- 您現在的位置：買賣IC網 > PDF目錄98224 > THS4211DRB (TEXAS INSTRUMENTS INC) 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 PDF資料下載
參數資料
| 型號： | THS4211DRB |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| 封裝： | PLASTIC, MSOP-8 |
| 文件頁數： | 16/40頁 |
| 文件大小： | 1013K |
| 代理商： | THS4211DRB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
THS4211
THS4215
SLOS400C SEPTEMBER 2002 REVISED JANUARY 2004
www.ti.com
23
Intercept points are specifications long used as key design
criteria in the RF communications world as a metric for the
intermodulation distortion performance of a device in the
signal chain (e.g., amplifiers, mixers, etc.). Use of the
intercept point, rather than strictly the intermodulation
distortion,
allows
simpler
system-level calculations.
Intercept points, like noise figures, can be easily cascaded
back and forth through a signal chain to determine the
overall
receiver
chain’s
intermodulation
distortion
performance. The relationship between intermodulation
distortion and intercept point is depicted in Figure 85 and
Figure 86.
Figure 85
IMD3 = PS PO
PS
PO
fc = fc f1
fc = f2 fc
PS
fc 3ff1 fc f2
fc + 3f
Power
f Frequency MHz
Figure 86
IMD3
OIP3
IIP3
3X
PIN
(dBm)
1X
POUT
(dBm)
PO
PS
Due to the intercept point’s ease of use in system level
calculations for receiver chains, it has become the
specification of choice for guiding distortion-related design
decisions. Traditionally, these systems use primarily
class-A, single-ended RF amplifiers as gain blocks. These
RF amplifiers are typically designed to operate in a 50-
environment. Giving intercept points in dBm implies an
associated impedance (50
).
However, with an operational amplifier, the output does not
require termination as an RF amplifier would. Because
closed-loop amplifiers deliver signals to their outputs
regardless of the impedance present, it is important to
comprehend this when evaluating the intercept point of an
operational amplifier. The THS4211 yields optimum
distortion performance when loaded with 150
to 1 k,
very similar to the input impedance of an analog-to-digital
converter over its input frequency band.
As a result, terminating the input of the ADC to 50
can
actually be detrimental to systems performance.
The discontinuity between open-loop, class-A amplifiers
and closed-loop, class-AB amplifiers becomes apparent
when comparing the intercept points of the two types of
devices. Equations 1 and 2 gives the definition of an
intercept point, relative to the intermodulation distortion.
OIP
3 + PO )
IMD
3
2
where
P
O + 10 log
V2
P
2R
L
0.001
NOTE: PO is the output power of a single tone, RL is the load
resistance, and VP is the peak voltage for a single tone.
NOISE ANALYSIS
High slew rate, unity gain stable, voltage-feedback
operational amplifiers usually achieve their slew rate at the
expense of a higher input noise voltage. The 7 nV/
√Hz
input voltage noise for the THS4211 and THS4215 is,
however, much lower than comparable amplifiers. The
input-referred voltage noise, and the two input-referred
current noise terms (4 pA/
√Hz), combine to give low output
noise under a wide variety of operating conditions.
Figure 87 shows the amplifier noise analysis model with all
the noise terms included. In this model, all noise terms are
taken to be noise voltage or current density terms in either
nV/
√Hz or pA/√Hz.
(2)
(3)
相關PDF資料 |
PDF描述 |
|---|---|
| THS4215DRB | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4215DG4 | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4215DGNR | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4215DGN | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4215DRBR | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS4211DRBR | 功能描述:高速運算放大器 Super-Fast Ultr-Lo- Distortion Hi-Speed RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4211DRBRG4 | 功能描述:高速運算放大器 Super-Fast Ultr-Lo- Distortion Hi-Speed RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4211DRBT | 功能描述:高速運算放大器 Super-Fast Ultr-Lo- Distortion Hi-Speed RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4211DRBTG4 | 功能描述:高速運算放大器 Super-Fast Ultr-Lo- Distortion Hi-Speed RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4211DRG4 | 功能描述:高速運算放大器 Super-Fast Ultr-Lo- Distortion Hi-Speed RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。