- 您現在的位置：買賣IC網 > PDF目錄371048 > MC68HCP11A1CP3 (MOTOROLA INC) HCMOS Single-Chip Microcontroller PDF資料下載
參數資料
| 型號： | MC68HCP11A1CP3 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | HCMOS Single-Chip Microcontroller |
| 中文描述： | 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PDIP48 |
| 封裝： | DIP-48 |
| 文件頁數： | 46/158頁 |
| 文件大小： | 776K |
| 代理商： | MC68HCP11A1CP3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁
MOTOROLA
5-2
SERIAL COMMUNICATIONS INTERFACE
MC68HC11A8
TECHNICAL DATA
5
1. The idle line is brought to a logic one state prior to transmission/reception of a
character.
2. A start bit (logic zero) is used to indicate the start of a frame.
3. The data is transmitted and received least-significant-bit first.
4. A stop bit (logic one) is used to indicate the end of a frame. A frame consists of
a start bit, a character of eight or nine data bits, and a stop bit.
5. A break is defined as the transmission or reception of a low (logic zero) for at
least one complete frame time.
Figure 5-1 Data Format
5.3 Wake-Up Feature
The receiver wake-up feature reduces SCI service overhead in multiple receiver sys-
tems. Software in each receiver evaluates the first character(s) of each message. If
the message is intended for a different receiver, the SCI can be placed in a sleep mode
so that the rest of the message will not generate requests for service. Whenever a new
message is started, logic in the sleeping receivers causes them to wake up so they
can evaluate the initial character(s) of the new message.
A sleeping SCI receiver can be configured (using the WAKE control bit in serial com-
munications control register 1 (SCCR1)) to wake up using either of two methods: idle
line wake up or address mark wake up.
In idle line wake up, a sleeping receiver wakes up as soon as the RxD line becomes
idle. Idle is defined as a continuous logic high on the RxD line for ten (or eleven) full
bit times. Systems using this type of wake up must provide at least one character time
of idle between messages to wake up sleeping receivers but must not allow any idle
time between characters within a message.
In address mark wake up, the most significant bit (MSB) in a character is used to indi-
cate that the character is an address (1) or a data (0) character. Sleeping receivers will
wake up whenever an address character is received. Systems using this method for
wake up would set the MSB of the first character in each message and leave it clear
for all other characters in the message. Idle periods may be present within messages
and no idle time is required between messages for this wake up method.
5.4 Receive Data (RxD)
Receive data is the serial data which is applied through the input line and the serial
communications interface to the internal bus. The receiver circuitry clocks the input at
a rate equal to 16 times the baud rate and this time is referred to as the RT clock.
0
1
2
3
4
5
6
7
8
*
0
IDLE LINE
SCI DATA FORMAT
1
START
STOP
START
* CONTROL BIT M IN SCCR1 SELECTS EITHER 8-BIT OR 9-BIT DATA.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HCP11A1MFN2 | HCMOS Single-Chip Microcontroller |
| MC68HCP11A1MP2 | HCMOS Single-Chip Microcontroller |
| MC68HCP11A1VFN2 | HCMOS Single-Chip Microcontroller |
| MC68HCP11A1VP2 | HCMOS Single-Chip Microcontroller |
| MC68HC11A8VCFN2 | HCMOS Single-Chip Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HCP11A1FN | 制造商:MOTORALA 功能描述: |
| MC68HCP11E0CP2 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC68HCP11E0FN | 功能描述:MICROCONTROLLER MCU 8ADC 3MHC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC11 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN，SCI，SPI 外圍設備:POR，PWM，溫度傳感器，WDT 輸入/輸出數:21 程序存儲器容量:40KB（20K x 16） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| MC68HCP11E0FNE | 功能描述:8位微控制器 -MCU 8B MCU 512RAM COP A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| MC68HCP11E1CFNE2 | 功能描述:8位微控制器 -MCU 8B MCU 512 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。