- 您現在的位置：買賣IC網 > PDF目錄374434 > MFL2805S (CRANE ELECTRONICS INC) DC/DC CONVERTERS 28 VOLT INPUT PDF資料下載
參數資料
| 型號： | MFL2805S |
| 廠商： | CRANE ELECTRONICS INC |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | DC/DC CONVERTERS 28 VOLT INPUT |
| 中文描述： | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | HERMETIC SEALED PACKAGE-12 |
| 文件頁數： | 1/8頁 |
| 文件大小： | 184K |
| 代理商： | MFL2805S |
MODELS
VDC O
UTPUT
SINGLE
5
12
15
28
1
Size (max): 3.005 x 1.505 x 0.400 inches (76.33 x 38.23 x 10.16 mm)
Case U
Weight:
100 grams maximum
Screening: Standard, ES, or 883 (Class H).
DUAL
±5
±12
±15
DESCRIPTION
The MFL Series 28-volt DC/DC converters are rated up to 65
watts of output power over a –55°C to +125°C temperature range
with a 28 Vdc nominal input. On dual output models up to 70% of
the rated output power can be drawn from either the positive or
negative output. Current sharing allows the units to be paralleled for
total power of up to 148watts. The welded, hermetically sealed
package is only 3.005 x 1.505 x 0.400 inches, giving the series an
overall power density of up to 43 watts per cubic inch.
D
ESIGN
F
EATURES
The MFL Series converters are switching regulators that use a
quasi-square wave, single ended forward converter design with a
constant switching frequency of 600 kHz.
Isolation between input and output circuits is provided with a trans-
former in the forward path and a wide bandwidth magnetic coupling
in the feedback control loop. The MFL uses a unique dual loop feed-
back technique that controls output current with an inner feedback
loop and an output voltage with a cascaded voltage mode feedback
loop.
The additional secondary current mode feedback loop improves
transient response in a manner similar to primary current mode
control and allows for ease of paralleling, but without the cost and
complexity.
The cascaded constant frequency, pulse-width modulated
converters use a quasi-square wave single-ended forward design.
Tight load regulation is achieved through a wide-bandwidth
magnetic feedback circuit. The output on single MFL models can be
trimmed (see Figure 1 for voltage changes with different resistor
values).
I
NHIBIT
The MFL Series converters have two TTL compatible inhibit termi-
nals (INH1 and INH2) that can be used to disable power conversion,
resulting in a very low quiescent input current and no generation of
switching noise. An open collector TTL compatible low (<0.8 volts)
is required to inhibit the converter between INH1 (pin 4) and Input
Common (pin 2). An open collector TTL compatible low (<0.5 volts)
is required to inhibit the converter between INH2 (pin 12) and Output
Common (pin 8). The application of intermediate voltages to these
pins (1.5 to 10.5 volts) should be avoided.
C
URRENT AND
P
ARALLEL
O
PERATION
Multiple MFL converters may be used in parallel to drive a common
load (see Figure 2). In this mode of operation the load current is
shared by two or three MFL converters. In current sharing mode,
one MFL converter is designated as a master. The SLAVE pin (pin
11) of the master is left unconnected and the MSTR/INH2 pin (pin
12) of the master is connected to the SLAVE pin (pin 11) of the slave
units. The units designated as slaves have the MSTR/INH2 pin (pin
12) connected to the SNS RTN pin (pin 9). Figure 2 shows the
typical setup for two or three units in parallel. Note that synchro-
nizing the units together (though shown in the figure) is not required
for current sharing operation. A second slave unit may be placed in
parallel with a master and slave; this requires the TRI pin (pin 3) of
the master unit to be connected to the SNS RTN pin (pin 9).
When paralleled, 76% of the total combined power ratings of the
MFL converters are available at the load. Overload and short circuit
performance are not adversely affected during parallel operation.
DC/DC C
ONVERTERS
28 V
OLT
I
NPUT
MFL SERIES
65 WATT
F
EATURES
–55° to +125°C operation
16 to 40 VDC input
Fully Isolated
Magnetic feedback
Fixed frequency, 600 kHz typical
Topology – Single Ended Forward
50 V for up to 50 ms transient protection
Inhibit (input & output side)
Sync function (in and out)
Output trim on single output models
Indefinite short circuit protection
Remote sense on single output models
Up to 87% efficiency / 43 W/in
3
Parallelable up to 148 watts
相關PDF資料 |
PDF描述 |
|---|---|
| MFL2812D | DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2812S | DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2815D | DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2815S | DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2828S | DC/DC CONVERTERS 28 VOLT INPUT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MFL2805S/883 | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2805S/ES | 制造商:CRANE 制造商全稱:CRANE 功能描述:MFL Single and Dual DC/DC Converters |
| MFL2812D | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 28 VOLT INPUT |
| MFL2812D/883 | 制造商:CRANE 制造商全稱:CRANE 功能描述:MFL Single and Dual DC/DC Converters |
| MFL2812D/ES | 制造商:CRANE 制造商全稱:CRANE 功能描述:MFL Single and Dual DC/DC Converters |
發布緊急采購，3分鐘左右您將得到回復。