- 您現在的位置：買賣IC網 > PDF目錄384921 > SMFL (INTERPION SEMICONDUCTOR CO.,LTD.) Single and Dual DC/DC Converters PDF資料下載
參數資料
| 型號： | SMFL |
| 廠商： | INTERPION SEMICONDUCTOR CO.,LTD. |
| 英文描述： | Single and Dual DC/DC Converters |
| 中文描述： | 單和雙DC / DC轉換器 |
| 文件頁數： | 1/13頁 |
| 文件大小： | 475K |
| 代理商： | SMFL |
description
The SMFL Series 28-volt DC/DC converters are rated up to 65 watts
output power over a -55° to +125°C temperature range with a 28 Vdc
nominal input. On dual output models up to 70% of the rated output
power can be drawn from either the positive or negative outputs. Current
sharing allows the units to be paralleled for total power of up to 148
watts. The welded, hermetically sealed package is only 3.0 x 1.5 x 0.40
inches, giving the series an overall power density of up to 45 watts per
cubic inch.
S
creening
SMFL converters offer the following screening options: Space Prototype
(O), Class H, or Class K. Radiation tolerant to Radiation Hardness
Assurance (RHA) levels of “-” (O) or “R”, per MIL-STD-38534. Interpoint
model numbers use an “O” in the RHA designator position to indicate the
“-” (dash) Radiation Hardness Assurance level of MIL-PRF-38534, which
is defined as “no RHA”. See “Class H and K, QML Screening” tables for
more information.
D
eSign
F
eatureS
SMFL Series converters are switching regulators that use a quasi-square
wave, single ended forward converter design with a constant switching
frequency of 600 kHz typical.
Isolation between input and output circuits is provided with a transformer
in the forward path and a wide bandwidth magnetic coupling in the feed-
back control loop. The SMFL uses a unique dual loop feedback technique
that controls output current with an inner feedback loop and an output
voltage with a cascaded voltage mode feedback loop. The additional
secondary current mode feedback loop improves transient response in
a manner similar to primary current mode control and allows for ease of
paralleling, but without the cost and complexity.
The constant frequency, pulse-width modulated converters use a quasi-
square wave single-ended forward design. Tight load regulation is
achieved through a wide-bandwidth magnetic feedback circuit. The output
voltage on single SMFL models can be trimmed to a specific output
voltage by adding an external resistor.
i
nhibit
The SMFL Series converters have two TTL compatible inhibit terminals
(INH1 and INH2) that can be used to disable power conversion, resulting
in a very low quiescent input current and no generation of switching
noise. An open collector TTL compatible low (<0.8 volts) is required to
inhibit the converter between INH1 (pin 4) and Input Common (pin 2). An
open collector TTL compatible low (<0.5 volts) is required to inhibit the
converter between INH2 (pin 12) and Output Common (pin 8). The appli-
cation of intermediate voltages to these pins (1.5 to 10.5 volts) should be
avoided.
S
ync
Converters may be synced to an external clock (525 to 675 kHz) or
to one another by using the sync in or out pins. The nominal free-run
switching frequency is 600 kHz.
c
urrent
anD
P
arallel
O
PeratiOn
Multiple single output SMFL converters may be used in parallel to drive a
common load. In this mode of operation the load current is shared by two
or three SMFL converters. In current sharing mode, one SMFL converter
is designated as a master. The SLAVE pin (pin 11) of the master is left
unconnected and the MSTR/INH2 pin (pin 12) of the master is connected
to the SLAVE pin (pin 11) of the slave units. The units designated as
slaves have the MSTR/INH2 pin (pin 12) connected to the SNS RTN
pin (pin 9). Note that synchronizing the units together is not required for
current sharing operation. A second slave unit may be placed in parallel
with a master and slave; this requires the TRI pin (pin 3) of the master
unit to be connected to the SNS RTN pin (pin 9). See Figure 2 for a block
diagram of parallel connections.
When paralleled, 76% of the total combined power ratings of the SMFL
converters are available at the load. Overload and short circuit perfor-
mance are not adversely affected during parallel operation.
Features
Fully qualified to Class H or K
–55° to +125°C operation
16 to 40 VDC input
Fully Isolated
Magnetic feedback
Fixed frequency, 600 kHz typical
Topology – Single Ended Forward
50 V for up to 120 ms transient protection
Inhibit input side and output side
Sync function
Output trim on single output models
Indefinite short circuit protection
Remote sense on single output models
Up to 85% efficiency / 43 W/in
3
Parallelable up to 148 watts
MODELS
VDc O
utPut
SINgLE
3.3
5
12
15
DUAL
±5
±12
±15
Crane Aerospace & Electronics Power Solutions
sMFL single and dual dc/dc converters
Crane Aerospace & Electronics
Electronics group (Interpoint Brand)
PO Box 97005 Redmond WA 98073-9705
425.882.3100 electronics@craneae.com
www.craneae.com
Page 1 of 13
Rev H - 20061102
28 VoLt input – 65 Watt
相關PDF資料 |
PDF描述 |
|---|---|
| SMH4802 | Programmable -48V Hot-Swap Controller with Forced Shut Down |
| SMH4803A | Distributed Power Hot Swap Controller |
| SMH4803AS | Distributed Power Hot Swap Controller |
| SMH4804 | -48V Programmable Hot Swap Sequencing Power Controller |
| SMH4812 | Distributed Power Hot-Swap Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SMFL200D | 制造商:Electrolube 功能描述:FLUX SOLDER REWORK 制造商:Electrolube 功能描述:FLUX, SOLDER, REWORK |
| SMFL2805D | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:Operating temperature -55° to +125°C Qualified to MIL-PRF-38534 Class H and K |
| SMFL2805D/HO | 制造商:INTERPION 制造商全稱:INTERPION 功能描述:Single and Dual DC/DC Converters |
| SMFL2805D/KR | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 28 VOLT INPUT |
| SMFL2805S | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:Operating temperature -55° to +125°C Qualified to MIL-PRF-38534 Class H and K |
發布緊急采購，3分鐘左右您將得到回復。