
RF Monolithics, Inc.
RFM Europe
2001 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF1092A-100605
Page 1 of 9
Electrical Characteristics
Characteristic
Sym
f
C
IL
BW
1
Notes
1
Min
Typ
Max
Units
MHz
dB
kHz
dB
P-P
ns
P-P
dB
Nominal Center Frequency
Passband
199.000
5.5
±140
Insertion Loss at fc
1 dB Passband
7.0
1, 2
±100
Amplitude Ripple over fc±100 kHz
Group Delay Variation over fc ±100 kHz
fc-800 to fc-600 and fc+600 to fc+800 kHz
119 MHz to fc-800 kHz
fc+800 kHz to 278 MHz
1.0
GDV
300
500
Rejection
1, 2, 3
35
45
45
Operating Temperature Range
Frequency Temperature Coefficient
T
A
FTC
1
1
-10
+85
°C
0.32
ppm/°C
2
SMP-75
Designed for GSM BTS Receiver IF Applications
Low Insertion Loss
Excellent Size-to-Performance Ratio
Hermetic SMP-75 Surface-Mount Case
Unbalanced Input and Output
Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Value
+18
30
-40 to +85
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Suitable for lead-free soldering - Max. Soldering Profile
260°C for 30 s
199 MHz
SAW Filter
SF1092A
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter
soldered to the specified demonstration board with impedance matching to 50
and measured
with 50
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center fre-
quency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection
in final user application is dependent on PCB layout and external impedance matching design.
See Application Note No. 42 for details.
The turnover temperature, T
O
, is the temperature of maximum (or turnover) frequency, f
o
. The
nominal frequency at any case temperature, T
c
, may be calculated from: f=f
o
[1-FTC(T
o
-T
c
)
2
].
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, imped-
ances and impedance matching may vary between Port 1 and Port 2, so that the filter must
always be installed in one direction per the circuit design.
US and international patents may apply.
Electrostatic Sensitive Device. Observe precautions for handling.
2.
3.
4.
5.
6.
7.
8.
Connection
Port 1 Hot
Port 1 Gnd Return
Port 2 Hot
Port 2 Gnd Return
Case Ground
Terminals
10
1
5
6
All others
Electrical Connections
Impedance Matching to 50
unbalanced
Case Style
Lid Symbolization (YY = year, WW = week)
External L-C
SMP-75 19 x 6.5 mm Nominal Footprint
RFM SF1092A YYWW
Pb