- 您現在的位置：買賣IC網 > PDF目錄382300 > MC1GU128NACA (SAMSUNG SEMICONDUCTOR CO. LTD.) MultiMediaCard Specification PDF資料下載
參數資料
| 型號： | MC1GU128NACA |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | MultiMediaCard Specification |
| 中文描述： | 多媒體卡規格 |
| 文件頁數： | 19/66頁 |
| 文件大?。?/td> | 1422K |
| 代理商： | MC1GU128NACA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
MultiMediaCard
TM
19
rising and falling edges). If the host does not allow the switchable R
OD
implementation, a fix R
CMD
can
be used. Consequently the maximum operating implementation, a fix R
CMD
can be used. Consequently
the maximum operating frequency in the open drain mode has to be reduced in this case.
4.4 SPI Bus Topology
4.4.1 SPI Interface Concept
The Serial Peripheral Interface (SPI) is a general-purpose synchronous serial interface originally found
on certain Motorola micro-controllers. The MultiMediaCard SPI interface is compatible with SPI hosts
available on the market. As any other SPI device the MultiMediaCard SPI channel consists of the
following 4 signals:
-
CS : Host to card chip select signal
-
CLK : Host to card clock signal
-
DataIn : Host to card data signal
-
DataOut : Card to host data signal
Another SPI common characteristic, which is implemented in the MultiMediaCard card as well, is byte
transfers. All data tokens are multiples of 8 bit bytes and always byte aligned to the CS signal. The SPI
standard defines the physical link only and not the complete data transfer protocol. The MultiMediaCard
uses a subset of the MultiMediaCard protocol and command set
.
4.4.2 SPI Bus Topology
The MultiMediaCard card identification and addressing algorithms are replaced by hardware Chip Select
(CS) signal. There are no broadcast commands. A card (slave) is selected, for every command, by
asserting (active low) the CS signal (see Figure 4-3). The CS signal bust is continuously active for the
duration of the SPI transaction (command, response and data). The only exception is card-programming
time. At this time the host can de-assert the CS signal without affecting the programming process. The
bi-directional CMD and DAT lines are replaced by unidirectional dataIn and dataOut signals. This
eliminates the ability of executing commands while data is being read or written and, therefore,
eliminates the sequential and multi block read/write operations. The SPI channel supports only single
block read/write.
Figure 4-3 SPI Bus System
相關PDF資料 |
PDF描述 |
|---|---|
| MC1DU128NACA | MultiMediaCard Specification |
| MC1GU256NACA | MultiMediaCard Specification |
| MC1DU256NACA | MultiMediaCard Specification |
| MC28U016HACA-0QC00 | MultiMediaCard Specification |
| MC2DU016HACA-0QC00 | MultiMediaCard Specification |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC1GU128NACA-0QC00 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification |
| MC1GU128NACB-0QC00 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification |
| MC1GU128NACC-0QC00 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification |
| MC1GU128NAFA-0QC00 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification |
| MC1GU128NAFB-0QC00 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification |
發布緊急采購，3分鐘左右您將得到回復。