- 您現在的位置：買賣IC網 > PDF目錄367893 > PE2444BF-70.0M-XXX (Electronic Theatre Controls, Inc.) 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad PDF資料下載
參數資料
| 型號： | PE2444BF-70.0M-XXX |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| 中文描述： | 10墊無鉛表面貼裝時鐘振蕩器，見6Pad PE1145B |
| 文件頁數： | 1/1頁 |
| 文件大?。?/td> | 41K |
| 代理商： | PE2444BF-70.0M-XXX |
PE2245B PECL Series
10 Pad Leadless Surface Mount Clock Oscillator, see PE1145B for 6 Pad
10.00 MHz – 170.00 MHz
See PE1145T for
higher
frequencies
Standard Specifications
Overall Frequency Stability
Operating Temperature Range
Supply Voltage (Vcc)
Supply Current (Icc)
J itter
0 to +80
°
C is standard, but can be extended to
-
40 to +85
°
C for certain frequencies
3.3 volts ± 10% standard, but 5.0 volts or 2.5 volts also available
60 to 70 mA typical, 90 mA maximumfor 70 MHz.
For < 70 MHz, consult factory
3
1 pS RMS maximum
from12 kHz to 20 MHz fromcarrier
for
3
70 MHz.
For < 70 MHz, consult factory
Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.
Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load
Mechanical:
not to scale
inches (mm)
Output Waveform
PECL with Differential Output
(see Waveform2)
Logic “1”
Logic “0”
Vcc - 1.025 volts mnimum
Vcc - 1.620 volts maximum
Output Load
Enable/Disable Option (E/D)
(as applicable)
Output must be termnated into 50 ohms to (Vcc - 2.0 V). See Test Circuit 5 and Note 1.
Output enabled when E/D Pin is open or at CMOS Logic “1”;
Output disabled when E/D Pin is at CMOS Logic “0”.
Part Numbering Guide
Model
(Pinout Option)
PE20 PE23
PE21 PE24
PE22
Frequency Stability
45 = ± 50 PPM
44 = ± 25 PPM
20 = ± 20 PPM
Frequency in MHz
Special Specifications (choose all that apply)
E: Extended Operating Temperature Range (- 40 to +85 C)
F: 47.5 /52.5% Symmetry at 50% of Vcc
V: Supply Voltage of 3.3 volts
±
10%
W: Supply Voltage of 2.5 volts
± 5
%
Y: Supply Voltage of 5.0 volts
±
10%
PE22 45 B Y - 70.0M - XXX
(Internal Code or blank)
Symmetry
Tr & Tf
45/55% to 55/45% at 50% of Vcc level standard, tighter symmetry available
1.0 nS max (20 to 80%) for 70 MHz.
For < 70 MHz, consult factory
In the typical PECL 100K logic output Voh is 2.35 volts and Vol is 1.60 volts at 3.3 Vcc. The center voltage of the PECL is therefore1.975 volts.
If a 50 ohmresistor is placed between the output and Vcc – 2 volts (1.3 volts), the current through the resistor is (1.975 – 1.3) / 50 = 13.5 mA.
The same load can be simulated by a resistor of 147 ± 1% ohms to ground (1.975 / 0.0135 = 146.29 ohms). If additional load current is placed
on the output, its load current must be subtracted fromthe 13.5 mA to calculate a new load resistor. Using simlar calculations, use 274 ± 1%
ohms to ground for 5.0V operation.
(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com
Pl tronics, Inc.
± 50 PPM ± 25 PPM ± 20 PPM over Operating Temperature Range
Packaging
Tray or
24mmtape,
16mmpitch
Note 1:
Due to part size and factory abilities, part marking may vary fromlot to lot and may contain our part number or an internal code.
July 2002
Differential PECL Output with or without Enable/ Disable Function
All Connor-Winfield EE94-5XX Pinouts Available
.400 (10.16)
1
2
3
10 9
8
4
5
7
6
.
(
.05
(1.3)
.
.
.560 (14.23) MAX
Vcc
9
GND
Q
7
4
3
5
6
8
2
*
10
N.C.
1
PLE
.217 (5.5)
MAX
N.C.
N.C.
N.C.
*
N.C.
E/D
N.C.
QN
N.C. QN
Pin PE20 PE21 PE22 PE23 PE24
2
6
QN
N.C.
Option '0' '1' '2' '3' '4'
*
N.C.
N.C.
E/D
C-W
PE2245B Series Pinout Options
Connor-Winfield EE94-5XX Equivalents
Pl tronics
,
Inc.
19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
Portions of the part number that appear after the frequency may not be marked on part (C of C provided)
For Best Performance,
Do NOT allow any traces other than ground
under oscillators (Even in buried layers)
Solder Pads
相關PDF資料 |
PDF描述 |
|---|---|
| PE2420BF-70.0M-XXX | Box-shaped pin header, Discrete wire crimping connection, Discrete wire connectors; HRS No: 538-0059-7 00; No. of Positions: 20; Connector Type: Wire; Contact Gender: Female; Contact Spacing (mm): 1.25; Terminal Pitch (mm): 1.25; Current Rating(Amps)(Max.): 1; Operating Temperature Range (degrees C): -35 to 85; General Description: Housing; Single row; Crimping |
| PE2020 | 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2044 | 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2044BV-70.0M-XXX | 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2045 | 10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PE2444BV-70.0M-XXX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2444BW-70.0M-XXX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2444BY-70.0M-XXX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2445 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
| PE2445BE-70.0M-XXX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 Pad Leadless Surface Mount Clock Oscillator,see PE1145B for 6Pad |
發布緊急采購，3分鐘左右您將得到回復。