欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MAX8896EREE+T
廠商: Maxim Integrated
文件頁數: 13/17頁
文件大小: 449K
描述: IC REG TRPL BCK/LINEAR 16UCSP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 1
拓撲: 降壓(降壓)同步(2),線性(LDO)(1)
功能: 任何功能
輸出數: 3
頻率 - 開關: 2MHz
電壓/電流 - 輸出 1: 0.2 V ~ 1.7 V,700mA
電壓/電流 - 輸出 2: 3.1V,200mA
電壓/電流 - 輸出 3: 2.8V,200mA
帶 LED 驅動器:
帶監控器:
帶序列發生器:
電源電壓: 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-WFBGA,CSPBGA
供應商設備封裝: 16-UCSP(4x4)
包裝: 標準包裝
其它名稱: MAX8896EREE+TDKR
Dual PWM Step-Down Converter in a 2mm x
2mm Package for WCDMA PA and RF Power
______________________________________________________________________________________ 13
The OUT2 step-down DC-DC converter operates with
100% duty cycle when the supply voltage approaches
the output voltage. This allows this converter to main-
tain regulation until the input voltage falls below the
desired output voltage plus the dropout voltage specifi-
cation of the converter. During 100% duty cycle opera-
tion, the high-side p-channel MOSFET turns on
constantly, connecting the input to the output through
the inductor. The dropout voltage (V
DO
) is calculated
as follows:
V
DO
= I
LOAD
x (R
P
+ R
L
)
where:
R
P
= internal p-channel MOSFET switch on-resistance
(see Electrical Characteristics)
R
L
= external inductor DC resistance
LDO
The LDO provides 200mA at 2.8V and is designed for
low noise (16礦
RMS
, typ) and high PSRR (65dB, typ).
The LDO is powered from OUT2 (3.1V) and is enabled
or disabled at the same time as OUT2 using RFEN1 or
RFEN2.
LDO Dropout Voltage
The regulators minimum input/output differential (or
dropout voltage) determines the lowest usable supply
voltage. In battery-powered systems, this determines
the useful end-of-life battery voltage. Because the LDO
uses a p-channel MOSFET pass transistor, the dropout
voltage is drain-to-source on-resistance (R
DS(ON)
) mul-
tiplied by the load current (see the Typical Operating
Characteristics).
Shutdown Mode
Connect PAEN to GND or logic-low to place OUT1 in
shutdown mode. In shutdown, the control circuitry,
internal switching MOSFET, and synchronous rectifier
turn off and LX1 becomes high impedance. Connect
PAEN to IN1, V
CC
, or logic-high for normal operation.
Either RFEN1 or RFEN2 enable OUT2 and the LDO.
Connect RFEN1 and RFEN2 to GND or logic-low to
place OUT2 and the LDO in shutdown mode. In shut-
down, the control circuitry, internal switching MOSFET,
and synchronous rectifier turn off and LX2 and the LDO
output become high impedance. Connect RFEN1 or
RFEN2 to IN2, V
CC
, or logic-high for normal operation.
When PAEN, RFEN1, and RFEN2 are all logic-low, the
MAX8896 enter a very low power state, where the input
current drops to 0.1礎 (typ).
Thermal-Overload Protection
Thermal-overload protection limits total power dissipation
in the MAX8896. If the junction temperature exceeds
+160癈, the MAX8896 turn off, allowing the IC to cool.
The IC turns on and begins soft-start after the junction
temperature cools by 20癈. This results in a pulsed out-
put during continuous thermal-overload conditions.
Applications Information
Inductor Selection
OUT1 operates with a switching frequency of 2MHz and
utilizes a 2.2礖 to 4.7礖 inductor. OUT2 operates with a
switching frequency of 2MHz and utilizes a 2.2礖 induc-
tor. This operating frequency allows the use of physically
small inductors while maintaining high efficiency.
The OUT1 inductors DC current rating only needs to
match the maximum load of the application because
OUT1 features zero current overshoot during startup and
load transients. For optimum transient response and high
efficiency, choose an inductor with DC series resistance
in the 50m&to 150m&range. See Table 1 for suggested
inductors and manufacturers.
Using a larger inductance value reduces the ripple cur-
rent, therefore providing higher efficiency at light load.
Output Capacitor Selection
For OUT1 and OUT2, the output capacitor keeps the
output voltage ripple small and ensures regulation loop
stability. C
OUT
must have low impedance at the switch-
ing frequency. Ceramic capacitors with X5R or X7R
temperature characteristics are highly recommended
due to their small size, low ESR, and small temperature
coefficients. A 4.7礔 capacitor is recommended for
C
OUT1
and 2.2礔 is recommended for C
OUT2
. For opti-
mum load-transient performance and very low output
ripple, the output capacitor value can be increased.
For the LDO, the minimum output capacitance required
is dependent on the load currents. For loads lighter
than 10mA, it is sufficient to use a 0.1礔 capacitor for
stable operation over the full temperature range. With
rated maximum load currents, a minimum of 1礔 is rec-
ommended. Larger value output capacitors further
reduce output noise and improve load-transient
response, stability, and power-supply rejection.
Note that some ceramic dielectrics exhibit large capac-
itance and ESR variation with temperature and DC bias.
Ceramic capacitors with Z5U or Y5V temperature char-
acteristics should be avoided. These regulators are
optimized for ceramic capacitors. Tantalum capacitors
are not recommended.
相關PDF資料
PDF描述
MC33232PG IC PFC CONTROLLER CRM 8DIP
MC33260DR2G IC PFC CONTROLLER DCM 8SOIC
MC33262DG IC PFC CONTROLLER CRM 8SOIC
MC33368DR2G IC PFC CONTROLLER CRM 16SOIC
MC33567D-1G IC REG CTRLR DUAL OUT 8-SOIC
相關代理商/技術參數
參數描述
MAX8896EVKIT+ 功能描述:直流/直流開關轉換器 Dual PWM Step-Down Converter in a 2mm x 2mm Package for WCDMA PA and RF Power RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
MAX8899EVKIT+ 制造商:Maxim Integrated Products 功能描述:EVALUATION KIT FOR MAX8899 - Boxed Product (Development Kits)
MAX8899EWZ+ 制造商:Maxim Integrated Products 功能描述:- Rail/Tube
MAX8899EWZ+T 制造商:Maxim Integrated Products 功能描述:WCDMA/EDGE/GPRS/GSM/CDMA - Tape and Reel
MAX8899EWZ+TCAA 制造商:Maxim Integrated Products 功能描述:WCDMA/EDGE/GPRS/GSM/CDMA PHONE PMIC - Rail/Tube
主站蜘蛛池模板: 灯塔市| 方正县| 寻乌县| 旌德县| 麟游县| 紫阳县| 合阳县| 内乡县| 五河县| 图片| 德江县| 宜丰县| 广州市| 宁德市| 景宁| 大连市| 宣恩县| 潞城市| 罗定市| 高邑县| 伊金霍洛旗| 乌鲁木齐市| 大田县| 从江县| 芦山县| 且末县| 永德县| 通海县| 惠州市| 义乌市| 济阳县| 池州市| 文登市| 通许县| 阳东县| 大同市| 简阳市| 古交市| 灵山县| 台东市| 兰考县|