- 您現在的位置：買賣IC網 > Datasheet目錄42 > LTC4280CUFD#PBF (Linear Technology)IC CONTROLLER HOT SWAP QFN-24 Datasheet資料下載
參數資料
| 型號： | LTC4280CUFD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 18/28頁 |
| 文件大小： | 291K |
| 描述： | IC CONTROLLER HOT SWAP QFN-24 |
| 標準包裝： | 73 |
| 類型： | 熱交換控制器 |
| 應用： | 通用 |
| 內部開關： | 無 |
| 電源電壓： | 2.9 V ~ 15 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 24-QFN（5x4） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC4280
18
4280f
APPLICATIONS INFORMATION
of R5 resistance, the absence of a drain bypass capacitor,
a combination of bus wiring inductance and bus supply
output impedance. To prevent this second type of oscillation
avoid load capacitance below 10糉, alternately connect an
external capacitor from the MOSFET gate to ground with
a value greater than 1.5糉.
Supply Transients
The LTC4280 is designed to ride through supply transients
caused by load steps. If there is a shorted load and the
parasitic inductance back to the supply is greater than
0.5糎, there is a chance that the supply collapses before
the active current limit circuit brings down the GATE pin.
If this occurs, the undervoltage monitors pull the GATE
pin low. The undervoltage lockout circuit has a 2約 lter
time after V
DD
drops below 2.74V. The UV pin reacts in
2約 to shut the GATE off, but it is recommended to add a
lter capacitor C
F
to prevent unwanted shutdown caused
by a transient. Eventually either the UV pin or undervoltage
lockout responds to bring the current under control before
the supply completely collapses.
Supply Transient Protection
The LTC4280 is safe from damage with supply voltages up
to 24V. However, spikes above 24V may damage the part.
During a short-circuit condition, large changes in current
owing through power supply traces may cause inductive
voltage spikes which exceed 24V. To minimize such spikes,
the power trace inductance should be minimized by using
wider traces or heavier trace plating. Also, a snubber circuit
dampens inductive voltage spikes. Build a snubber by using
a 100?resistor in series with a 0.1糉 capacitor between
V
DD
and GND. A surge suppressor, Z1 in Figure 1, at the
input can also prevent damage from voltage surges.
Design Example
As a design example, take the following speci cations:
V
IN
= 12V, I
MAX
= 5A, I
INRUSH
= 1A, 5ms FILTER time,
C
L
= 330糉, V
UV(ON)
= 10.75V, V
OV(OFF)
= 14.0V, V
PWRGD(UP)
= 11.6V, and I
2
C ADDRESS = 1010011. This completed
design is shown in Figure 1.
Selection of the sense resistor, R
S
, is set by the overcurrent
threshold of 25mV:
R
mV
I
S
MAX
=
=
25
0 005
. ?/DIV>
The MOSFET is sized to handle the power dissipation during
inrush when output capacitor C
OUT
is being charged. A
method to determine power dissipation during inrush is
based on the principle that:
Energy in CL = Energy in Q1
This uses:
Energy in C
L
=
=
(
)( )
1
2
1
2
0 33
12
2
2
CV
mF
.
or 0.024 joules. Calculate the time it takes to charge up
C
OUT
:
t
C
V
I
mF
V
A
ms
STARTUP L
DD
INRUSH
=
=
=
"
.
"
0 33
12
1
4
The power dissipated in the MOSFET:
P
t
W
DISS
STARTUP
=
=
Energyin C
L
6
The SOA (safe operating area) curves of candidate MOSFETs
must be evaluated to ensure that the heat capacity of the
package tolerates 6W for 4ms. The SOA curves of the
Fairchild FDC653N provide for 2A at 12V (24W) for 10ms,
satisfying this requirement. Since the FDC653N has less
than 8糉 of gate capacitance and we are using a GATE
RC network, the short-circuit stability of the current limit
should be checked and improved by adding a capacitor
from GATE to SOURCE if needed.
The inrush current is set to 1A using C1:
C C
I
I
C
mF
糀
A
or C
L
GATE
INRUSH
1
1 0 33
20
1
1 6
=
=
=
"
.
"
?nbsp ?/DIV>
.8 8nF
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4300-1IMS8#TRPBF | IC HOTSWAP 2WIRE BUS BUFFR 8MSOP |
| LTC4300A-2IMS8#TRPBF | IC BUFFER BUS 2WR HOTSWAP 8-MSOP |
| LTC4301IDD | IC BUFFER BUS HOTSWAP 2WR 8DFN |
| LTC4301LIDD#TRPBF | IC BUFFER BUS HOTSWAP 2WR 8DFN |
| LTC4302IMS-1#TRPBF | IC BUFFER 2-WIRE BUS 10-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4280CUFD-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4280CUFD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4280IUFD | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4280IUFD#PBF | 功能描述:IC HOT SWAP CONTROLLER 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4280IUFD#TRPBF | 功能描述:IC CTLR HOT SWAP I2C MON 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。