- 您現在的位置：買賣IC網 > PDF目錄98027 > MPC92469AC (INTEGRATED DEVICE TECHNOLOGY INC) 400 MHz, OTHER CLOCK GENERATOR, PQFP32 PDF資料下載
參數資料
| 型號： | MPC92469AC |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 400 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| 封裝： | LEAD FREE, LQFP-32 |
| 文件頁數： | 1/12頁 |
| 文件大小： | 907K |
| 代理商： | MPC92469AC |
MPC92469
IDT / ICS PECL CLOCK SYNTHESIZER W/SPREAD SPECTRUM
1
MPC92469REV 4 JANUARY 23, 2007
400 MHz Low Voltage PECL
Clock Synthesizer w/Spread
Spectrum
The MPC92469 is a 3.3 V compatible, PLL based clock synthesizer targeted
for high performance clock generation in mid-range to high-performance tele-
com, networking and computing applications. With output frequencies from
25 MHz to 400 MHz and the support of differential PECL output signals the
device meets the needs of the most demanding clock applications.
Features
25 MHz to 400 MHz synthesized clock output signal
Differential PECL output
LVCMOS compatible control inputs
On-chip crystal oscillator for reference frequency generation
Spread Spectrum output for EMI reduction
3.3 V power supply
Fully integrated PLL
Minimal frequency overshoot
Serial 3-wire programming interface
Parallel programming interface for power-up
32-lead LQFP packaging
32-lead Pb-free package available
SiGe Technology
Ambient temperature range 0
°C to +70°C
Pin compatible to the MC12429, MPC9229, MPC92429, and ICS84329
Functional Description
The internal crystal oscillator uses the external quartz crystal as the basis of its frequency reference. The frequency of the
internal crystal oscillator is divided by 16 and then multiplied by the PLL. The VCO within the PLL operates over a range of 400
to 800 MHz. Its output is scaled by a divider that is configured by either the serial or parallel interfaces. The crystal oscillator
frequency fXTAL, the PLL feedback-divider M and the PLL post-divider N determine the output frequency.
The feedback path of the PLL is internal. The PLL adjusts the VCO output frequency to be 2
M times the reference frequency
by adjusting the VCO control voltage. Note that for some values of M (either too high or too low) the PLL will not achieve phase
lock. The PLL will be stable if the VCO frequency is within the specified VCO frequency range (400 to 800 MHz). The M-value
must be programmed by the serial or parallel interface.
The PLL post-divider N is configured through either the serial or the parallel interfaces, and can provide one of four division
ratios (1, 2, 4, or 8). This divider extends performance of the part while providing a 50% duty cycle. The output driver is driven
differentially from the output divider, and is capable of driving a pair of transmission lines terminated 50
to VCC – 2.0 V. The
positive supply voltage for the internal PLL is separated from the power supply for the core logic and output drivers to minimize
noise induced jitter.
The configuration logic has two sections: serial and parallel. The parallel interface uses the values at the M[8:0] and N[1:0]
inputs to configure the internal counters. It is recommended on system reset to hold the P_LOAD input LOW until power becomes
valid. On the LOW-to-HIGH transition of P_LOAD, the parallel inputs are captured. The parallel interface has priority over the
serial interface. Internal pullup resistors are provided on the M[8:0] and N[1:0] inputs prevent the LVCMOS compatible control
inputs from floating.
The serial interface centers on a eighteen bit shift register. The shift register shifts once per rising edge of the S_CLOCK input.
The serial input S_DATA must meet setup and hold timing as specified in the AC Characteristics section of this document. The
configuration latches will capture the value of the shift register on the HIGH-to-LOW edge of the S_LOAD input. See PROGRAM-
MING INTERFACE for more information. The TEST output reflects various internal node values, and is controlled by the T[2:0]
bits in the serial data stream. In order to minimize the PLL jitter, it is recommended to avoid active signal on the TEST output.
400 MHz LOW VOLTAGE
CLOCK SYNTHESIZER
w/SPREAD SPECTRUM
FA SUFFIX
32-LEAD LQFP PACKAGE
CASE 873A-03
AC SUFFIX
32-LEAD LQFP PACKAGE
Pb-FREE PACKAGE
CASE 873A-03
相關PDF資料 |
PDF描述 |
|---|---|
| MPC92474FA | 700 MHz, OTHER CLOCK GENERATOR, PQFP48 |
| MPC972FA | 125 MHz, PROC SPECIFIC CLOCK GENERATOR, PQFP52 |
| MPC9772FA | 230 MHz, OTHER CLOCK GENERATOR, PQFP52 |
| MPC9865VM | 200 MHz, OTHER CLOCK GENERATOR, PBGA100 |
| MPC9865VF | 200 MHz, OTHER CLOCK GENERATOR, PBGA100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC92469ACR2 | 功能描述:IC SYNTHESIZER LVPECL 32-LQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
| MPC9259 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:900 MHz LOW VOLTAGE LVDS CLOCK SYNTHESIZER |
| MPC9259D | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:900 MHz LOW VOLTAGE LVDS CLOCK SYNTHESIZER |
| MPC9259FA | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:900 MHz LOW VOLTAGE LVDS CLOCK SYNTHESIZER |
| MPC926508SD | 功能描述:IC NETWORKING CLK SOURCE 20-SSOP RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。