- 您現在的位置：買賣IC網 > PDF目錄361091 > NCP1381 (ON SEMICONDUCTOR) Low−Standby High Performance PWM Controller PDF資料下載
參數資料
| 型號： | NCP1381 |
| 廠商： | ON SEMICONDUCTOR |
| 英文描述： | Low−Standby High Performance PWM Controller |
| 文件頁數： | 20/26頁 |
| 文件大小： | 559K |
| 代理商： | NCP1381 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁
NCP1381
http://onsemi.com
20
+
IN
Current
V(CMP)
P
Spice
:
EB
load
Value
Figure 30. A Simple Simulation Configuration Helps to Tailor the Right Value for C
fil
+B1
Voltage
2
3
V
(line)
V
(timing)
B
load
3
35
V(bulk)
: 0
IF (V(CMP)
3,
V(35
+
+
+
+
C
fil
220 n
R
upper
R
lower
Bulk
Line
Timing
V2
V1
C
bulk
47 F
I
C
= 40
TiCMP
P
Spice
:
EB
brown
Value
{IF (V(CMP)
3, 250 m, 0)}
V
(CMP)
3 250 m : 500 m
B
brown
Voltage
5
Brown Out
Bulk
V
load
V1 Timing 0 PWL 0 0.2 3s 1 7s 1 10s 0.2
V2 Line 0 SIN 150 50
Figure 31. Typical Signals Obtained from the Simulator
0
4
8
12
16
200
100
0
100
200
8.156
8.175
8.195
8.215
8.235
Turnoff Voltage Occurs at:
V
inRMS
= 72.3 V
V
brownout
Brownout internal circuit
Given the low startup current and the weak overall consumption of the controller, a circuit needs to be found in order to create
a hiccup mode when there is not enough mains detected on Pin 2. Figure 32 portrays the solution based on a 1mA current
source, solely activated when the V
CC
is going low and the BOK has not authorized the controller to pulse. This 1 mA actually
discharges the V
CC
capacitor to make V
CC
reach 10 V. At this point, the source goes to zero and the startup resistor replenishes
the V
CC
capacitor. When we reach 15 V, the logic checks whether the BOK gives the green light. If not, V
CC
goes low via the
1 mA. The logic arrangement is made in such a way that if the mains comes back asynchronously to V
CC
(e.g. in the downslope
or in the upslope), we always restart at V
CC
= 15 V. Figure 33 shows a simulated behavior with a mains going up and down.
Figure 34 and 35 confirm the good restart synchronization with the 15 V level.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1381DR2G | Low−Standby High Performance PWM Controller |
| NCP1395APG | High Performance Resonant Mode Controller |
| NCP1395ADR2G | High Performance Resonant Mode Controller |
| NCP1395BDR2G | High Performance Resonant Mode Controller |
| NCP1395BPG | High Performance Resonant Mode Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1381 AM90 WAF | 制造商:ON Semiconductor 功能描述: |
| NCP1381ADAPEVB | 功能描述:BOARD EVAL NCP1381 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
| NCP1381DR2G | 功能描述:電流型 PWM 控制器 ANA PWM CONTROLLER RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1382DR2G | 功能描述:電流型 PWM 控制器 L-STNDBY PWM CNTRLR RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1392B | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High-Voltage Half-Bridge Driver with Inbuilt Oscillator |
發布緊急采購，3分鐘左右您將得到回復。