- 您現在的位置：買賣IC網 > PDF目錄382380 > PCD5042HZ (NXP SEMICONDUCTORS) DECT burst mode controller PDF資料下載
參數資料
| 型號： | PCD5042HZ |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | DECT burst mode controller |
| 中文描述： | TELECOM, CORDLESS, BURST MODE CONTROLLER, PQFP80 |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 134K |
| 代理商： | PCD5042HZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
1996 Oct 31
16
Philips Semiconductors
Objective specification
DECT burst mode controller
PCD5042
6.6
Microcontroller Interface
6.6.1
F
UNCTION OF THE MICROCONTROLLER INTERFACE
The microcontroller Interface will provide the following
services.
Direct interface to processors which have an
INTEL-8051 compatible interface
General interface to processors that can handle ‘wait
states’ e.g. 68000-family; in this case glue logic is
required
Processor clock signal of which the frequency is
programmable in order to adjust instantaneously
processor performance to processor work load
A programmable interrupt register
A watchdog timer with time-out periods of
1.25 or 82 seconds, depending on the programming.
The microcontroller can address the PCD5042 as any
other RAM memory connected to the microcontroller bus.
By writing the ‘Interface-Mode Register’, the
microcontroller can select the interface mode and its own
clock frequency.
6.6.2
M
ICROCONTROLLER INTERRUPTS
The function of microcontroller Interrupts is to make
optimal use of the microcontroller’s processing power, and
to achieve optimal cooperation between time-critical tasks
and less time-critical tasks both executed in software.
Three registers are available to handle interrupts. These
are:
Interrupt Event Register
Interrupt Enable Register
Interrupt Reset Register.
These registers are to be regarded together.
Corresponding bits in these registers relate to one and the
same event. Bits in the Interrupt Event Register are set by
the PCC and are to be reset by the external processor by
writing ‘1’s in the corresponding bits in the Interrupt Reset
Register. The mask in the Interrupt Enable Register
enables the interrupt if corresponding events do occur.
6.6.3
W
ATCHDOG
The PCD5042 is equipped with a watchdog timer, which
generates a reset towards an external device (e.g. a
μ
C)
after time-out. Two (fixed) time-out periods can be
programmed; 1.25 s and 82 s. The watchdog function can
be disabled by using the EN_WATCHDOG input pin.
6.6.4
P
OWER
-
DOWN
The PCC may switch off the 6.912 MHz internal clock, to
enter a power saving mode. All blocks, running on this
clock are then switched off (i.e. RF-interface, cipher block,
speech interface, PCC). This is called the power-down
state, and is only used in the handset mode.
The 13.824 MHz clock is never switched off. The Timing
Control, microcontroller interface, and Bus Controller keep
running, in order to remain synchronous with a base
station, and to keep the wake-up circuitry active. During
power-down the external microcontroller has still access to
the common data area.
6.7
Survey of registers
For a survey of all addresses occupied refer to
Tables 1 and 2. Some of the address locations are used
differently for read and write. The addresses 000 to 7DF
are occupied by RAM memory, while the upper 32 bytes
are assigned to the hardware registers. A part of the RAM
memory is allocated for use by the RF block, cipher block,
and the speech interface.
相關PDF資料 |
PDF描述 |
|---|---|
| PCD5042 | DECT burst mode controller |
| PCD5043 | DECT burst mode controller |
| PCD5043H | DECT burst mode controller |
| PCD5091HZ | DECT baseband controller |
| PCD5091 | DECT baseband controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCD5043 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller |
| PCD5043H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller |
| PCD5071 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MODEM |
| PCD5090 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT baseband controllers |
| PCD5090H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT baseband controllers |
發布緊急采購，3分鐘左右您將得到回復。