- 您現在的位置：買賣IC網 > PDF目錄382379 > PCD3310A (NXP Semiconductors N.V.) Pulse and DTMF diallers with redial PDF資料下載
參數資料
| 型號： | PCD3310A |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Pulse and DTMF diallers with redial |
| 中文描述： | 脈沖和DTMF撥號器與重撥 |
| 文件頁數： | 9/28頁 |
| 文件大小： | 145K |
| 代理商： | PCD3310A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
1996 Nov 21
9
Philips Semiconductors
Product specification
Pulse and DTMF diallers with redial
PCD3310; PCD3310A
7.6
Flash duration control (FLD)
Flash (or register recall) is activated by the FL key and can
be used in DTMF and pulse dialling modes.
The FL key has the same effect as placing the telephone
‘on-hook’ for a calibrated time. Pressing the FL key will
produce a timed line-break of 100 ms (min.) at the DP/FLO
output. During the conversation mode pressing FL also
acts as a chip enable. The flash pulse duration (t
FL
) is
calibrated and can be prolonged with an external resistor
and capacitor connected to the FLD input/output (see
Fig.5). The flash pulse resets the Read Address Counter
(RAC) to the address of the first entered digit of the last
number dialled. Subsequent redial is possible (see Fig.9).
The counter of the reset delay time is held for a period of
t
FL
.
7.7
TONE output (DTMF mode)
The single and dual tones which are provided at the TONE
output are filtered by an on-chip switched capacitor filter,
followed by an on-chip active RC low-pass filter. Hence,
the total harmonic distortion of the DTMF tones meets the
CEPT recommendations. The tone output has the
following states:
tone OFF; 3-state
tone ON; the associated frequencies are superimposed
on a DC level of
1
2
V
DD
.
When the DTMF mode is selected output tones are timed
in manual dialling with a minimum duration of bursts and
pauses, and in redial with a calibrated timing. Single tones
may be generated for test purposes (CE = HIGH). Each
row and column has one corresponding frequency.
High group frequencies are generated by connecting the
column to V
SS
and LOW group frequencies are generated
by forcing the row to V
DD
. The single tone frequency will be
transmitted during activation time, but it is neither
calibrated nor stored.
An on-chip reference voltage provides output tone levels
independent of the supply voltage. Table 3 shows the
frequency tolerance of the output tones for DTMF
signalling.
Fig.5 Flash pulse duration setting.
(a) Flash duration control circuit.
(b) Flash pulse timing. t
FLRC
≈
R
×
C.
ndbook, full pagewidth
MGE492
tFL
tFLRC
(a)
(b)
R
C
FLD
60
nA
FLO
相關PDF資料 |
PDF描述 |
|---|---|
| PCD3310AP | Pulse and DTMF diallers with redial |
| PCD3310AT | Pulse and DTMF diallers with redial |
| PCD3310P | Pulse and DTMF diallers with redial |
| PCD3310T | Pulse and DTMF diallers with redial |
| PCD3311 | DTMF/modem/musical-tone generators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCD3310AP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pulse and DTMF diallers with redial |
| PCD3310APN | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
| PCD3310AT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pulse and DTMF diallers with redial |
| PCD3310ATD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
| PCD3310ATD-T | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
發布緊急采購，3分鐘左右您將得到回復。