- 您現在的位置：買賣IC網 > PDF目錄371001 > MC100LVE222FA (MOTOROLA INC) LOW VOLTAGE 1:15 DIFFERENTIAL ±1/±2 ECL/PECL CLOCK DRIVER PDF資料下載
參數資料
| 型號： | MC100LVE222FA |
| 廠商： | MOTOROLA INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | LOW VOLTAGE 1:15 DIFFERENTIAL ±1/±2 ECL/PECL CLOCK DRIVER |
| 中文描述： | 100LVE SERIES, LOW SKEW CLOCK DRIVER, 15 TRUE OUTPUT(S), 15 INVERTED OUTPUT(S), PQFP52 |
| 封裝： | 10 X 10 MM, 0.65 MM PITCH, PLASTIC, TQFP-52 |
| 文件頁數： | 1/6頁 |
| 文件大小： | 137K |
| 代理商： | MC100LVE222FA |
SEMICONDUCTOR TECHNICAL DATA
4–1
REV 1
Motorola, Inc. 1996
10/96
÷
÷
The MC100LVE222 is a low voltage, low skew 1:15 differential
÷
1/
÷
2
ECL fanout buffer designed with clock distribution in mind. The device
features fully differential clock paths to minimize both device and system
skew. The LVE222 can be used as a simple fanout buffer or outputs can
be configured to provide half frequency outputs. The combination of 1x
and 1/2x frequencies is flexible providing for a myriad of combinations. All
timing differences between the 1x and 1/2x signals are compensated for
internal to the chip so that the output–to–output skew is identical
regardless of what output frequencies are selected.
Fifteen Differential Outputs
200ps Part–to–Part Skew
50ps Output–to–Output Skew
Selectable 1x or 1/2x Frequency Outputs
Extended Power Supply Range of –3.0V to –5.25V (+3.0V to +5.25V)
52–Lead TQFP Packaging
ESD > 2000V
The fsel and CLK_Sel input pins are asynchronous control signals. As
a result, changing these inputs could cause indeterminent excursions on
the outputs immediately following the changes on the inputs.
For applications which require a single–ended input, the VBB reference
voltage is supplied. For single–ended input applications the VBB
reference should be connected to the CLK input and bypassed to ground
via a 0.01
μ
f capacitor. The input signal is then driven into the CLK input.
To ensure that the tight skew specification is met it is necessary that both sides of the differential output are terminated into
50
, even if only one side is being used. In most applications all fifteen differential pairs will be used and therefore terminated. In
the case where fewer than fifteen pairs are used it is necessary to terminate at least the output pairs adjacent to the output pair
being used in order to maintain minimum skew. Failure to follow this guideline will result in small degradations of propagation
delay (on the order of 10–20ps) of the outputs being used, while not catastrophic to most designs this will result in an increase in
skew. Note that the package corners isolate outputs from one another such that the guideline expressed above holds only for
outputs on the same side of the package.
The MC100LVE222, as with most ECL devices, can be operated from a positive VCC supply in PECL mode. This allows the
LVE222 to be used for high performance clock distribution in +3.3V systems. Designers can take advantage of the LVE222’s
performance to distribute low skew clocks across the backplane or the board. In a PECL environment series or Thevenin line,
terminations are typically used as they require no additional power supplies, if parallel termination is desired a terminating voltage
of VCC–2.0V will need to be provided. For more information on using PECL, designers should refer to Motorola Application Note
AN1406/D.
The MC100LVE222 is packaged in the 52–lead TQFP package. For a 3.3V supply this package provides the optimum
performance and minimizes board space requirements. The LVE222 will operate from a standard 100E –4.5V supply or a 5.0V
PECL supply. The 52–lead TQFP utilizes a 10x10mm body with a lead pitch of 0.65mm.
LOW VOLTAGE
1:15 DIFFERENTIAL
÷
1/
÷
2
ECL/PECL CLOCK DRIVER
FA SUFFIX
TQFP PACKAGE
CASE 848D–03
相關PDF資料 |
PDF描述 |
|---|---|
| MC100LVEL30DW | SINGLE-CHANNEL 100ma POWER SWITCH 8-SOIC -40 to 85 |
| MC100EL30DW | Triple D Flip-Flop With Set and Reset |
| MC100LVEL31D | SINGLE-CHANNEL 100ma POWER SWITCH 8-SOIC -40 to 85 |
| MC100LVEL32D | D SUFFIX PLASTIC SOIC PACKAGE CASE 751-05 |
| MC100LVEL59DW | Triple 2:1 Multiplexer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC100LVE222FAG | 功能描述:時鐘驅動器及分配 BBG ECLClock Driver Differential RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC100LVE222FAR2 | 功能描述:時鐘驅動器及分配 3.3V 1:15 Diff ECL RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC100LVE222FAR2G | 功能描述:時鐘驅動器及分配 BBG ECLClock Driver Differential RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC100LVE310FN | 功能描述:時鐘驅動器及分配 3.3V ECL 2:8 Diff RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC100LVE310FNG | 功能描述:時鐘驅動器及分配 3.3V ECL 2:8 Diff Fanout Buffer RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。