- 您現在的位置：買賣IC網 > PDF目錄98249 > TLV1562CDWR (TEXAS INSTRUMENTS INC) 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 PDF資料下載
參數資料
| 型號： | TLV1562CDWR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | ADC |
| 英文描述： | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| 封裝： | 1.27 MM PITCH, SOIC-28 |
| 文件頁數： | 11/41頁 |
| 文件大小： | 600K |
| 代理商： | TLV1562CDWR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
TLV1562
2.7 V TO 5.5 V, HIGH-SPEED LOW-POWER RECONFIGURABLE ANALOG-TO-DIGITAL
CONVERTER WITH 4-INPUT, DUAL S/H, PARALLEL INTERFACE, AND POWER DOWN
SLAS162 – SEPTEMBER 1998
19
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
external clock input (CR0.5 = 1, SYSCLK = External Clk)
The TLV1562 is designed to operate with an external clock input (CMOS/TTL) with a frequency from 100 kHz
to 14 MHz. When an external clock is used as the source of SYSCLK, the setup time from the falling edge of
RD to the rising edge of SYSCLK, ts(TRGL-ECLKH) is 5 ns minimum. The internal OSC is shut down when the
external clock mode is selected.
host processor interface
parallel processor interface
The TLV1562 provides a generic high-speed parallel interface that is compatible with high-performance DSPs
and general-purpose microprocessors. These include D(0,9), RD, WR, and INT. RD transitions from high to low
to signal the end of acquisition. The parallel I/O has its own power supply to minimize digital noise.
output data format
The output data format is unipolar binary (1023 to 0) when the device is operated in the single-ended input mode
and is bipolar (511 to –512) when the device is operated in differential input mode. The output code format can
be either binary or 2s compliment. The output data format is controlled by CR1.2.
power down
The device offers two different power-down modes: Auto power-down mode for interrupt-driven conversions
and software power-down mode for all conversion modes. All configuration information is kept intact when the
device is in software or auto power-down mode.
auto-power down for interrupt-driven conversion modes
When auto-power down is enabled, the device turns off the analog section (the converter except for the
reference network) at the falling edge of INT and resumes after the falling edge of CS (if RD is the conversion
trigger) or CSTART (if CSTART is the conversion trigger). The reference current and I/O are kept alive to ensure
a fast recovery. Average power consumption can be reduced by accessing the converter less often. Special
requirements for using this feature are:
D It is necessary to toggle CS between cycles so the converter knows when to resume.
D There is an additional delay to a conversion after the device is accessed due to the auto-power-down
control. Therefore, the time between RD (or CSTART) triggers is longer (longer RD or CSTART high time).
software power down (CR.10 = 1, software power down enabled)
In addition to the auto-power-down feature, the device has a software powerdown feature to further reduce
power consumption when the device is idle. Writing a 1 to control register bit CR1.0 puts the TLV1562 into
software power-down mode in 200 ns after CS is up. The device consumes less than 1
A when in the
power-down mode. Writing a 0 to control register bit CR1.0 wakes up the device. Conversion can start 1
s after
the device is resumed. CS must be high when the device is in power-down mode. Software power-down
operation is slower than auto-power down but is more flexible and consumes almost no power.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV1562CDW | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| TLV1562IDWR | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| TLV1562CPWR | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| TLV1562CPW | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
| TLV1562IPWR | 4-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV1562CPW | 功能描述:模數轉換器 - ADC 10bit Programmable RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV1562CPWG4 | 功能描述:模數轉換器 - ADC 10-Bit 2 MSPS Quad Channel RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV1562EVM | 制造商:Rochester Electronics LLC 功能描述:10- BIT A-D CONVERTER EVALUATION MODULE - Bulk 制造商:Texas Instruments 功能描述:10- BIT A-D CONVERTER EVALUATION MODULE - Bulk |
| TLV1562IDW | 功能描述:模數轉換器 - ADC 10bit Programmable RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV1562IDWG4 | 功能描述:模數轉換器 - ADC 10-Bit 2 MSPS Quad Channel RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。