- 您現在的位置：買賣IC網 > PDF目錄367908 > PEX8114-AA13BI (Electronic Theatre Controls, Inc.) ExpressLane⑩ PCI Express-to-PCI/PCI-X Bridge PDF資料下載
參數資料
| 型號： | PEX8114-AA13BI |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | ExpressLane⑩ PCI Express-to-PCI/PCI-X Bridge |
| 中文描述： | 的ExpressLane⑩的PCI Express-to-PCI/PCI-X橋 |
| 文件頁數： | 1/4頁 |
| 文件大小： | 1705K |
| 代理商： | PEX8114-AA13BI |
ExpressLane PCI Express-to-PCI/PCI-X Bridge
.
Features
General Features
o
Forward and Reverse bridging
o
Reverse bridging root functions
o
Transparent and Non-transparent
bridging
o
Standard 256 Plastic BGA package
(17mm x 17mm)
o
Low power – 2W max.
o
No heat sink required
o
EEPROM configuration option
o
1.0 V core supply voltage
o
DC and AC JTAG (1149.1 and
1149.6)
Scalable PCI Express Interface
o
x4 Link (configurable as x1, x2 or x4)
o
Full-duplex PCI Express lanes;
2.5 Gbps each
o
Automatic lane reversal
o
8b/10b encoding
o
Link training (auto-negotiate to
smallest link width)
o
256 byte maximum payload size
o
PCI Express Base specification 1.0a
compliant
o
End-to-end CRC and data poisoning
o
Advanced error reporting
o
Link and device power management
o
Advanced flow control
o
Hot Plug
o
Turn off unused lanes for power
reduction
Advanced PCI-X Interface
o
PCI-X (v 1.0b): 64 bits at 133, 100 or
66 MHz
o
PCI 3.0: 32 or 64 bits at 66, 50, 33 or
25 MHz
o
8-outstanding split transactions
o
Internal arbiter supports up to 4
external masters
o
3.3V I/O
o
Message Signal Interrupt (MSI)
support
o
Provides up to four PCI/PCI-X clocks
o
Scratchpad and doorbell registers
Flexible, High-Performance Bridge in a Small Package
The PLX Technology ExpressLane PEX 8114 is a high performance bridge that
enables designers to migrate legacy PCI and PCI-X bus interfaces to the new
advanced serial PCI Express interface. This flexible device supports forward,
reverse and non-transparent bridging.
The bridge is equipped with a standard, but flexible PCI Express port that scales to
x1, x2 or x4 lanes with a maximum of 1 Gigabyte per second of throughput per
transmit and receive direction. With four 2.5 Gbps integrated SerDes, the standard
PCI Express signaling delivers the highest bandwidth with the lowest possible pin
count using LVDS technology.
The ExpressLane PEX 8114 has a single parallel bus segment supporting the
advanced PCI-X protocol, with a 64-bit wide parallel data path running at 133MHz.
The bridge also supports conventional PCI operation.
While both sides of the bridge are evenly matched, the device also supports internal
queues with flow control features to optimize throughput and traffic flow.
The small 17mm x 17mm footprint in standard Plastic BGA packaging makes the
ExpressLane PEX 8114 ideal for a variety of applications where board real estate is
at a premium.
Forward and Reverse Bridging
Compliant to the PCI Express-to-PCI/PCI-X Bridge Specification 1.0, the
ExpressLane PEX 8114 is capable of operating in either forward or reverse bridging
modes. In forward mode, the bridge allows legacy PCI or PCI-X chips and adapters
to be used with new PCI Express processor systems. Reverse bridge operation allows
conventional PCI or PCI-X processors and chipsets to configure and control
advanced PCI Express switches and endpoints. The reverse bridge not only allows
complete configuration of a downstream PCI Express system from the PCI/PCI-X
bus, but it also handles limited PCI Express root functions for reverse interrupt and
advanced error handling.
Non-Transparent Bridging
The ExpressLane PEX 8114 can be configured as a non-transparent bridge when
operating in forward mode. Non-transparent bridging is used to design intelligent I/O
and storage adapters as well as to enable multi-host systems. The non-transparency
features are implemented in the same fashion as conventional PCI-to-PCI bridge
applications.
Non-Transparent bridges allow systems to isolate CPU and memory spaces to
connect two independent address/processor domains. The bridge includes doorbell
registers to send interrupts from each side to the other and scratchpad registers
accessible from both sides for inter-processor communications.
High Performance PCI Express Interface
The fully integrated PCI Express interface incorporates many of the advanced
protocol features in PCI Express such as Automatic Lane Reversal, ECRC, Data
Poisoning, Link State Power Management and Hot Plug. The single link scales from
x4 to x2 or x1 operation through configuration or automatic link training. This
enables the user to reduce power consumption by turning off unused lanes.
PEX 8114
Version 2.1 2004
相關PDF資料 |
PDF描述 |
|---|---|
| PEX8533-AA25BI | Flexible & Versatile PCI Express⑩ Switch |
| PEX8533 | Flexible & Versatile PCI Express⑩ Switch |
| PEX8533-AA25BIG | Flexible & Versatile PCI Express⑩ Switch |
| PEX8533-AARDK | Flexible & Versatile PCI Express⑩ Switch |
| PEX8547 | PCI Express⑩ Switch for Graphics Fan-Out |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PEX8114-AA13BIG | 制造商:PLX Technology 功能描述: |
| PEX8114-BA13BIG | 功能描述:外圍驅動器與原件 - PCI ExpressLane PCI to X Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PEX8114-BC13BI | 功能描述:接口 - 專用 4 Lane PCI Express to PCI-X Bridge RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| PEX8114-BC13BI G | 功能描述:PCI-to-PCI Bridge Interface 256-BGA (17x17) 制造商:broadcom limited 系列:ExpressLane? 包裝:托盤 零件狀態:在售 應用:PCI 至 PCI 橋 接口:PCI 電壓 - 電源:3.3V 封裝/外殼:- 供應商器件封裝:256-BGA（17x17） 安裝類型:表面貼裝 標準包裝:450 |
| PEX8114-BC13BIG | 功能描述:外圍驅動器與原件 - PCI 4 Lane PCI Express to PCI-X Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。