- 您現在的位置：買賣IC網 > PDF目錄367613 > LUCL9214AA-DT Low-Cost Ringing SLIC PDF資料下載
參數資料
| 型號： | LUCL9214AA-DT |
| 英文描述： | Low-Cost Ringing SLIC |
| 中文描述： | 低成本振鈴用戶接口 |
| 文件頁數： | 1/46頁 |
| 文件大小： | 790K |
| 代理商： | LUCL9214AA-DT |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
codec is used.
Preliminary Data Sheet
October 2001
L9214A/G
Low-Cost Ringing SLIC
Introduction
The Agere Systems Inc. L9214 is a subscriber line
interface circuit that is optimized to provide a very
low-cost solution for short- and medium-loop applica-
tions. This device provides the complete set of line
interface functionality, including power ringing
needed to interface to a subscriber loop. This device
has the capability to operate with a V
CC
supply of
3.3 V or 5 V and is designed to minimize external
components required at all device interfaces.
Features
I
Low-cost solution
I
Onboard ringing generation with software adjust-
able crest factor switching
I
Flexible V
CC
options:
— 3.3 V or 5 V V
CC
— No –5 V required
I
Power control options:
— Power control resistor
— Automatic battery switch to minimize off-hook
power
I
Eight operating states:
— Scan mode for minimal power dissipation
— Forward and reverse battery active
— On-hook transmission states
— Ring mode
— Disconnect mode
I
Low on-hook power:
— 25 mW scan mode
— 165 mW active mode
I
Two SLIC gain options to minimize external com-
ponents in codec interface
I
Loop start, ring trip, and ground key detectors
I
Programmable current limit
I
On-hook and scan mode line voltage clamp
I
Thermal protection
I
48-pin MLCC, 32-pin PLCC, and 28-pin SOG
(Please contact your Agere Sales Representative
for availability) packages
Applications
I
Voice over Internet Protocol (VoIP)
I
Cable Modems
I
Terminal Adapters (TA)
I
Wireless Local Loop (WLL)
I
Telcordia
Technologies
GR-909 Access
I
Network Termination (NT)
I
PBX
I
Key Systems
Description
This device is optimized to provide battery feed, ring-
ing, and supervision on short- and medium-loop plain
old telephone service (POTS) loops. Supported
round trip loop length is up to 1000
.
This device provides power ring to the subscriber by
the use of line reversal to create either a sine wave
ringing signal with a PWM input or a trapezoidal ring-
ing signal with a selectable crest factor from a square
wave input. It provides forward and reverse battery
feed states, on-hook transmission, a low-power scan
state, and a forward disconnect state.
The device requires a V
CC
and line feed battery to
operate. V
CC
may be either a 3.3 V or a 5 V supply.
The ringing signal is derived from the high-voltage
battery. An automatic battery switch is included to
allow for use of a second lower voltage battery in the
off-hook mode, thus minimizing short-loop off-hook
power consumption and dissipation. If the user
desires single battery operation, a power resistor is
required to reduce the power dissipation in the SLIC.
Loop closure, ring trip, and ground key detectors are
available. The loop closure detector has a fixed
threshold with hysteresis. The ring trip detector and
ground key detector threshold and time constants are
externally set.
The dc current limit is programmed by an external
resistor, the maximum current limit determined by the
Vcc supply.
The overhead voltage for this device is fixed and the
device is capable of supporting 3.17 dB into a 600
load with minimal overhead.
The device is offered with two gain options. This
allows for an optimized codec interface, with minimal
external components regardless of whether a first-
generation or a programmable third-generation
相關PDF資料 |
PDF描述 |
|---|---|
| LUCL9214ARG-D | Low-Cost Ringing SLIC |
| LUCL9214AAU-D | Circular Connector; MIL SPEC:MIL-C-5015; Body Material:Metal; Series:GT; No. of Contacts:6; Connector Shell Size:36; Connecting Termination:Solder; Circular Shell Style:Square Flange Receptacle; Body Style:Straight |
| LUCL9215GAU-DT | Short-Loop Sine Wave Ringing SLIC |
| LUCL9215GRG-D | Short-Loop Sine Wave Ringing SLIC |
| LUCL9215GAU-D | Short-Loop Sine Wave Ringing SLIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LUCL9214AAJ-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Ringing SLIC |
| LUCL9214AAJ-DT | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Ringing SLIC |
| LUCL9214AAU-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Ringing SLIC |
| LUCL9214ARG-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Ringing SLIC |
| LUCL9214ARG-DT | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Ringing SLIC |
發布緊急采購，3分鐘左右您將得到回復。