欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TLC5615IDG4
廠商: TEXAS INSTRUMENTS INC
元件分類: DAC
英文描述: SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDSO8
封裝: GREEN, PLASTIC, MS-012AA, SOIC-8
文件頁數: 3/22頁
文件大小: 552K
代理商: TLC5615IDG4
www.ti.com
DAC Code
Output
Voltage
0 V
Negative
Offset
POWER-SUPPLY BYPASSING AND GROUND MANAGEMENT
0.1
F
Analog Ground Plane
1
2
3
4
8
7
6
5
SAVING POWER
SLAS142E – OCTOBER 1996 – REVISED JUNE 2007
The output amplifier attempts to drive the output to a negative voltage. However, because the most negative
supply rail is ground, the output cannot drive below ground and clamps the output at 0V.
The output voltage then remains at zero until the input code value produces a sufficient positive output voltage
to overcome the negative offset voltage, resulting in the transfer function shown in Figure 14.
Figure 14. Effect of Negative Offset (Single Supply)
This offset error, not the linearity error, produces this breakpoint. The transfer function would have followed the
dotted line if the output buffer could drive below the ground rail.
For a DAC, linearity is measured between zero-input code (all inputs '0') and full-scale code (all inputs '1') after
offset and full scale are adjusted out or accounted for in some way. However, single supply operation does not
allow for adjustment when the offset is negative due to the breakpoint in the transfer function. So the linearity is
measured between full-scale code and the lowest code that produces a positive output voltage. For the
TLC5615, the zero-scale (offset) error is
±3LSB maximum. The code is calculated from the maximum
specification for the negative offset.
Printed circuit boards that use separate analog and digital ground planes offer the best system performance.
Wire-wrap boards do not perform well and should not be used. The two ground planes should be connected
together at the low-impedance power-supply source. The best ground connection may be achieved by
connecting the DAC AGND terminal to the system analog ground plane making sure that analog ground currents
are well managed and there are negligible voltage drops across the ground plane.
A 0.1
F ceramic-capacitor bypass should be connected between V
DD and AGND and mounted with short leads
as close as possible to the device. Use of ferrite beads may further isolate the system analog supply from the
digital power supply.
Figure 15 shows the ground plane layout and bypassing technique.
Figure 15. Power-Supply Bypassing
Setting the DAC register to all 0s minimizes power consumption by the reference resistor array and the output
load when the system is not using the DAC.
11
相關PDF資料
PDF描述
TLC5615CDGKG4 SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDSO8
TLC5615IP SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDIP8
TLC5615CDR SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDSO8
TLC5615CDG4 SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDSO8
TLC5615IPE4 SERIAL INPUT LOADING, 12.5 us SETTLING TIME, 10-BIT DAC, PDIP8
相關代理商/技術參數
參數描述
TLC5615IDGK 功能描述:數模轉換器- DAC 10-Bit 12.5 us DAC Serial Input Lo-Pwr RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
TLC5615IDGKG4 功能描述:數模轉換器- DAC 10-Bit 12.5 us DAC Serial Input Lo-Pwr RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
TLC5615IDGKR 功能描述:數模轉換器- DAC 10-Bit 12.5 us DAC Serial Input Lo-Pwr RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
TLC5615IDGKRG4 功能描述:數模轉換器- DAC 10-Bit 12.5 us DAC Serial Input Lo-Pwr RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
TLC5615IDR 功能描述:數模轉換器- DAC 10-Bit 12.5 us DAC Serial Input Lo-Pwr RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
主站蜘蛛池模板: 礼泉县| 民乐县| 田林县| 乐业县| 杭锦后旗| 全椒县| 凤凰县| 望奎县| 普兰店市| 收藏| 鹤庆县| 金堂县| 南宫市| 邓州市| 通化市| 咸宁市| 民丰县| 大连市| 洪湖市| 盐池县| 密山市| 柳州市| 申扎县| 平武县| 临高县| 高雄县| 永清县| 曲沃县| 灌南县| 开鲁县| 萝北县| 鹿泉市| 隆林| 剑河县| 岳阳市| 徐州市| 营山县| 南陵县| 宝鸡市| 扬州市| 谷城县|