- 您現在的位置：買賣IC網 > Datasheet目錄55 > MAX2369EGM+TD (Maxim Integrated)IC TRANSMITTER QUAD 48QFN-EP Datasheet資料下載
參數資料
| 型號： | MAX2369EGM+TD |
| 廠商： | Maxim Integrated |
| 文件頁數： | 7/16頁 |
| 文件大小： | 229K |
| 描述： | IC TRANSMITTER QUAD 48QFN-EP |
| 標準包裝： | 2,500 |
| 頻率： | 120MHz ~ 235MHz |
| 應用： | 手機，GAIT 手持話機，LAN，PCS，TDMA，WAN，WLL |
| 功率 - 輸出： | 5.8dBm ~ 12dBm |
| 電流 - 傳輸： | 6.5mA ~ 155mA |
| 數據接口： | PCB，表面貼裝 |
| 天線連接器： | PCB，表面貼裝 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-QFN 裸露焊盤 |
| 包裝： | 帶卷 (TR) |
Complete Dual-Band
Quadrature Transmitter
_______________________________________________________________________________________ 7
Pin Description
VGC
V
CC
IFOUT+,
IFOUT-
V
CC
RF and IF Variable-Gain Control Analog Input. VGC floats to +1.5V. Apply
+0.5V to +2.6V to control the gain of the RF and IF stages. An RC filter on this pin may be used
to reduce DAC noise or PDM clock spurs from this line.
20
Supply Pin for the IF VGA. Bypass with a capacitor as close to the pin as possible. The bypass
capacitor must not share its ground vias with any other branches.
21
Differential IF Outputs. These pins must be inductively pulled up to V
CC
. A differential IF band-
pass filter is connected between this port and IFIN+ and IFIN-. The pullup inductors can be part
of the filter structure. The differential output impedance of this port is nominally 600&. The trans-
mission lines from these pins should be short to minimize the pickup of spurious signals and
noise.
18, 19
Power supply. Bypass to ground with a 1000pF capacitor.
16, 17
PIN
NAME
FUNCTION
1
RFL
Transmitter RF Output for Cellular Band (800MHz to 1000MHz)for both FM and digital modes.
This open-collector output requires a pullup inductor to the supply voltage, which is part of the
output matching network and may be connected directly to the battery.
2
RFH
Transmitter RF Output for PCS Band (1700MHz to 2000MHz). This open collector output
requires a pullup inductor to the supply voltage. The pullup inductor is part of the output match-
ing network and may be connected directly to the battery.
Open-Collector Output Indicating Lock Status of the IF PLL. Requires a pullup resistor. Control
using configuration register bit LD_MODE.
LOCK
3
4
V
CC
Power Supply. Supply pin for the driver stage. V
CC
must be bypassed to system ground as
close to the pin as possible. The ground vias for the bypass capacitor should not be shared by
any other branch. Bypass to ground with 100pF and 100nF capacitors.
Power Supply. Connect to pin 4 for normal operation.
V
CC
5
6
V
CC
Supply Pin for the Upconverter Stage. V
CC
must be bypassed to system ground as close to the
pin as possible. The ground vias for the bypass capacitor should not be shared by any other
branch.
Digital Input. A logic low on TXGATE shuts down everything except the IF PLL, IF VCO, and ser-
ial bus and registers. This mode is used for IF PLL settling before the transmit time slot.
TXGATE
7
8, 9
IFIN+, IFIN-
Differential Inputs to the RF Upconverter. These pins are internally biased to +1.5V. The input
impedance for these ports is nominally 400& differential. The IF filter should be AC-coupled to
these ports. Keep the differential lines as short as possible to minimize stray pickup and shunt
capacitance.
No Connection. Leave these pins floating.
N.C.
10, 11
12
R
BIAS
Bias Resistor Pin. RBIAS is internally biased to a bandgap voltage of +1.18V. An external resistor
or current source must be connected to this pin to set the bias current for the upconverters and PA
driver stages. The nominal resistor value is 16k&. This value can be altered to optimize the linearity
of the driver stage.
Input Pins from the 3-Wire Serial Bus (SPI/QSPI/MICROWIRE compatible).
An R-C filter on each of these pins may be used to reduce noise.
CLK, DI, CS
13, 14, 15
相關PDF資料 |
PDF描述 |
|---|---|
| MAX2850ITK+ | TRANSMITTER MIMO 5GHZ 4CH 68TQFN |
| MAX7057ASE+T | IC TRANSMITTER ASK/FSK 16-SOIC |
| MBA-2060 | ANTENNA METROLOGY BICONICAL |
| MC33493ADTBER2 | IC RF TRANSMITTER UHF 14-TSSOP |
| MDEV-916-ES | KIT MASTER DEVELOP 916MHZ ES SRS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX2369EGM-TDG069 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX236C/D | 功能描述:RS-232接口集成電路 +5V Pwrd 4 RS-232 Xmttrs and 3 RS-232 Rcvrs w/ Pwr Shtdwn & Rcvr RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX236C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX236C/D+ | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX236CNG | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。