- 您現在的位置：買賣IC網 > PDF目錄371129 > MOC3051 (MOTOROLA INC) 6-Pin DIP Random-Phase Optoisolators Triac Drivers PDF資料下載
參數資料
| 型號： | MOC3051 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 光電耦合器 |
| 英文描述： | 6-Pin DIP Random-Phase Optoisolators Triac Drivers |
| 中文描述： | 1 CHANNEL TRIAC OUTPUT OPTOCOUPLER |
| 封裝： | PLASTIC, DIP-6 |
| 文件頁數： | 5/8頁 |
| 文件大小： | 329K |
| 代理商： | MOC3051 |
5
Motorola Optoelectronics Device Data
TYPICAL ELECTRICAL CHARACTERISTICS
TA = 25
°
C
Figure 9. Delay Time, t(d), and Fall Time, t(f),
versus LED Trigger Current
IFT, LED TRIGGER CURRENT (mA)
100
0.1
10
20
30
40
50
60
10
t
s
μ
1
t(f)
t(d)
t(delay), t(f) versus IFT
The triac driver’s turn on switching speed consists of a turn
on delay time t(d) and a fall time t(f). Figure 9 shows that the
delay time depends on the LED trigger current, while the ac-
tual trigger transition time t(f) stays constant with about one
micro second.
The delay time is important in very short pulsed operation
because it demands a higher trigger current at very short trig-
ger pulses. This dependency is shown in the graph IFT ver-
sus LED PW.
The turn on transition time t(f) combined with the power
triac’s turn on time is important to the power dissipation of
this device.
Switching Time Test Circuit
1. The mercury wetted relay provides a high speed repeated
pulse to the D.U.T.
2. 100x scope probes are used, to allow high speeds and
voltages.
3. The worst–case condition for static dv/dt is established by
triggering the D.U.T. with a normal LED input current, then
removing the current. The variable RTEST allows the dv/dt to
be gradually increased until the D.U.T. continues to trigger in
response to the applied voltage pulse, even after the LED
current has been removed. The dv/dt is then decreased until
the D.U.T. stops triggering.
τ
RC is measured at this point and
recorded.
Figure 10. Static dv/dt Test Circuit
+400
Vdc
PULSE
INPUT
RTEST
CTEST
R = 1 k
MERCURY
WETTED
RELAY
D.U.T.
X100
SCOPE
PROBE
APPLIED VOLTAGE
WAVEFORM
Vmax = 400 V
dv/dt =
0.63 Vmax
τ
RC
252
τ
RC
=
τ
RC
252 V
0 VOLTS
SCOPE
IFT
VTM
t(d)
t(f)
ZERO CROSS
DETECTOR
EXT. SYNC
Vout
FUNCTION
GENERATOR
PHASE CTRL.
PW CTRL.
PERIOD CTRL.
Vo AMPL. CTRL.
IFT
VTM
10 k
DUT
100
ISOL. TRANSF.
AC
115 VAC
相關PDF資料 |
PDF描述 |
|---|---|
| MOC3052 | 6-Pin DIP Random-Phase Optoisolators Triac Drivers |
| MOC3052TV-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052SR2-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052S-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MOC3051FM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FR2M | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FR2VM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FVM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051M | 功能描述:三極與 SCR 輸出光電耦合器 DIP-6 OPTO TRIAC RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。