- 您現在的位置：買賣IC網 > PDF目錄98218 > THS1206MDA (TEXAS INSTRUMENTS INC) 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 PDF資料下載
參數資料
| 型號： | THS1206MDA |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | ADC |
| 英文描述： | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| 封裝： | PLASTIC, TSSOP-32 |
| 文件頁數： | 8/44頁 |
| 文件大?。?/td> | 548K |
| 代理商： | THS1206MDA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
THS1206
SLAS217H – MAY 1999 – REVISED JULY 2003#
www.ti.com
16
DETAILED DESCRIPTION
Reference Voltage
The THS1206 has a built-in reference, which provides the reference voltages for the ADC. VREFP is set to 3.5 V and
VREFM is set to 1.5 V. An external reference can also be used through two reference input pins, REFP and REFM, if the
reference source is programmed as external. The voltage levels applied to these pins establish the upper and lower limits
of the analog inputs to produce a full-scale and zero-scale reading respectively.
Analog Inputs
The THS1206 consists of 4 analog inputs, which are sampled simultaneously. These inputs can be selected individually
and configured as single-ended or differential inputs. The desired analog input channel can be programmed.
Converter
The THS1206 uses a 12-bit pipelined multistaged architecture with 4 1-bit stages followed by 4 2-bit stages, which achieves
a high sample rate with low power consumption. The THS1206 distributes the conversion over several smaller ADC
sub-blocks, refining the conversion with progressively higher accuracy as the device passes the results from stage to stage.
This distributed conversion requires a small fraction of the number of comparators used in a traditional flash ADC. A
sample-and-hold amplifier (SHA) within each of the stages permits the first stage to operate on a new input sample while
the second through the eighth stages operate on the seven preceding samples.
Conversion Modes
The conversion can be performed in two different conversion modes. In the single conversion mode, the conversion is
initiated by an external signal (CONVST). An internal oscillator controls the conversion time. In the continuous conversion
mode, an external clock signal is applied to the clock input (CONV_CLK). A new conversion is started with every falling
edge of the applied clock signal.
DATA_AV
In continuous conversion mode, the first DATA_AV signal is delayed by (7+TL) cycles of CONV_CLK after a FIFO reset
command. This is due to the latency of the pipe line architecture of the THS1206.
Sampling Rate
The maximum possible conversion rate per channel is dependent on the selected analog input channels. Table 1 shows
the maximum conversion rate in the continuous conversion mode for different combinations.
Table 1. Maximum Conversion Rate in Continuous Conversion Mode
CHANNEL CONFIGURATION
NUMBER OF
CHANNELS
MAXIMUM CONVERSION
RATE PER CHANNEL
1 single-ended channel
1
6 MSPS
2 single-ended channels
2
3 MSPS
3 single-ended channels
3
2 MSPS
4 single-ended channels
4
1.5 MSPS
1 differential channel
1
6 MSPS
2 differential channels
2
3 MSPS
1 single-ended and 1 differential channel
2
3 MSPS
2 single-ended and 1 differential channels
3
2 MSPS
The maximum conversion rate in the continuous conversion mode per channel, fc, is given by:
fc
+ 6MSPS
# channels
相關PDF資料 |
PDF描述 |
|---|---|
| THS1207CDA | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1207IDA | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1207CDAR | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1207IDAR | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
| THS1207IDAG4 | 4-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS1206MDAREP | 功能描述:模數轉換器 - ADC EP 12B,6Msps ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS1206M-EVM | 功能描述:數據轉換 IC 開發工具 THS1206M Eval Module RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| THS1206QDA | 功能描述:模數轉換器 - ADC 12-Bit 6 MSPS Quad Channel RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS1206QDAR | 功能描述:模數轉換器 - ADC 12 Bit 6 MSPS Quad Channel RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS1207 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:12 bit 4 ANALOG INPUT 6 MSPS SIMULTANEOUS SAMPLING |
發布緊急采購，3分鐘左右您將得到回復。