- 您現在的位置：買賣IC網 > PDF目錄382289 > MB91133 (Fujitsu Limited) 32-Bit RISC Microcontroller PDF資料下載
參數資料
| 型號： | MB91133 |
| 廠商： | Fujitsu Limited |
| 英文描述： | 32-Bit RISC Microcontroller |
| 中文描述： | 32位RISC微控制器 |
| 文件頁數： | 20/123頁 |
| 文件大小： | 1362K |
| 代理商： | MB91133 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁
MB91133/MB91F133
20
I
HANDLING DEVICES
1.
Points to Note on Handling Devices
(1) Latch-up prevention
Latch-up may occur by CMOS IC if a voltage in excess of V
CC
5 or lower than V
SS
is applied to the input/output
pins, or if the voltage exceeds the rating between V
CC
5 and V
SS
. If latch-up occurs, the electrical current increases
significantly and may destroy certain components due to excessive heat, so great care must be taken to ensure
that the maximum rating is not exceeded during use.
(2) Handling Pins
Handling unused pins
Input pins that are not used should be pulled up or down as they may cause erroneous operations if left open.
Handling N.C. pins
N.C. pins must be opened for use.
Handling output pins
Excessive electric current may flow if the output pin is shorted by the power source or other output pins, or
connected to large loads. If such status is prolonged, the device is liable to be damaged, so great care must
be taken to ensure that the usage volume does not exceed the maximum rating.
Mode pins (MD0 to MD2)
Those pins must be directly connected to V
CC
5 or V
SS
for use.
Pattern lengths between V
CC
5 or V
SS
and each mode pin on the printed-circuit board should be arranged to
be as short as possible to prevent the test mode from being erroneously turned on due to noise, and they
should be connected with low impedance.
Power pins
When there are a number of V
CC
5/V
CC
3/V
SS
, those whose electrical potential must be the same within the
device are connected to prevent erroneous operation such as latch-up for device design purposes, but those
must be externally connected to a power source and earthed to follow the general output current standard and
prevent erroneous operation of strobe signals due to increased ground level and reduction in unnecessary
radiation.
Care must also be taken to ensure that they are connected to the V
CC
5/V
SS
or V
CC
3/V
SS
of this device at the
lowest possible impedance from the source of the electrical current supply.
Furthermore, it is recommended that a ceramic capacitor of around 0.1
μ
F be used to connect the V
CC
5 and
V
SS
, or V
CC
3 and V
SS
near the device as a bypass capacitor.
Crystal oscillation circuits
Noise near the X0, X1, X0A or X1A pins can cause erroneous operation. The printed-circuit board must be
designed so that the X0, X1, X0A and X1A pins, crystal oscillator (or ceramic oscillator) and bypass capacitor
to the ground can be arranged as close as possible.
Also, a printed-circuit board with grounded artwork enclosing the X0, X1, X0A and X1A pins is strongly
recommended to ensure stable operation.
相關PDF資料 |
PDF描述 |
|---|---|
| MB91133PMT2 | 32-Bit RISC Microcontroller |
| MBC13900 | NPN Silicon Low Noise Transistor |
| MBC13900T1 | NPN Silicon Low Noise Transistor |
| MBC2014CF | SILICON PLANAR PHTODIODES |
| MBC3026CF | SILICON PLANAR PHTODIODES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB91133PBT | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-Bit RISC Microcontroller |
| MB91133PMT2 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-Bit RISC Microcontroller |
| MB91150 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91151A | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91151APMT2-G | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。