
PS10/PS11
1
Quad Power Sequencing Controller
Features
Sequencing of Four or More* Supplies, ICs, or Sub-
systems
Independently Programmable Delays Between Open
Drain PWRGD Flags (5ms to 200ms)
±10V to ±90V Operation
Tracking in Combination with Schottky Diodes
Input Supervisors Including:
o
UV/OV Lock Out/Enable
o
Power-On-Reset (POR)
Low Power Consumption, 0.4mA Supply Current
Small SO-14 Package
*By Daisy-Chaining PS10/11’s
Applications
Power Supply Sequencing
-48V Telecom and Networking Distributed Systems
-24V Cellular and Fixed Wireless Systems
-24V PBX Systems
+48V Storage Systems
FPGA, Microprocessor Tracking
Industrial/Embedded System Timing/Sequencing
High Voltage MEMs Driver’s Supply Sequencing
High Voltage Display Driver’s Supply Sequencing
Description
Many of today’s high performance FPGA’s, Microproces-
sors, DSP and industrial/embedded subsystems require
sequencing of the input power. Historically this has been
accomplished: i) discretely using comparators, references
& RC circuits; ii) using expensive programmable control-
lers; or iii) with low voltage sequencers requiring resistor
drop downs and several high voltage optocoupler or level
shift components.
The PS10/11 saves board space, improves accuracy,
eliminates optocouplers or level shifts and reduces overall
component count by combining four timers, programmable
input UV/OV supervisors, a programmable POR and four
90V open drain outputs. A high reliability, high voltage,
junction isolated process allows the PS10/11 to be con-
nected directly across the high voltage input rails.
The power-on-reset interval (POR) may be programmed
by a capacitor on Cramp. To sequence additional sys-
tems, PS10/11 may be daisy chained together. If at any
time the input supply falls outside the UV/OV detector
range the PWRGD outputs will immediately become IN-
ACTIVE. Down sequencing may be accomplished with
additional components (see page 11).
The PS10/PS11 is available in a space saving SO-14
package.
PS10 - Active High
PS11 - Active Low
A051204
Relative to Negative Rail
Typical Application Circuit
Waveform
(49.9k pull-up on PS11 PWRGD pins)
Initial Release
RTB
9.76K
6.81K
487K
RTD
RTC
/EN
DC/DC
CONVERTER
DC/DC
CONVERTER
DC/DC
CONVERTER
/EN
DC/DC
CONVERTER
TB
OV
UV
V
/EN
TC
PWRGD-C / PWRGD-C
PWRGD-D / PWRGD-D
TD
PWRGD-A / PWRGD-A
PWRGD-B / PWRGD-B
COM
+2.5V
+3.3V
+5V
+12V
PS10/PS11
COM
-48V or GND
GND or +48V
Notes:
1. Under Voltage Shutdown (UV) set to 37V.
2. Over Voltage Shutdown (OV) to 57.8V.
10nF
Ramp
V
13
10
4
3
2
1
14
6
5
7
11
12
EE
IN
Supertex, Inc. 1235 Bordeaux Drive, Sunnyvale, CA 94089 Tel: (408) 222-8888 FAX: (408) 222-4895 www.supertex.com