- 您現在的位置：買賣IC網 > Datasheet目錄62 > OPB804 (TT Electronics/Optek Technology)SENS OPTO SLOT 3.94MM TRANS THRU Datasheet資料下載
參數資料
| 型號： | OPB804 |
| 廠商： | TT Electronics/Optek Technology |
| 文件頁數： | 2/3頁 |
| 文件大小： | 147K |
| 描述： | SENS OPTO SLOT 3.94MM TRANS THRU |
| 產品培訓模塊： | Slotted Switches |
| 標準包裝： | 1 |
| 檢測距離： | 0.155"（3.94mm） |
| 檢測方法： | 可傳導的 |
| 輸出配置： | 光電晶體管 |
| 電流 - DC 正向(If)： | 50mA |
| 電流 - 集電極 (Ic)（最大）： | 30mA |
| 電壓 - 集電極發射極擊穿（最大）： | 30V |
| 安裝類型： | 通孔 |
| 封裝/外殼： | PCB 安裝 |
| 包裝： | 散裝 |
| 類型： | 無放大 |
| 工作溫度： | -40°C ~ 85°C |
| 產品目錄頁面： | 2788 (CN2011-ZH PDF) |
| 其它名稱： | 365-1017 |
OPTEK Technology Inc. 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue B 06/2012
Page 2 of 3
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Slotted Optical Switch
OPB804
Electrical Characteristics ( T
A
= 25癈 )
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode (see OP140 or OP240 for additional information)
V
F
Forward Voltage
- 1.25 1.70 V I
F
= 20 mA
I
R
Reverse Current
- - - - Not designed for reverse operation
Output Phototransistor (see OP550 for additional information)
V
(BR)CEO
Collector-Emitter Breakdown Voltage 30 - - V I
C
= 1 mA, E
E
= 0 mw/cm
2
V
(BR)ECO
Emitter-Collector Breakdown Voltage 5.0 - - V I
E
= 100 礎, E
E
= 0 mw/cm
2
I
CEO
Collector Dark Current
- - 100 nA V
CE
= 10 V, I
F
= 0, E
E
= 0 mw/cm
2
Coupled
V
CE(SAT)
Collector-Emitter Saturation Voltage - - 0.40 V I
C
= 250 礎, I
F
= 20 mA
I
C(ON)
On-State Collector Current
0.5 5 - mA V
CE
= 10 V, I
F
= 20 mA
Absolute Maximum Ratings
Storage Temperature Range
-40癈 to +100?C
Operating Temperature Range
-40癈 to +85?C
Lead Soldering Temperature
260?C
( 5)
Input Diode
Input Diode Power Dissipation
75 mW
( 7)
Input Diode Forward D.C. Current, T
A
= 25癈
50 mA
( 7)
Input Diode Peak Forward Pulse Current, T
A
= 25癈 (1祍 pulse width, 300pps)
1 A
Phototransistor
Power Dissipation
100 mW
( 7)
Collector - Emitter Voltage
30V
Emitter - Collector Voltage
5.0V
Notes:
(1) Dot indicates # 3 collector lead side.
(2) Feature controlled at body.
(3) Cathode lead may be shorter.
(4) RMA flux recommended. Highly activated water soluble fluxes may attack plastic. Recommend trial to verify application.
(5) Maximum lead soldering temperature .060 [1.6mm] from case for 5 seconds with soldering iron.
(6) Plastic is soluble in chlorinated hydrocarbons and ketones. Methanol or isopropanol are recommended as cleaning agents.
(7) Derate linearly 1.67 mW/癈 above 25?C.
(8) All parameters tested using pulse techniques.
(9) Do not connect input diode directly to a voltage source without an external current limiting resistor.
(10) Do not apply reverse voltage to LED. LED will be a 0V in reverse voltage and draw current as if a short.
相關PDF資料 |
PDF描述 |
|---|---|
| OPB806 | SENS OPTO SLOT 3.18MM TRANS THRU |
| OPB815W | SENS OPTO SLOT 9.53MM TRANS C-MT |
| OPB821S5Z | SENS OPTO SLOT 2.03MM TRANS C-MT |
| OPB821TXV | SENS OPTO SLOT 2.03MM TRANS C-MT |
| OPB825B | SENS OPTO SLOT 4.06MM TRANS THRU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPB804 | 制造商:TT Electronics / OPTEK Technology 功能描述:OPTO SWITCH SLOTTED |
| OPB806 | 功能描述:光學開關（透射型，光電晶體管輸出） Slotted Opt Switch RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| OPB806_05 | 制造商:OPTEK 制造商全稱:OPTEK 功能描述:Slotted Optical Switch |
| OPB810L | 制造商:OPTEK 制造商全稱:OPTEK 功能描述:WIDE GAP SLOTTED OPTICAL SWITCHES |
| OPB810L51 | 功能描述:光學開關（透射型，光電晶體管輸出） .375" WIDE GAP 890NM RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
發布緊急采購，3分鐘左右您將得到回復。