欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: LP3982ILDX-1.8
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 基準電壓源/電流源
英文描述: Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
中文描述: 1.8 V FIXED POSITIVE LDO REGULATOR, DSO8
封裝: LLP-8
文件頁數: 9/12頁
文件大小: 361K
代理商: LP3982ILDX-1.8
Application Information
(Continued)
The delay time for the application of
Figure 5
is set as
follows:
The application is set for a reset delay time of 8.8ms. Note
that the comparator should have high impedance inputs so
as to not load down the V
REF
at the CC pin of the LP3982.
Shutdown
The LP3982 goes into sleep mode when the SHDN pin is in
a logic low condition. During this condition, the pass transis-
tor, error amplifier, and bandgap are turned off, reducing the
supply current to 1nA typical. The maximum guaranteed
voltage for a logic low at the SHDN pin is 0.4V. A minimum
guaranteed voltage of 2V at the SHDN pin will turn the
LP3982 back on. The SHDN pin may be directly tied to V
IN
to
keep the part on. The SHDN pin may exceed V
IN
but not the
ABS MAX of 6.5V.
Figure 6
shows an application that uses the SHDN pin. It
detects when the battery is too low and disconnects the load
by turning off the regulator. A micropower comparator
(LMC7215) and reference (LM385) are combined with resis-
tors to set the minimum battery voltage. At the minimum
battery voltage, the comparator output goes low and tuns off
the LP3982 and corresponding load. Hysteresis is added to
the minimum battery threshold to prevent the battery’s re-
covery voltage from falsely indicating an above minimum
condition. When the load is disconnected from the battery, it
automatically increases in terminal voltage because of the
reduced IR drop across its internal resistance. The Minimum
battery detector of figure 6 has a low detection threshold
(V
) of 3.6V that corresponds to the minimum battery volt-
age. The upper threshold (V
) is set for 4.6V in order to
exceed the recovery voltage of the battery.
Resistor value for V
UT
and V
LT
are determined as follows:
(The application of figure 6 used a G
T
of 5μ mho)
The above procedure assumes a rail-to-rail output compara-
tor. Essentially, R
2
is in parallel with R
1
prior to reaching the
lower threshold, then R
becomes parallel with R
for the
upper threshold. Note that the application requires rail-to-rail
input as well.
The resistor values shown in
Figure 6
are the closest prac-
tical to calculated values.
Fast Start-up
The LP3982 provides fast start-up time for better system
efficiency. The start-up speed is maintained when using the
optional noise bypass capacitor. An internal 500μA current
source charges the capacitor until it reaches about 90% of its
final value.
20036921
FIGURE 5. Power on Delayed Reset Application
20036902
FIGURE 6. Minimum Battery Detector that Disconnects
the Load Via the SHDN Pin of the LP3982
L
www.national.com
9
相關PDF資料
PDF描述
LP3982ILDX-2.5 CAP EL 220UF 20% 63V 105C LO ESR SMD
LP3982ILDX-2.77 Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
LP3982ILDX-2.82 Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
LP3982ILDX-3.0 Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
LP3982ILDX-3.3 Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
相關代理商/技術參數
參數描述
LP3982ILDX18/NOPB 制造商:Texas Instruments 功能描述:MICROPOWER, ULTRA LOW-DROPOUT, LOW-NOISE, 300MA CMOS REGULATOR
LP3982ILDX-2.5 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
LP3982ILDX-2.5/NOPB 功能描述:IC REG LDO 2.5V .3A 8LLP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 穩壓器拓撲結構:正,固定式 輸出電壓:3.1V 輸入電壓:最高 5.5V 電壓 - 壓降(標準):- 穩壓器數量:1 電流 - 輸出:300mA 電流 - 限制(最小):420mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR)
LP3982ILDX-2.77 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Micropower, Ultra Low-Dropout, Low-Noise, 300mA CMOS Regulator
LP3982ILDX-2.77/NOPB 功能描述:IC REG LDO 2.77V .3A 8LLP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 穩壓器拓撲結構:正,固定式 輸出電壓:3.1V 輸入電壓:最高 5.5V 電壓 - 壓降(標準):- 穩壓器數量:1 電流 - 輸出:300mA 電流 - 限制(最小):420mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR)
主站蜘蛛池模板: 桦川县| 平顶山市| 伊川县| 昭觉县| 台东市| 满洲里市| 沅江市| 沈丘县| 江永县| 呼和浩特市| 前郭尔| 剑川县| 徐闻县| 手游| 鹿邑县| 左云县| 保靖县| 拜城县| 洞头县| 荥阳市| 金阳县| 牟定县| 巍山| 溧阳市| 会同县| 巫山县| 迭部县| 清河县| 万安县| 南康市| 霞浦县| 郧西县| 灵宝市| 宾阳县| 周宁县| 客服| 同仁县| 缙云县| 海原县| 嵊州市| 革吉县|