- 您現在的位置：買賣IC網 > Datasheet目錄41 > LTC3100EUD#TRPBF (Linear Technology)IC REG BUCK/BOOST/LINEAR 16-QFN Datasheet資料下載
參數資料
| 型號： | LTC3100EUD#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 19/26頁 |
| 文件大小： | 403K |
| 描述： | IC REG BUCK/BOOST/LINEAR 16-QFN |
| 產品培訓模塊： | More Information on LDOs |
| 標準包裝： | 2,500 |
| 拓撲： | 降壓（降壓）（1），升壓（升壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 3 |
| 頻率 - 開關： | 1.5MHz |
| 電壓/電流 - 輸出 1： | 0.6 V ~ 5.5 V，250mA |
| 電壓/電流 - 輸出 2： | 1.5 V ~ 5.25 V，700mA |
| 電壓/電流 - 輸出 3： | 0.6 V ~ 5.25 V，100mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 0.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-QFN-EP（3x3） |
| 包裝： | 帶卷 (TR) |
LTC3100
19
3100fb
For more information www.linear.com/LTC3100
APPLICATIONS INFORMATION
Low ESR input capacitors reduce input switching noise
and reduce the peak current drawn from the battery. It
follows that ceramic capacitors are also a good choice for
input decoupling and should be located as close as pos-
sible to the device. A 2.2礔 input capacitor on the V
INBST
pin is sufficient for most applications. Larger values may
be used without limitations. For applications where the
power source is more than a few inches away, a larger
bulk decoupling capacitor is recommended on the input
to the boost converter.
Table 2 shows a list of several ceramic capacitor manu-
facturers. Consult the manufacturers directly for detailed
information on their selection of capacitors.
Note that even X5R and X7R type ceramic capacitors have
a DC bias effect which reduces their capacitance with a DC
voltage applied. This effect is particularly bad for capacitors
in the smallest case sizes. Consult the manufacturers data
for the capacitor you select to be assured of having the
necessary capacitance in your application.
Table 2.Capacitor Vendor Information
SUPPLIER
PHONE
WEB SITE
AVX
(803) 448-9411 www.avxcorp.com
Murata
(714) 852-2001 www.murata.com
Taiyo-Yuden
(408) 573-4150 www.t-yuden.com
TDK
(847) 803-6100 www.component.tdk.com
Buck Inductor Selection
The choice of buck inductor value influences both the
efficiency and the magnitude of the output voltage ripple.
Larger inductance values will reduce inductor current ripple
and will therefore lead to lower output voltage ripple. For
a fixed DC resistance, a larger value inductor will yield
higher efficiency by lowering the peak current to be closer
to the average. However, a larger value inductor within the
same family will generally have a greater series resistance,
thereby offsetting this efficiency advantage. Given a desired
peak to peak current ripple, DI
L
, the required inductance
can be calculated via the following expression, where f
represents the switching frequency in MHz:
L =
1
fDI
L
" 1
V
OUT
V
IN
?/DIV>
?/DIV>
主站蜘蛛池模板：
桃园县|
合山市|
颍上县|
上犹县|
贞丰县|
桃源县|
武义县|
寿阳县|
西青区|
慈利县|
饶河县|
玛纳斯县|
三台县|
东兰县|
扶余县|
广南县|
太保市|
抚远县|
金寨县|
郯城县|
米林县|
乌兰县|
铁力市|
卓资县|
肃北|
黎川县|
阳江市|
孝昌县|
托里县|
榆树市|
郎溪县|
宁波市|
洪江市|
三明市|
女性|
科尔|
通渭县|
新蔡县|
石屏县|
洛宁县|
澎湖县|
?/DIV>
?/DIV>
?/DIV>
?/DIV>
礖
( )
A reasonable choice for ripple current is DI
L
= 100mA
which represents 40% of the maximum 250mA load
current. The DC current rating of the inductor should
be at least 450mA to avoid saturation under overload or
short-circuit conditions. To optimize efficiency the inductor
should have a low series resistance. In particularly space
restricted applications it may be advantageous to use
a much smaller value inductor at the expense of larger
ripple current. In such cases, the converter will operate
in discontinuous conduction for a wider range of output
loads and efficiency will be reduced.
In addition, there is a minimum inductor value required
to maintain stability of the current loop (given the fixed
internal slope compensation). Specifically, if the buck
converter is going to be utilized at duty cycles over 40%,
the inductance value must be at least L
MIN
as given by the
following equation:
L
MIN
= 2.5 " V
OUT
(礖)
Table 3 depicts the minimum required inductance for
several common output voltages.
Table 3.Buck Minimum Inductance
OUTPUT VOLTAGE
MINIMUM INDUCTANCE
0.6V
1.5礖
0.8V
2礖
1.2V
3礖
2V
5礖
2.7V
6.8礖
3.3V
8.3礖
Larger values of inductor will also provide slightly greater
output current capability before reaching current limit (by
reducing the peak-to-peak ripple current).
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3104IMSE#TRPBF | IC REG DL BCK/LINEAR SYNC 16MSOP |
| LTC3445EUF#TRPBF | IC REG TRPL BUCK/LINEAR 24-QFN |
| LTC3446IDE#PBF | IC REG TRPL BCK/LINEAR 14-DFN |
| LTC3537EUD#TRPBF | IC REG DL BST/LINEAR SYNC 16-QFN |
| LTC3541EDD#TRPBF | IC REG DL BCK/LINEAR SYNC 10-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3101 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:8-Output Regulator with Sequencing and I2C |
| LTC3101_10 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Wide VIN, Multi-Output DC/DC Converter and PowerPath Controller |
| LTC3101EUF#PBF | 功能描述:IC BUCK/BST TRPL ADJ 350MA 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.173"，4.40mm 寬）裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF) |
| LTC3101EUF#TRPBF | 功能描述:IC BUCK/BST TRPL ADJ 350MA 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3101EUF-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Wide VIN, Multi-Output DC/DC Converter and PowerPath Controller |
發布緊急采購，3分鐘左右您將得到回復。