- 您現在的位置：買賣IC網 > PDF目錄383877 > T9000 (Lineage Power) ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) PDF資料下載
參數資料
| 型號： | T9000 |
| 廠商： | Lineage Power |
| 英文描述： | ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) |
| 中文描述： | ISDN網絡終端節點（新界西）設備（ISDN網網絡終端節點器件） |
| 文件頁數： | 1/126頁 |
| 文件大小： | 1523K |
| 代理商： | T9000 |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Advance Data Sheet
April 2000
T9000
ISDN Network Termination Node (NTN) Device
1 Description
The T9000 is an ISDN network termination node
device that is highly integrated and provides a low-
cost solution to support the following:
I
All standard NT1 functions required to attach an
S/T interface device to an ISDN network. In addi-
tion, the T9000 also supports attachment of two
standard analog (POTS) telephones for communi-
cations over an ISDN network.
I
Intelligent network termination (INT/Smart NT1)
functions, with its built-in controller and support for
attachment of two analog phones for communica-
tions over an ISDN network.
I
A variation of the V5.1 signaling protocol called
narrowband multiservice delivery system (NMDS)
adopted by countries using the V5 signaling proto-
col (e.g., United Kingdom)
In addition, the T9000 can also be used for pair-gain
applications where support for more than one tele-
phone line is required without the installation of an
additional pair of wires from the telephone central
office to the customer premises.
2 Features
I
Complete interface to basic rate ISDN networks at
the S/T-interface and U-interface reference points.
I
U-interface (LT or NT operation) conforms to
ANSI* T1.601 and ETSI TS 080 standards.
I
S/T-interface conforms to ANSIT1.605 standard,
ITU-T I.430 recommendation, and ETSI ETS 300
012 standard for the network termination (NT) side
of the network.
I
Low power consumption.
I
D-channel HDLC formatter with address recogni-
tion and integrated contention resolution scheme.
I
64-byte D-channel FIFOs.
I
GCI+ interface supporting GCI and generic TDM
modes for interfacing to a wide variety of POTS cir-
cuits.
I
General-purpose I/O (GPIO) ports with interrupt
capability for interfacing to SLICs, codecs, DTMF
decoders, and other peripheral devices.
I
Three low-power, general-purpose comparators.
I
Two 100 kHz programmable PWM outputs with an
automatic sine wave generation mode to support
ringing, pulse metering, etc.
I
20 kHz—200 kHz programmable dc/dc converter
synchronization output.
I
JTAG boundary scan on all digital pins.
I
Power-saving mode.
— In this mode, the unused interfaces of the
T9000, such as, microcontroller, PWMs, and
comparator can remain in powerdown mode,
thus resulting in significant reduction in power
consumption (see Section 20.2, Power Con-
sumption).
I
Packaged in a 100-pin TQFP (thin quad flat pkg).
I
5 V power supply.
I
Operating temperature range: –40 °C to +85 °C.
I
Integrated 80C32 microcontroller with the following
features:
— Programmable clock rates (MHz): 15.36, 7.68,
3.84, 1.92, 0.96.
— 4K internal SRAM.
— 64K internal ROM.
— Supports external ROM/RAM.
— Can be disabled via pin strap (sleep mode) for
use with an external emulator.
— Programmable watchdog timer.
External ROM and RAM (64K x 8 maximum each)
are accessed through an external data/address bus.
Support for ROM and RAM space above the 64K
limit can be accomplished by memory paging using
one or more GPIO signals as an external chip select.
Power management routines may be implemented
through the microcontroller to power down most of
the internal submodules, including the microcontrol-
ler itself. An autosleep mode is also included, allow-
ing the microcontroller to stop its internal clock and
be automatically restarted (microcontroller wake-up)
whenever any interrupt is triggered.
* ANSI is a registered trademark of American National Standards
Institute, Inc.
相關PDF資料 |
PDF描述 |
|---|---|
| T90RIA10 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA40 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA60 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA80 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA100 | MEDIUM POWER PHASE CONTROL THYRISTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T9001 | 功能描述:罩類、盒類及殼類產品 15x14x3-1/2(3.13cf) 1 Compartment RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9006 | 功能描述:罩類、盒類及殼類產品 15 x 14 x 3-1/2 (2.96cf) RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9007 | 功能描述:罩類、盒類及殼類產品 13 1/8 x 13 1/8 x 3" 6 COMPARTMENTS RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9008 | 制造商:Nortools International Ltd 功能描述:HSS METRIC DIE SET,M3-M12 |
| T900BK | 功能描述:罩類、盒類及殼類產品 of Box Dividers Clear RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
發布緊急采購，3分鐘左右您將得到回復。