- 您現在的位置：買賣IC網 > PDF目錄376316 > RT9167A-29CS (Electronic Theatre Controls, Inc.) INDUCTOR, 470UHINDUCTOR, 470UH; Inductance:470uH; Inductor type:Inductor; Current, DC max:0.64A; Resistance:0.16R; Case style:D; Diameter, PCB hole:0.64mm; Flammability rating:UL94V-0 PDF資料下載
參數資料
| 型號： | RT9167A-29CS |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | INDUCTOR, 470UHINDUCTOR, 470UH; Inductance:470uH; Inductor type:Inductor; Current, DC max:0.64A; Resistance:0.16R; Case style:D; Diameter, PCB hole:0.64mm; Flammability rating:UL94V-0 |
| 中文描述： | 低噪聲固定輸出電壓200MA/500MA LDO穩壓器 |
| 文件頁數： | 9/14頁 |
| 文件大小： | 257K |
| 代理商： | RT9167A-29CS |
RT9167/A
DS9167/A-10 July 2001
www.richtek-ic.com.tw
9
Load-Transient Considerations
The RT9167/A load-transient response graphs (see
Typical
Operating
Characteristics)
components of the output response: a DC shift from
the output impedance due to the load current
change, and the transient response. The DC shift is
quite small due to the excellent load regulation of the
IC. Typical output voltage transient spike for a step
change in the load current from 0mA to 50mA is tens
mV, depending on the ESR of the output capacitor.
Increasing the
output
decreasing the ESR attenuates the overshoot.
show
two
capacitor’s
value
and
Shutdown Input Operation
The RT9167/A is shutdown by pulling the SHDN
input low, and turned on by driving the input high. If
this feature is not to be used, the SHDN input should
be tied to VIN to keep the regulator on at all times
(the SHDN input must
not
be left floating).
To ensure proper operation, the signal source used to
drive the SHDN input must be able to swing above and
below the specified turn-on/turn-off voltage thresholds
which guarantee an ON or OFF state (see Electrical
Characteristics). The ON/OFF signal may come from
either CMOS output, or an open-collector output with
pull-up resistor to the RT9167/A input voltage or
another logic supply. The high-level voltage may
exceed the RT9167/A input voltage, but must remain
within the absolute maximum ratings for the SHDN pin.
Internal P-Channel Pass Transistor
The RT9167/A features a typical 1.1
P-channel
MOSFET
pass
transistor.
advantages over similar designs using PNP pass
transistors, including longer battery life. The P-channel
MOSFET requires no base drive, which reduces
quiescent current considerably. PNP-based regulators
waste considerable current in dropout when the pass
transistor saturates. They also use high base-drive
currents under large loads. The RT9167/A does not
suffer from these problems and consume only 80
μ
A of
quiescent current whether in dropout, light-load, or
heavy-load applications.
It
provides
several
Input-Output (Dropout) Voltage
A
differential (or dropout voltage) determines the
lowest usable supply voltage. In battery-powered
systems, this will determine the useful end-of-life
battery voltage. Because the RT9167/A uses a P-
channel MOSFET pass transistor, the dropout
voltage is a function of drain-to-source on-resistance
[R
DS(ON)
] multiplied by the load current.
regulator’s
minimum
input-output
voltage
Reverse Current Path
The power transistor used in the RT9167/A has an
inherent diode connected between the regulator
input and output (see Fig.3). If the output is forced
above the input by more than a diode-drop, this
diode will become forward biased and current will
flow from the V
OUT
terminal to V
IN
. This diode will
also be turned on by abruptly stepping the input
voltage to a value below the output voltage. To
prevent regulator mis-operation, a Schottky diode
should be used in any applications where
input/output voltage conditions can cause the
internal diode to be turned on (see Fig.4). As shown,
the Schottky diode is connected in parallel with the
internal parasitic diode and prevents it from being
turned on by limiting the voltage drop across it to
about 0.3V. < 100 mA to prevent damage to the part.
10.0
15.0
0
5.0
C
BP
= 10nF
Time (ms)
Fig. 2
C
BP
= 1nF
V
V
OUT
= 3.0V
相關PDF資料 |
PDF描述 |
|---|---|
| RT9167A-34CB | LOW NOISE FIXED OUTPUT VOLTAGE 200MA/500MA LDO REGULATOR |
| RT9167A-34CBR | BOARD DAUGHTER ICEPIC3 |
| RT9167A-34CS | LOW NOISE FIXED OUTPUT VOLTAGE 200MA/500MA LDO REGULATOR |
| RT9167A-37CB | IC ENCODER TRANSMITTER RF 8DIP |
| RT9167A-37CBR | LOW NOISE FIXED OUTPUT VOLTAGE 200MA/500MA LDO REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RT9167A-2HGB | 功能描述:IC REG LDO 2.85V .5A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 6V 電壓 - 壓降（標準）:0.08V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:LP3988IMFX-3.3 |
| RT9167A-2HGBR | 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Low-Noise, Fixed Output Voltage,300mA/500mA LDO Regulator |
| RT9167A-2HGS | 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Low-Noise, Fixed Output Voltage,300mA/500mA LDO Regulator |
| RT9167A-2HPB | 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Low-Noise, Fixed Output Voltage,300mA/500mA LDO Regulator |
| RT9167A-2HPBR | 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Low-Noise, Fixed Output Voltage,300mA/500mA LDO Regulator |
發布緊急采購，3分鐘左右您將得到回復。