- 您現在的位置：買賣IC網 > PDF目錄98217 > THS1009IDA (TEXAS INSTRUMENTS INC) 2-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 PDF資料下載
參數資料
| 型號： | THS1009IDA |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | ADC |
| 英文描述： | 2-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| 封裝： | GREEN, PLASTIC, TSSOP-32 |
| 文件頁數： | 20/30頁 |
| 文件大小： | 294K |
| 代理商： | THS1009IDA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
THS1009
SLAS287A – AUGUST 2000 – REVISED DECEMBER 2002
www.ti.com
27
SINGLE-ENDED MODE OF OPERATION
The THS1009 can be configured for single-ended operation using dc or ac coupling. In either case, the input of the
THS1009 should be driven from an operational amplifier that does not degrade the ADC performance. Because the
THS1009 operates from a 5-V single supply, it is necessary to level-shift ground-based bipolar signals to comply with
its input requirements. This can be achieved with dc- and ac-coupling.
DC COUPLING
An operational amplifier can be configured to shift the signal level according to the analog input voltage range of the
THS1009. The analog input voltage range of the THS1009 goes from 1.5 V to 3.5 V. An operational amplifier can
be used as shown in Figure 35.
Figure 35 shows an example with the analog input signal in the range between –1 V and 1 V. The signal is shifted
by an operational amplifier to the analog input range of the THS1009 (1.5 V to 3.5 V). The operational amplifier is
configured as an inverting amplifier with a gain of –1. The required dc voltage of 1.25 V at the noninverting input is
derived from the 2.5-V output reference REFOUT of the THS1009 by using a resistor divider. Therefore, the
operational amplifier output voltage is centered at 2.5 V. The 10
F tantalum capacitor is required for bypassing
REFOUT. REFIN of the THS1009 must be connected directly to REFOUT in single-ended mode. The use of ratio
matched, thin-film resistor networks minimizes gain and offset errors.
_
+
5 V
R1
RS
3.5 V
2.5 V
1.5 V
THS1009
AINP
REFOUT
R2
1.25 V
1 V
0 V
–1 V
REFIN
+
C
10
F
Figure 35. Level-Shift for DC-Coupled Input
DIFFERENTIAL MODE OF OPERATION
For the differential mode of operation, a conversion from single-ended to differential is required. A conversion to
differential signals can be achieved by using an RF-transformer, which provides a center tap. Best performance is
achieved in differential mode.
THS1009
AINP
AINM
REFOUT
C
R
200
49.9
Mini Circuits
T4–1
+
10
F
Figure 36. Transformer Coupled Input
相關PDF資料 |
PDF描述 |
|---|---|
| THS1009IDAR | 2-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1009IDAG4 | 2-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1030CDW | 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| THS1030IDWR | 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| THS1030CPW | 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS1009IDAG4 | 功能描述:模數轉換器 - ADC 10-Bit 8 MSPS Dual Ch RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS1009IDAR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT, 2 ANALOG INPUT, 8 MSPS, SIMULTANEOUS SAMPLING ANALOG-TO-DIGITAL CONVERTER |
| THS1009IDARG4 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT, 2 ANALOG INPUT, 8 MSPS, SIMULTANEOUS SAMPLING ANALOG-TO-DIGITAL CONVERTER |
| THS10100RJ | 功能描述:線繞電阻器 - 底架安裝 100 Ohms 10W 50PPM RoHS:否 制造商:Vishay/Dale 電阻:7 Ohms 容差:1 % 功率額定值:100 W 溫度系數:50 PPM / C 系列:RH 工作溫度范圍:- 55 C to + 250 C 尺寸:46.02 mm Dia. x 46.02 mm W x 88.9 mm L x 44.45 mm H 封裝:Bulk 產品:Power Resistors Wirewound Aluminum Housed |
| THS10100RJ | 制造商:TE Connectivity 功能描述:RESISTOR WIREWOUND 100OHM 10W 5% |
發布緊急采購，3分鐘左右您將得到回復。