Ghz High Freq Dual Pll RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
LMX2433TMX 功能描述:鎖相環 - PLL RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
LMX2433TMX/NOPB 功能描述:鎖相環 - PLL RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
LMX2434 制造商:NSC 制造商全稱:National Semiconductor 功能描述:PLLatinum Dual High Frequency Synthesizer for RF Personal Communications
LMX2434EVAL 功能描述:時鐘和定時器開發工具 LMX2434 EVAL BOARD RoHS:否 制造商:Texas Instruments 產品:Evaluation Modules 類型:Clock Conditioners 工具用于評估:LMK04100B 頻率:122.8 MHz 工作電源電壓:3.3 V
主站蜘蛛池模板: 蒲江县| 乳源| 汾阳市| 顺昌县| 綦江县| 万山特区| 白沙| 宜良县| 青阳县| 外汇| 平昌县| 莱西市| 蚌埠市| 台北县| 临沂市| 甘泉县| 威远县| 阳高县| 孝感市| 宁武县| 武冈市| 香格里拉县| 喀什市| 容城县| 黄浦区| 安义县| 余干县| 咸宁市| 江陵县| 濮阳市| 兰考县| 远安县| 南京市| 昌黎县| 永宁县| 揭东县| 襄汾县| 东兰县| 扶余县| 马尔康县| 铜山县|